What have you done to your K2 today?

Viktorrocks15 · May 24, 2018

Finish installing the dashboard and doors panel trim pieces with painted gloss black trim. Turned out a lot better than what I thought since I had them as extras I still have the gray ones just in case..

Sent from my iPhone using Tapatalk

TX LIMO · May 24, 2018

Finish installing the dashboard and doors panel trim pieces with painted gloss black trim. Turned out a lot better than what I thought since I had them as extras I still have the gray ones just in case..

Sent from my iPhone using Tapatalk

That looks really good. I did mine in Realtree vinyl.

Delivered via my cellular device using a mobile chat forum thingy.

Viktorrocks15 · May 24, 2018

That looks really good. I did mine in Realtree vinyl.

Delivered via my cellular device using a mobile chat forum thingy.

Thank you.! The black gloss really offsets the matte leather finish and it it gives tons of depth to the painted trim pieces.

Sent from my iPhone using Tapatalk

Chev-mekanik · May 24, 2018

48 minutes ago, Viktorrocks15 said:

Finish installing the dashboard and doors panel trim pieces with painted gloss black trim. Turned out a lot better than what I thought since I had them as extras I still have the gray ones just in case..

Sent from my iPhone using Tapatalk

Nicely done! Doesn’t seem as tacky as some of the weird colour matching that goes on.

Viktorrocks15 · May 24, 2018

Nicely done! Doesn’t seem as tacky as some of the weird colour matching that goes on.

Used the same paint and clear as the exterior of my truck.[emoji1303]

Sent from my iPhone using Tapatalk

99silveradoz71 · May 24, 2018

Washed, clayed, polished, and waxed her up.

b-garage · May 24, 2018

Swapped out the chrome bumper for the high country painted with fogs bumper.

Before:

After:

Edited May 24, 2018 by b-garage

COshooter · May 24, 2018

15 hours ago, Ravenkeeper said:

Is it the shadow(s), or is the shell just a touch too long? Looking at getting one for mine.

Just a shadow. The cap fits really well all around. The installers did a great job of getting it centered on the bed. I'd say there's less than 1/4 inch overhang all around - just enough for a drip edge.

15BlueSilverado · May 24, 2018

Dropped my truck off at the dealer to get the AC fixed, still under warranty!! They put me in a 2018 Silverado as a loaner, probably to try and persuade me into trading mine in since it only has 35k miles. It's nice but the only difference is the front end, interior is the same as mine, can't believe nothing has changed in 3 years.

Aboogie808 · May 24, 2018

I installed a B&M transmission pan to go along with the rear diff cover i installed a few weeks back. I am so glad i did it. The oil was gross, it was last flushed ~30k ago. Today i did the pan and filter and filled it back up with Amsoil ATF. I also did the transfer case too. The front and rear ends are both also filled with Amsoil.

The pan was kind of a pain to install since i had to drop the Y pipe to get some clearance but beyond that is was easy.

One thing i will note on the transmission is it shifts way better than before, not sure if its a placebo effect or not but it has never felt as good as it does today since it was new. The rear end seems a lot less clunky too with the heavier oil in there, the factory oil was like water.

The pan,

A sample of the oil i drained from the transmission

The rear diff cover i put on a few weeks ago