Jump to content

Recommended Posts

Posted
27 minutes ago, SuthrnZ71 said:

Thanks man, I love it!!  I couldn't stop looking at it last night before I went to bed!  This is my first crew cab, always had extended cab or quad cab trucks, so the additional space in the back is nice!

I agree with the crew cab comment, it is nice to have the extra interior space. You just learn how to utilize the shorter bed.

Posted
On 1/30/2019 at 10:37 AM, JamesAT18 said:

Adding some pictures over the past couple of months. Love this truck. 

IMG_20181206_072031.jpg

00000IMG_00000_BURST20181224172824161_COVER.jpg

 

Great lake photo!  Is that Lanier?

Posted
4 hours ago, FlipZ71 said:

Been a while...

 

20180507_132406.jpg

look's good - mine has 79000 still running great. what does you have.

Posted
55 minutes ago, slj2008 said:

look's good - mine has 79000 still running great. what does you have.

71,000 , running strong 

Posted
11 hours ago, 17Allterrainx said:

Before: 2.5” level and after Mcgaughys 7”-9 lift. Need 35’s

FA742255-7ECA-45BA-8500-0B4B0A20E6E2.jpeg

8CF18005-BD52-47E1-A1ED-43DC074743B8.jpeg

 

That looks awesome!  How you like your Hostile Sprockets?  I was about to order a set of either them or XD Grenade 20x10s to swap these Fuel Assaults out with. 

Posted
4 minutes ago, SuthrnZ71 said:

 

That looks awesome!  How you like your Hostile Sprockets?  I was about to order a set of either them or XD Grenade 20x10s to swap these Fuel Assaults out with. 

Thanks! And can’t complain, have not had any issues with them. These are 20x10 -19. Have had them a little less than 10k miles. Just posted them on craigslist see if anyone bites. Thinking of going 22x12 . 

Posted (edited)
2 minutes ago, 17Allterrainx said:

Thanks! And can’t complain, have not had any issues with them. These are 20x10 -19. Have had them a little less than 10k miles. Just posted them on craigslist see if anyone bites. Thinking of going 22x12 . 

Do you feel like the lip isn't deep enough?  That's some things I've heard.  The XD Grenades I'm looking at are 20x10 -24 so not sure how much deeper those really would be.  That looks like ya got a perfect setup tho with the toyo mts!

Edited by SuthrnZ71
Posted
1 minute ago, SuthrnZ71 said:

Do you feel like the lip isn't deep enough?  That's some things I've heard.  The XD Grenades I'm looking at are 20x10 -24 so not sure how much deeper those really would be.  That looks like ya got a perfect setup tho with the toyo mts!

I think you would need to go with a wider wheel for a deeper lip. The lip on this wheel is fine for me. Its just that after the lift I wanted a wider wheel with a different offset. 

DACE86E9-4B8D-482D-957D-C9D074A4436A.jpeg

  • Like 1
Posted
Before: 2.5” level and after Mcgaughys 7”-9 lift. Need 35’sFA742255-7ECA-45BA-8500-0B4B0A20E6E2.thumb.jpeg.5e4f9cf8391b88af0ee4f87480a4fa2b.jpeg

8CF18005-BD52-47E1-A1ED-43DC074743B8.thumb.jpeg.18c9a3716f9e511117ee508c3341ca23.jpeg

 

Have any pics head on? I'd like to see if they stick out and how much.  

Where are you located? I'm looking for a new set of wheels.

 

Sent from my Pixel 2 XL using Tapatalk

 

 

 

 

 

Posted
11 minutes ago, Izzyjr56 said:

Negative!!!!! Truck was purchased as you see it. 

Understood. That makes more sense. You just haven't had time to de-accessorize it yet.........

 

Shakey

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • So, do I go elbow-deep on this thing or list it for sale and play dumb? Seems to "runs good."   I'm about $1200 away from having: -a rebuilt injector ($300) -a new cat ($250) -a new cat back exhaust (OE style) ($300) -a new AC compressor ($200) -AC refrigerant charge ($150)   In theory, this should rectify the obvious detracting issues from its value and operability. Cold AC with a non-squeaking AC pulley both sounds and feels good. An exhaust that isn't cut/hacked in 17 different places and doesn't vibrate on a crossmember would make it sound and feel less janky. A working cat would help the stink, and will save the earth, but *if and only if* the fuel system is working properly, which would also address the intermittent "rich" CEL.   Heard a good one... CEL for "Rich condition" means you haven't spent enough money on the truck lately, and it's letting you know.   Rebuilding the injector would seem to be the most important part. Replacing the cat would be secondary. I don't think mine is plugged or overly restricted, but it might be a little restricted? I have no good way to tell other than seat of the pants feel. I hate the smell.   The current theory is I have a rich idle problem: A bad fuel pressure regulator, or a leaking injector(s) being the highest probabilities. I already replaced the FPR but that doesn't mean its replacement isn't also bad. It was a new part from Dorman, but the packaging looked like it had been sitting on a shelf for 20 years.   This is the (single) upstream O2 sensor shown at idle. I'm getting a lot of "rich" it seems. Sometimes it stays high like that and doesn't drop down. That makes me think it's processing injector leaks or a partially stuck open injector.     Other times it looks like this. Nice oscillations between rich and lean, which is what I think it should be. Under load and at speed, the oscillations are nice and tight and uniform looking, high and low.     Fuel trims suggest the PCM is compensating pretty hard at idle to pull fuel out. But it's not enough to trip a CEL. Something about slowing to a stop: brake vaccum booster, EGR, or the EVAP purge is delayed, or there's pooled fuel in the intake again that's draining into a cylinder is enough to set the CEL. Of course, in two days of driving, it hasn't set. I was hoping to actually look at the freeze-frame data when it sets. IAT is high because it's idling on an 83 degree day here.  
    • Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...