Interior lighting circuit?

[Rosco18]

First time post and new member but long time reader,

 

This is my problem, I have purchased self adhesive LED strip lighting that I intend to install under the bed rails to light up the bed (I have a tonneau Cover), its dark in there. So I have done my research and I am not incapable at all but I cant find the interior lighting circuit. You see I would like to operate the lights off this circuit for ease of operation, walk up to the truck and hit the key fob and the lights turn on for enough time to get things in and out of the bed then go off by themselves. In my research I have discovered that the wire I am looking for is on Junction Box (61) Instrument Panel - Connector X2 (pin #29). After all that here is my question, were on my truck do I find the Junction Box (61)?

 

I have attached what I have found online so far.

 

Thank you in advance for any and all help!

2014 Electrical section.pdf

2014 Electrical section.pdf

2014 Electrical section.pdf

2014 Electrical section.pdf

[ravageur1972]

Why you don't plug it same way as cargo box light should be plug??

Behind the left rear bumper you will find the rear junction block.....cargo light plug there....you can also buy the oem kit ...it will come with 2 light..harness and everything you will need to make it functional. ...it will also probably last longer abs will make more lumens too

[Rosco18]

Why you don't plug it same way as cargo box light should be plug??

Behind the left rear bumper you will find the rear junction block.....cargo light plug there....you can also buy the oem kit ...it will come with 2 light..harness and everything you will need to make it functional. ...it will also probably last longer abs will make more lumens too

[Rosco18]

I already have the LED's and the rear cargo dose not operate with the interior lights, I.e. Key fob will not turn light on, but thanks for the other thoughts.

[ravageur1972]

Oh okay. ..I didn't understand it that way ..my bad

[ravageur1972]

by the way the junction box is where clutch pedal should be........there is a cover you can remove........the box is bolt on firewall between brake pedal and emergency brake pedal

[Rosco18]

Yes you are correct thanks for the help, and for anyone else I found a post where this has been gone over already

 

http://www.gm-trucks.com/forums/topic/146836-gmt900-footwell-lighting/