Jump to content

Recommended Posts

Posted
got 305/55x20 BF Ko2 All terrains on my AT4 with the stock 20's.  no rub except for when there is caked on mud in the wells so it's close.  

Post up pics@potato please!


Sent from my iPhone using Tapatalk
Posted

275/70r18 BFG K02's on 1.75" spacers.  Slight rub on reverse at full turn, not enough to do anything about.  

IMG_8530.jpg

IMG_8528.jpg

  • Like 13
Posted
4 hours ago, potato said:

 

7SNAbP0FQKiKMz0vYfVAfA.jpg

It looks great man! I noticed you have the bigger factory mud guards. I will probably swap mine for those when the time comes to up size my tires. 

  • 2 weeks later...
Posted (edited)

I put my new wheels/tires on today. 20x10 -18 Fuel Vandals w/ 33x12.50 Nitto Ridge Grapplers. The wheels slightly brushed the front brake calipers, so I had to add 1/4” spacers. So now, it’s at about a -24 mm offset. There’s only a slight rub at full lock on the back of the wheel well. It’s a Trail Boss with the 2” stock lift. I’ve also added a 1.5” MotoFab under strut leveling kit. 

2E800728-BA24-409B-8D7D-46D01A835D63.jpeg

C141956B-A267-4443-B9B9-191C36FD9209.jpeg

Edited by CPBassGuide
  • Like 1
Posted

Do you think a 285/75/r18 duratrac which measures 35.1x11.2 would fit stock trail boss on factory rims or 295/70 is the biggest you can go, if not I’m getting 295/70 st maxx’s

Posted
3 hours ago, CPBassGuide said:

I put my new wheels/tires on today. 20x10 -18 Fuel Vandals w/ 33x12.50 Nitto Ridge Grapplers. The wheels slightly brushed the front brake calipers, so I had to add 1/4” spacers. So now, it’s at about a -24 mm offset. There’s only a slight rub at full lock on the back of the wheel well. It’s a Trail Boss with the 2” stock lift. I’ve also added a 1.5” MotoFab under strut leveling kit. 

2E800728-BA24-409B-8D7D-46D01A835D63.jpeg

C141956B-A267-4443-B9B9-191C36FD9209.jpeg

Man, this looks great!  I’m getting mine installed tomorrow morning.  But I can’t believe they wouldn’t fit over the caliper.  This is the first vandal wheel that I have heard doesn’t fit.  There is a guy on FB with an AT4 with same 20x10 -18 wheels and they fit fine.  Very interesting! But sweet truck man, awesome job.

Posted
On ‎3‎/‎24‎/‎2019 at 5:15 AM, CPBassGuide said:

 

Yes. As far as the looks of the tires, they’re fairly similar to the GY Wranglers that came stock. The bigger size fills out the wheel wells a lot better. I’ll get some more pics. 

 

Have you noticed any rubbing yet. Could you post more pics??

Thanks

Posted
On 3/16/2019 at 11:16 AM, CPBassGuide said:

I have a ‘19 Trail Boss and added a set of Cooper Discoverer AT3 XLT 295/70R18 on stock wheels. No rubbing at all. 

Have you noticed a change in fuel mileage with the larger/heavier tire?

Posted

I went with a 1” motofab lift, Ridge Grappler 305/55/R20, fuel Vandal 20x9 +1 offset.  We had to remove the bracket behind the mud flap as it was pushing the mud flap forward and making it rub against the tire at full lock.  After removal, we were able to push the mud flap back about a half inch and now have zero rub.

4EE8ECEE-82FA-471C-9626-1471F608E774.jpeg

  • Like 1
Posted
16 hours ago, Trailboss75 said:

Here is picture of the bracket behind mud flap.

47984C9D-8E7B-468C-8708-01043ED42999.jpeg

Just did the same thing!  Thanks for the idea, no more rubbing!!

  • Thanks 1
Posted
4 hours ago, z1boss said:

Just did the same thing!  Thanks for the idea, no more rubbing!!

That’s awesome man!  Glad it worked for you.  That bracket seems to serve no purpose but to push the mud flap forward.  Super happy the shop took a long look to see what they could  do to get everything to fit without rubbing.  Definitely an easy fix.

  • Like 1
  • Thanks 1
Posted

I would think the bracket supports the mud flap like when driving through water /mud/snow.

Posted
8 hours ago, Ultra54 said:

I would think the bracket supports the mud flap like when driving through water /mud/snow.

The mud flap is extremely durable and doesn’t really move at all.  It’s possible you could have some issues if you do heavy off roading, but if you are on pavement majority of time, I don’t see any issues with it.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.4k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,760
    Total Members
    8,960
    Most Online
    MASONV88888888
    Newest Member
    MASONV88888888
    Joined
  • Who's Online   3 Members, 0 Anonymous, 1,512 Guests (See full list)


  • Latest Articles

  • Posts

    • My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • I have 2 choices. 
    • Do you have access to BP fuels? Some stations have Silver 91 E-0 priced the same as their 93 E-10.  There is a local Marathon with 90 alky free for $6 a gallon but I go down the road to BP for $5-ish. They also have a 100 E-0 but that stuff is $10 a pop. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...