Jump to content

Power window problems

Joemaggs
 Share

Recommended Posts

Joemaggs New Member

Joemaggs

Posted
Posted

I have a 2014 Chevy Silverado. My driver side window works fine. My passenger side window only works for the passenger side switch. My rear windows do not work at all. I replaced the switch and have the same problem. Any ideas I’m at a loss?

Ravenkeeper Senior Enthusiast

Ravenkeeper

Posted
Posted
2 hours ago, Joemaggs said:

I have a 2014 Chevy Silverado. My driver side window works fine. My passenger side window only works for the passenger side switch. My rear windows do not work at all. I replaced the switch and have the same problem. Any ideas I’m at a loss?

Double check the "Child Safety Switch" for the windows to make sure that it's not set.

 

Check fuses, and ohm wires from switches to window motor. 

 

 

durandetto Enthusiast

durandetto

Posted
Posted

Check the wires in the door jamb for breaks. Try grabbing the rubber boots and moving it around while operating the switches to see if they start working.

 

 

1. Test the driver's window switch power and ground feeds. 

 

2. Check for wire breaks in the door jamb boot. 

 

3. If there is low/no voltage on the Yellow wire in terminal 43 at the switch, cut the Yellow wire in terminal 22 in the X2 connector at the Body Control Module (BCM). 

 

4. Confirm there are 12 volts on the Yellow wire on the BCM side of the cut. 

 

5. If there are 12 volts, check for an open in the Yellow wire between the BCM and the driver power window switch.

 

Sent from my SM-G988U using Tapatalk

 

 

 

 

  • Like 1
durandetto Enthusiast

durandetto

Posted
Posted

You're welcome. I see that all the time at work. Probably best to add enough wire so your splices aren't in the bend.

Sent from my SM-G988U using Tapatalk

  • Like 1
  • 2 years later...
LARRY GOLLBACH New Member

LARRY GOLLBACH

Posted
Posted

Thanks for posting this topic. I had the exact same symptoms. I thought it was the switch also. Them I found this site. Found the same broken wires in the door jam harness.  Very helpful.  Thank you very much.

  • Like 1
  • 7 months later...
GOMD Enthusiast

GOMD

Posted
Posted

I have the same symptoms, but my wire harness looks good, except the thick black wire is cut and exposed some. Ordering a new harness now, hoping to have positive results.

 

Tyler Gibbs Enthusiast

Tyler Gibbs

Posted
Posted
On 3/11/2020 at 7:30 PM, durandetto said:

Check the wires in the door jamb for breaks. Try grabbing the rubber boots and moving it around while operating the switches to see if they start working.

 

 

1. Test the driver's window switch power and ground feeds. 

 

2. Check for wire breaks in the door jamb boot. 

 

 

 

 

 

 

Yup, this.

Tyler Gibbs Enthusiast

Tyler Gibbs

Posted
Posted
On 3/14/2020 at 8:46 AM, NE18 said:

Is this a common problem on the K2’s?

I know this post is from 2020 but when my 2018 was in the shop in July for this, the GM dealer said it was becoming more increasingly common.  As well as the hood sensor/switch failing.

GOMD Enthusiast

GOMD

Posted
Posted

So it ends up that while I found a slice in the black ground wire in the main door harness, I actually only needed to replace fuse #8 in the drivers side fuse panel to get everything working again. Thanks.

  • 1 year later...
Derek D New Member

Derek D

Posted
Posted (edited)

I have a 2018 Silverado. The passenger window will not roll down from the passenger door switch or the drivers door switch. All of the other windows work from their respective switch and the drivers panel. I replaced the switch and the window motor assembly (both OEM) but the problem remains. Additionally, the door ajar light is on continuously. I checked the fuses and the wiring and I can’t find any issues. Any advice? 

Edited by Derek D
Adding info
MikeBMW Senior Enthusiast

MikeBMW

Posted
Posted

Have you run a scan with a scan tool?
Also, have you checked all grounds (yeah, I know, always the easy answer without solving the problem)
Still, a scan would probably find the fault, might be a legacy code that needs a reset.

  • Like 1
  • 3 months later...
Mdp243 New Member

Mdp243

Posted
Posted

 I have a early model 2014 Chevy Silverado and the drivers side windows have stopped working as well as the stereo stays on after the vehicle is shut off (opening door does not cancel the radio) I have replaced the window switch, door wiring harness, and the latch on the drivers door. I have also checked all fuses and they are good any ideas where to look next.

  • 5 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Me too……..

      By newdude · Posted

      The engine was done as part of the 6.2 recall?   You'd have to see if your VIN also has the 6.2 engine special coverage on it.  Coverage number is N252494003.  If you have this, your engine is covered under this and NOT the GM replacement part engine warranty which is 3yr/100k from the date of install.  The 3yr/100k mi warranty is in effect for non warranty purchases.     This is not any different if it was replaced under warranty without a recall or special coverage.  So if you had a 5.3 and it popped at 3 years in at 50,000mi during the 5yr/60k powertrain, the replacement engine would not get the 3yr/100k, and instead gets the remainder of the 5yr/60k as coverage.     So N252494003 gives 10 years or 150,000mi of coverage, which ever comes first, starting at the vehicle in service date.  So if your in service date is 01/01/2022, N252494003 gives you special coverage of the engine until 01/01/2032 or 150,000mi, whichever comes first.  So if your start date was 01/01/2022, you'd have left 5 years and 4 months (lets round to august 1st), or 62,000mi left of coverage.   So you need to know your in service date to know how much coverage is left.  
    • CamGTP
      Injector update

      By CamGTP · Posted

      Okiee dokie there bud, way to take things to the extreme.   I guess you missed the whole point and take things way to serious. I installed different EV6 style injectors that just so happen to be larger in my car running the same LQ4 engine and with a better spray pattern than the stock style injectors and I noticed no difference in the idle quality. Kinda was my round about way of saying that even if you put the same size but better style injectors in your truck, you will likely see the same thing.    I'm sure you're great to have conversations with in person if that's how you act through a keyboard. One little things sets you off and now I guess my dick is all up in your face.
    • richard wysong
      Injector update

      By richard wysong · Posted

      WoW
    • taze
      Me too……..

      By taze · Posted

      I can't believe that could possibly be the case. It should be 36mo/100k miles from installation. Then again, it also seems like since a dealership installed it, it'd all be in the system and you wouldn't need to worry about registering, either. Shows you what I know. 😄 Hope this one outlives the warranty!
    • asilverblazer
      The Peckish Synapse

      By asilverblazer · Posted

      I haven't seen inventory recovery from COVID.    In the few random times I 'build my own' truck or SUV, no one has the exact one I want.   GM has been working to lower incentives too for a long time.    A $500 incentive isn't getting me off the couch to go truck shopping.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...