Jump to content

Recommended Posts

Posted

Just an alternative opinion,...I'll vote AGAINST Bilstein almost any day. In general, I'm not a fan of their valving. In several applications, I've used them and always had some remorse. 

 

They're just too stiff on the small bumps and irregularities. I'd put a set of Monroe shocks on with a spacer before even thinking of touching a 5100. The 6112 series is rumored to have a lot more forgiving valving.  

  • Like 2
Posted

I used KYB Gas Adjust struts on my 15 Silverado Z71 4WD. Not as firm as Bilstein, somewhat firmer than original.  I agree, I would never buy Bilstein based on past experience with a 3500 van.  The ride was extremely hard. Apparently some of our readers love them, I don't!

  • Like 2
Posted

Are they bad or are you just wanting to change them out?  Shocks last a long time unless you have tons of rough roads and potholes.

  • Like 1
Posted

I'm just about to install some Rancho RS5000X shocks on my truck after noticing my OEM shocks were worn. I went with the ranchos because they weren't too expensive and I've heard the same thing as others here have mentioned about the Bilsteins being too stiff. I'll see how the 5000Xs ride and let you know. 

  • Like 2
Posted
I'm just about to install some Rancho RS5000X shocks on my truck after noticing my OEM shocks were worn. I went with the ranchos because they weren't too expensive and I've heard the same thing as others here have mentioned about the Bilsteins being too stiff. I'll see how the 5000Xs ride and let you know. 

Awesome!! Thanks.


Sent from my iPhone using Tapatalk
Posted

I have Bilstein 5100’s front and 5125 rear(custom length 5100 for lifted applications). I really like the Billy’s. Definitely an improvement over the stock Ranchos that bounce like a rodeo horse.

I was wanting the 6112’s but they weren’t out when I bought mine. I don’t have any input on those but I have heard good things.


Sent from my iPhone using Tapatalk

  • Like 1
Posted

I installed the KYB on my 2002, I didn't notice any difference.  This was at 115k on the original shocks, that when I took them off were still good.  The roads here in eastern NC are in good shape. Just an FYI

Posted

Mine came with the z71 Rancho shocks. At 30k I changed them when I put my lift on. It came with new rough country rear shocks and I like them alot better then the Ranchos. I will be buying the rough country fronts soon, if I don't trade in on a new truck lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • My take: I don't think seeing up to 200k on the odometer of any of these engines/trucks (2014-to present) is surprising. (Excluding the known DEFECTS, specifically, the 6.2 main/connecting rod bearing issues, the defective lifters, alternatively parts that a recall was issued for - I think there were three.)   250K is my line in the sand, anything over that is 'surprising', but not limited to the engine making it that far but including the truck surrounding it too. (We've talked about this in other posts, why I think the engine isn't the deciding factor for ultimate mileage.)
    • I included the first gen-cylinder de-activation (active fuel management) in my statement.
    • Hello All!   My 2019 Colorado 3.6 LT, 4WD Crew Cab has approximately 77,500 miles and I recently began experiencing the well-known transmission shudder between about 30 and 65 mph. The problem had worsened to the point that I could no longer attribute it to road conditions - and I had decided to bring the truck to the dealer - when recently, I experienced a sudden loss of power while driving at maybe 40 MPH. Several warning lights flashed, the “Check Stabilitrack” message appeared, and the Check Engine, Stabilitrack, and Traction Control icons remained illuminated. The truck regained driving power, but it stayed in a low gear with unusually high RPMs for the speed. (limp mode?) Because I was only about two miles from home, driving slowly, I was able to make it back and run an OBD-II scan, which showed fault codes U0101, P0700, and U0100. My next trip in the truck was to drive it to the dealer the following day. That trip began normally, but after about a mile I experienced another loss of power, along with the same warning lights and the same “Check Stabilitrack” message. As before the truck remained driveable, but again operated at an abnormally high RPM-to-speed ratio and seemed stuck in a single gear. About a mile later, the dashboard lit up once more, this time displaying “Check 4WD.” Soon after that, I arrived at the dealer. I have verified that the truck still has its original factory transmission fluid, which means it has never received the corrective fluid exchange outlined in GM Technical Service Bulletin #18-NA-355.  That was Thursday of last week and I've heard nothing yet from the dealer.    According to Technical Service Bulletin #18-NA-355 and the build date of my truck, my truck should have the newer LV fluid. I've done a little research and read something about a problem with the wiring harness as well.   Anyone have an insights into this situation?  Thank you!!
    • Having bumper and other body damages can be very frustrating, especially as a result of a parking lot collision/bump. Our team wants to learn more about the damages to your truck so we can look into ways we might be able to help. When you get the chance, please fill out our support form with more details: https://s.gmc.com/support-request . A member of our team will follow up with you as soon as next available. We want to get you enjoying your truck to the fullest again. 
    • Did you even read this article?   Even the title of the article says "U.S.-Iran Deal Doesn’t Mean a Swift Return of Oil and Gas Flows"   Remember, crude oil prices are based on FUTURE purchases by the oil companies.  Gas prices are based on FUTURE purchases by the station.  This article stated that many of the oil producing nations have to restart their processes to get the oil produced.  Then the oil has to be shipped to wherever.  And it doesn't get there overnight.  And most of that oil is not coming here. Check out this site:  https://afdc.energy.gov/data/10621   A graph will pop up to show where the US imports their oil from.  Notice that there isn't a lot of import from OPEC and Iraq.  Most of the US import comes from Canada. The US oil produces are selling their oil on the open market, which is why the US fuel costs went up.  So you're correct, the US oil companies are going to slow walk the price downward.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...