Jump to content

2006 Chevy Tahoe Coolant temperature low

Mfriend3
 Share

Recommended Posts

Mfriend3 Enthusiast

Mfriend3

Posted
Posted (edited)

I got a 2006 Tahoe that needed an engine.  found a remanufactured (z code engine) had installed with new water pump, radiator and thermostat ( have replaced 3 times with factory 187 degree stat). Now the engine runs about 165 to 175 on the road. When idling it will get up to about 210 and will stay there all day idling fans turning on and off working normally. But when I drive temp drops back down to 165-175. Has anybody sean this and know what the issue might be? I’m checking coolant temperature with ODBII scanner and gage. 

Edited by Mfriend3
Add info
  • Mfriend3 changed the title to 2006 Chevy Tahoe Coolant temperature low
Sharpz Enthusiast

Sharpz

Posted
Posted

If you are positive you have no air in the system and the gauge doesnt jump past 210, you are within specs.  Your heater works as it should I am guessing since you didnt list that as a symptom.  Since you have went through and did all this work, you may want to stick another coolant temp sensor in, for what they cost, it would eliminate at least one possible issue to whats going on with your gauge.  

Mfriend3 Enthusiast

Mfriend3

Posted
  • Author
Posted

I have replaced the coolant temp sensor and harness when replacing the engine. The heater gets warm not as hot as I would think but is putting out heat.  As far as bleeding all the air I have been trying to find the best way to make sure it’s all out but it’s hard to know. As many times as I have drained and filled the system you would hope I don’t have any air pockets. 
Thanks for help alway open to suggestions. This is driving me crazy. 

Sharpz Enthusiast

Sharpz

Posted
Posted

It should get hot, a clogged Heater core might be giving you issues.  Get a pipe and bypass the core and see if this resolves your issue.  

Mfriend3 Enthusiast

Mfriend3

Posted
  • Author
Posted

I will do that it does make sense. I will have to figure out how to bypass heater hoses but the hose to the surge tank (return)connects to the heater hoses. 

Sharpz Enthusiast

Sharpz

Posted
Posted
3 hours ago, Mfriend3 said:

I will do that it does make sense. I will have to figure out how to bypass heater hoses but the hose to the surge tank (return)connects to the heater hoses. 

2 things you can do.  First get the HVAC coupler removal tools, and remove the heater hoses where they plug into the HVAC.  Then get a pipe that they will fit (its only to bypass the Heater core for the test.  The other thing you can do, if the hoses are old, and its been a while since you have changed them, go ahead and just cut the hoses on inlet and outlet about 8 - 12 inches from where they plug into the HVAC and get a pipe to just slide them over using screw down clamps.  Keep in mind that a known issue is the plastic coupler for the inlet is a common fail point, so you may just want to plan on replacing that coupler, anyway.   This should allow you to bleed out the system again, and get a reading on your temp issue. Obviously if the temp is stable it would have been because of air in the system or your heater core.  Flushing it out with the lines off with a garden hose on the outlet side without high pressure sometimes helps to free any clogs. 

Mfriend3 Enthusiast

Mfriend3

Posted
  • Author
Posted

Well I decided before I bypassed the heater.  I would try and restrict the return hose from the coolant surge tank to the water pump/ heater hose. Then started it up and let it run came right up to temperature about 197 degrees and then I drove it stayed around that temperature fluctuates a few degrees up and down. Not sure if this is a fix but I will drive around some and test. I’m sure I will need to adjust how much flow and see how it does. I’m still looking for a fix and other suggestions or ideas. 
Thanks everyone for your advice!

Mfriend3 Enthusiast

Mfriend3

Posted
  • Author
Posted

I believe it is fixed and it turns out that the radiator has a restrictor on the small hose that goes to the surge tank. But what I think is that the restrictor was letting to much coolant flow to the surge tank and bypassing the thermostat and keeping the engine cool. I added a brass shutoff to that hose and the temperature I’d now running around 195-200 and I can adjust the flow and temperature. Thanks for everyone’s help. I will let you know if I have any other issues. 

  • Thanks 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Coastie05
      Replacing 2.7L on 2021 Silverado with 2023 2.7L

      By Coastie05 · Posted

      I’m definitely interested to hear the end result here. 
    • MASONV88888888
      Another 6.2L engine failure!

      By MASONV88888888 · Posted

      My 2025 Silverado 1500 had to receive a brand-new engine (long block) under warranty last month at only around 16,500 miles. Before the replacement, the truck repeatedly displayed "Engine Oil Level Low" warnings, even though the Oil Life Monitor still showed around 50% remaining after about 6,000 miles since my last oil change. After seeing the warning several times, I checked the dipstick with the engine cold, and the oil level was completely normal. The next day, the message escalated to "Add Engine Oil." At first, I assumed it was just a faulty oil level sensor, so I brought the truck to the dealership. After inspecting the engine, they found internal cylinder wall scoring and ultimately replaced the entire long block under warranty. Before this happened, I was planning to install a 4-inch lift and suspension upgrade on my truck. After needing a new engine at just 16,500 miles, I honestly don't see the point anymore. I also contacted GM to ask whether my vehicle qualified for a buyback, but I was informed that it does not at this time. Anyway, this experience has left me with serious concerns about the long-term reliability of this engine. I sincerely hope NHTSA expands the current investigation or recall to include 2025 model and performs a thorough inspection of affected vehicles. My biggest concern is that these engines may fail shortly after the powertrain warranty expires. If GM truly stands behind this engine, then at the very least, please consider extending the powertrain warranty to 10 years for affected owners. That would go a long way toward restoring customer confidence.
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      Without exception but then I'm the odd duck, right? I know what goes into that test, how it is calculated and thus how to beat it. But EPA values are often not beaten by the general public and the government has in past years adjusted the means and methods to come to those values to more closely approximate "Joe Average".    The only real trick to beating that EPA average is don't drive like "Joe Average".    It's the same method you used to profit from "Economic Migration" and in doing so beat the 'stats'. But you, like me, are not "Joe Average".     The thing you don't seem to grasp is this "Purchasing Power Index" isn't forward looking. It doesn't predict what it going to be but looks backward and states what it was. They are not telling us what the THINK, they are telling us what they MEASURED. Example:    Wife says "I'm going to lose 40 pounds by Christmas". May she does, maybe she doesn't but the doctors office who weighed her when she made that statement and again at Christmas only REPORTS what the RESULT was. You and I can banter about what was possible and what aunt Tilly did till the cows come home but the result is the result. Arguing otherwise is.....irrational. That's all I'm saying. This isn't about:      What you are calling a 'Statistic' is a RESULT not a CALCUATION and as a result the RULE. Like gravity as a rule, it can not be broken. 
    • MASONV88888888
      Rattle in the rear!

      By MASONV88888888 · Posted

      Just wanted to say thank you for posting this. Years later, your thread is still helping Silverado owners.   I bought my 2025 Silverado 1500 in January 2025, and I've had what feels like the exact same rattle since day one. After reading your findings, I believe my truck has the same issue with the cable carrier contacting the rear sliding window. To be honest, I had pretty much given up on pursuing the issue. It wasn't until I recently drove another brand's pickup that I realized just how quiet their cabin was—and how noisy mine has been all along. On my truck, the rattle happens on almost any paved road, gets even worse on rougher pavement, and I can even hear it during braking and acceleration.   I actually referenced your thread when submitting my case to GM, hoping they'll recognize this as a recurring issue instead of treating it as an isolated incident. The reason I reached out to GM first is because my dealership told me they would need to keep the truck for at least two days just to diagnose the problem. I was concerned that even after two days, they still might not be able to identify the source of the rattle before giving the truck back to me. I had also asked a few dealerships about this issue during previous service visits, but none of them seemed to know what was causing it or had a solution. That's why I decided to contact GM directly first, hoping they might already have an official repair procedure or guidance for this issue.   I also hope GM eventually comes up with an official fix for this problem. I have a feeling there are many Silverado owners experiencing the same rattle, but most either choose to live with it or simply don't know what the cause is.   Really appreciate you taking the time to document your diagnosis. Your post is still making a difference years later.
    • Buckwild27
      Gas Prices

      By Buckwild27 · Posted

      I have 2 choices. 

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...