Jump to content

Recommended Posts

Posted

What does the quad say?

 

Dirty Chicken?

Posted

My weekend

 

ab27a1e85b4d4131889b94a971889ac3.jpg4f478f158b9331922ee9602a9bd0eee6.jpg3d152e58ee40c9caf4b2d457b76d9701.jpg

 

Sent from my SM-G925V using Tapatalk

Were is this place would love to put paddles on my Raptor and take it there.
Posted

Silver Lake in Michigan.

Does anyone still have that picture?
  • Like 1
Posted

Does anyone still have that picture?

 

I traded that truck in. Doesn't count anymore. lol

Posted

I traded that truck in. Doesn't count anymore. lol

Doesnt stick with the truck. Sticks with the person. The DMV didnt wipe my 80 in a 45 because i changed engines
  • Like 2
Posted

Doesnt stick with the truck. Sticks with the person. The DMV didnt wipe my 80 in a 45 because i changed engines

Second that motion

 

It is with you for life lol

Posted (edited)

We'll need the snowblower here, unfortunately. 6" more on the way for Monday ... :nonod: 22° right now ..

 

IMG_5560_zpsb2eh5ix9.jpg

 

IMG_5561_zpsqmcxcdri.jpg

Edited by Jsdirt
  • Like 2
Posted

That sucks iv already had to lay all my motocross gear out on the deck to air out and dry out (it was starting to smell like my hockey equipment) but then again I live in Saskatchewan and there's bin times were its 20+C and next day it's snowing so dam until June its every man for himself here in Saskatchewan.(land of living sky's)

Posted

Sounds alot like here! Not too long ago I was out on my '74 RD350, smoking up the town. Now it's headed toward the teens ... Fahrenheit. In another week it'll be mid 60's again.

 

Last year I ran the coal boiler until June for heat! The year before it was 80° in March. Just never know what your gonna get in New England ... and that goes for politics too ... :lol:

Posted

Picked up a new axle shaft and seal for the truck but ran out of time to get them replaced. However I did replace the footwell light bulbs...kind of nice to have some additional lighting inside the cab when I open the door.

Posted

Picked up a new axle shaft and seal for the truck but ran out of time to get them replaced. However I did replace the footwell light bulbs...kind of nice to have some additional lighting inside the cab when I open the door.

One for he things GM forgot to add to the k2 trucks, kind of irritating. That and rear hvac vents
Posted

One for he things GM forgot to add to the k2 trucks, kind of irritating. That and rear hvac vents

This one doesn't have the rear vents either, except the ones under the seat. My old truck had the center counsel so it had the vents built into them.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...