What have you done to your K2 today?

[stormh2oguy]

The leveling kit is one of the aluminum lower strut mount spacers off of EBay. They come with 2 half inch spacers and 4 quarter inch spacers. The 1/2 inch thick spacer actually provides 1" of lift. You can combine them to make a 1/2", 1", 1 1/2" or 2" leveling kit. I have used this same kit on a 2012 Sierra and on my wife's 2011 Yukon and they are very high quality kits and only cost about $65.

[TXGrantDuke]

Put in a drop in K&N air filter two weeks ago. Might be a placebo bit I swear it runs and responds better.

 

Today I put on the Access Tonnosport Tonneau Cover. I did more research than I care to admit. Went with this bc of full bed access, no drilling, and sleek look.

 

Thus far it is greatm install was by the book. Small problem with one clamp but it was easily fixed.

 

Pics before and after below.

 

 

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

 

[TXGrantDuke]

Couple with it open:

 

 

Sent from my SAMSUNG-SGH-I337 using Tapatalk

 

 

[mking417]

Debadged the truck....

I spot a Reds Fan!

[LTZTom]

Installed an Airaid CAI yesterday. According to my "butt dyno" it made a BIG difference!

 

[block8head]

 

 

 

Installed an Airaid CAI yesterday. According to my "butt dyno" it made a BIG difference!

 

Love the intake... Any noticeable gain?

[LTZTom]

It sure feels like it did. And as an added bonus I believe it's getting a little better gas mileage.

 

 

Tapatalk via iPhone 5s

[Dj0nes]

I have the same one installed on mine and it's awesome. Got about 350 miles on it.

 

 

Sent from my iPhone using Tapatalk

[GMC-AT]

My Airaid should be in early next week.. can't wait. For you guys that just installed it.... how is the noise level? can you explain....

[nomadicdogg]

Installed an Airaid CAI yesterday. According to my "butt dyno" it made a BIG difference!

 

I see you have the 6.2... did you end up using the 5.3 CAI kit from airaid? any modifications for it to work?

 

also is that 6.2 badge in the front factory or did you add it? where is it from? looks nice!

 

Edited February 9, 2014 by nomadicdogg

[LTZTom]

 

Installed an Airaid CAI yesterday. According to my "butt dyno" it made a BIG difference!

 

 

 

 

I see you have the 6.2... did you end up using the 5.3 CAI kit from airaid? any modifications for it to work?

also is that 6.2 badge in the front factory or did you add it? where is it from? looks nice!

 

I added it. I got them on eBay. Yes it's the one for the 5.3L. I read where they had no plans to make seperate one for the 6.2L. Honestly, after installing this one, I don't know what they could do differently for the 6.2L. Someone on here mentioned that it was a little hard to slide the air tube over the snout on the fuel injection unit but it wasn't that difficult when it was all said and done.

Edited February 9, 2014 by LTZTom

[nomadicdogg]

I added it. I got them on eBay. Yes it's the one for the 5.3L. I read where they had no plans to make seperate one for the 6.2L. Honestly, after installing this one, I don't know what they could do differently for the 6.2L. Someone on here mentioned that it was a little hard to slide the air tube over the snout on the fuel injection unit but it wasn't that difficult when it was all said and done.

both look great

[LTZTom]

Thanks!!!

 

 

Sent from my iPad using Tapatalk

[LTZTom]

After a wash I get my Purple Slice out, slide under the truck and do the part of the tailpipes that can been seen so they alway look brand new anyway.

 

 

 

what is purple slice?

 

It's a detailing spray that I use on my Harley. It's good stuff. Look it up at purpleslice.com

 

 

Tapatalk via iPhone 5s

[block8head]