Jump to content

Recommended Posts

Posted (edited)

I have a 2010 Sierra 1500 4x4 with 21,000 miles. The park assist quit working. When pressing the button under the radio, it does not light up ever, but the display briefly show "Park Assist Off". I check the parking brake, there is no trailer hitch and tailgate is up.

There use to be a beep upon shifting to reverse, but not any more. Nothing. Any ideas?

Edited by jnicke
Posted

try a battery disconnect thing ,,,,,,if that does not work ,,,you have to take it to a garage that has knowledge on computer controlled vehs ,,,,,or a dealer

  • Like 1
Posted

I had an issue with my aftermarket radio... the audible alerts didn't work right with the module and wintertime car washes caused ice that scrwed up the sensors so I just got rid of it you can totally disable it if you like... that's what I did. you pull the fuse and disconnect the battery for 5 minutes and it relearns the computer like it was never installed.

 

I am going to be replacing the sensors with LED lighting at some point as well


I had an issue with my aftermarket radio... the audible alerts didn't work right with the module and wintertime car washes caused ice that scrwed up the sensors so I just got rid of it you can totally disable it if you like... that's what I did. you pull the fuse and disconnect the battery for 5 minutes and it relearns the computer like it was never installed.

 

I am going to be replacing the sensors with LED lighting at some point as well

Posted

A bad sensor will disable the system but usually results in a service park assist light. Make sure all 4 sensors are properly seated.

Posted

try a battery disconnect thing ,,,,,,if that does not work ,,,you have to take it to a garage that has knowledge on computer controlled vehs ,,,,,or a dealer

Disconnected the battery for 10 mins and it now works! Thanks

Posted

Beginning to think vehicle these days are getting more like computers, less like machines. First thing you are asked to do when your computer acts up, restart it. Restarting a computer is effectively removing power from it. Looks like disconnecting battery is the ultimate ctrl/alt/del three finger salute.

  • 7 years later...
Posted
On 3/28/2014 at 8:40 AM, jnicke said:

Disconnected the battery for 10 mins and it now works! Thanks

I had to replace a damaged front sensor on my 2016 Silverado 2500hd LTZ. I damaged it accidentally and I replaced it with the correct part number.  My issue is, I now have a flashing yellow light on the dash button, but my DIC is showing it enabled!  If I disconnect the batteries, which terminals do I remove from the batteries?  Someone has suggested to positive terminals, but why can't I just do the negative ones?  Also, do I need to located and pull the fuse first?

 

Thanks!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Your tire pressure issue may just be batteries, you can reset them using tge Ing switch (I think) and the owner's  manual. ChatGTP will b e a faster, better help than Google.
    • The thinking is that starting out in a higher gear makes it easier to avoid applying excessive torque when pressing the gas pedal. In a modern 4wd truck with 4 low and a limited slip or locking rear end, I would use 4 low and try to crawl up the ramp. Sometimes if they are too slippery, you have to back up to let the boat have some bouyancy, and then accelerate briskly to get some momentum to help you pull the through the slippery parts. 
    • I have a Retrax pro that I first had on my 2020 chevy and transferred it to my current GMC.  It stays in the garage most of the time, so hard for me to judge it's long term weather resistance.  It still works perfectly, been very durable.  It doesn't see oil patch usage, but it's not a mall queen.  It keeps most things mostly dry (small leaks) and the security of it is enough to slow someone down but not keep them out for long.  I would buy one again, it works for me.     
    • Thanks to the convenience of Amazon, I was able to get a few things done to the truck today.  I installed Carquest Premium oil and air filters with five quarts of Mobil1 High Mileage 10-30 along with a quart of Pennzoil Platinum 5w-30 I already had.  The latch for the flip up center console lid was broken so I replaced it along with the power mirror switch.  I found my push retainer assortment this morning and reattached the plastic under the bumper and it was only held on with a few screws and retainers.  Then I programmed a new remote keyless entry fob so I can lock my dog in the truck when I take her out with me (I've got to keep the air going for her since it's been in the 100s).  Finally, I ordered some LED interior bulbs and replaced the reading lamps.  The front lights are working fine while one of the back lights only works intermittently and the other not at all.   While under the truck, I found the source of at least one of the noises: the sway bar links need replacing.  I ordered a set of Suspension Dudes links with Code Red bushings.  Never heard of them, but they're made in the USA and have decent reviews.  While making yet another Amazon order, I went ahead and added a set of front tow hooks.  I went with red, since that's the color of the sway bar link and bushings and it should look decent enough on a black and chrome truck.  Speaking of which, it doesn't bug me much, but the passenger side mirror has a chrome cap while the driver side doesn't, so eventually I'll make them match one way or another.  Oh, and I ordered a $20 TPMS reset tool.  No idea if it will do anything for my sensors but it was cheap and will work for the Ford Transit Connect as well.     For tradition's sake, I ordered a new oil change wrench.  I kept the Snap-On 9/16"x15mm GM wrench I bought when I was 18 in the 2006 GMC from the time I bought that truck until the truck was lost.  While I was tempted, there's no need to spend $80 for a new SO wrench, or even $50 with shipping for a used one on Ebay.  I just bought a Duratech 15mm extra-long ratcheting wrench to do the job as needed.  It works, and if I like that wrench enough, I'll buy the set.  
    • The recall is for exactly this issue - those drain holes combined with the limited environmental capability of the tailgate electronics card inside the tailgate were a problem. The “safety issue” was the potential for the tailgate to spontaneously open, but all kinds of tailgate misbehavior can occur from water contamination of that control card.    There is no real fix yet. The initial recall just disabled the tailgate. Later, when parts became available, they would replace bad parts with new parts of the same bad design. My dealer is going nuts because the few times I let them get their hands on my truck, my tailgate is off due to a slide-in camper installation. They really want to cut my tailgate wires, but I won’t give them the chance. I will let them get their dirty hands on it when a real fix (redesign) is available.  My tailgate, which works just fine with sealant plugging the drain holes, will remain safe in a dry storage crate until then.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...