Jump to content

Recommended Posts

  • 2 weeks later...
Posted

c42097cdcba74a5c240229461621f9fb.jpg

I just added mine on Friday and it does gets toasty., pgamboa helped me out on removing the air bag the rest was a piece of cake., the collision button obviously doesn't work but it does light up with the rest of steering wheel buttons, no biggie.

The 2 extra wires coming out of the new clock spring literally is ground and hot. If you can wire it to hot and ground the you'll be set.

 

 

Sent from my iPhone using Tapatalk

  • Like 2
Posted

The wire does go from X51L IP FUSE BLOCK LEFT to the X201 connector above the BCM. Connector X2 terminal 37 gets a (if I'm not mistaken [emoji851]) mouser 829-13849930-L and at X201 a Yazaki 7114-4110-02. Install it along with the new steering wheel airbag coil and you're good to go!

 

Oh and if you'd rather buy the terminated leads for the X51L side of things the part number is 19301761 comes in a pack of 5

 

 

Sent from my iPhone using Tapatalk

Using this method should the wheel turn on no matter the temp outside or does it have to be below a certain temp? I installed the wire per this thread and it doesn't light up but it's 65 or more degrees out.

Posted

I just turned mine on and it's 90 degrees out. Does your turn on at all?

 

 

Sent from my iPhone using Tapatalk

No light at all. I'll have to double check everything.
  • 2 weeks later...
Posted

Okay, I decided to install the harness at least and check for power and ground. Got it all set up, running factory with the factory fuse. I have power and ground at the small 2 pin connector just like it's supposed to. All I have to do now is install my airbag coil and steering wheel and I'll be good to go! [emoji1417]

 

f4d9e1cb5f6349476ff2daecac61f845.jpg

Two clips hold the fuse panel in, you have to hold them down and pull the panel outward.

046994f13e96f27fa2fc20278f44d1f1.jpg

 

ba8d225507cc00139c835c07c45b2672.jpg

There are 4 clips surrounding the connector. You'll have to undo the clips and move the CPA downward about 1/8 inch. It stops by itself to another set of stops, DO NOT go past those stops.

7833fd9015482bf60b38d42a17345ce1.jpg

 

5079adc512fd308c784a91e0d69b90ce.jpg

I chose to install thicker gauge wire because it's a battery positive circuit.

b357340fb09b000700ea371fd5fe98ad.jpg

 

068c45622b9dd5a5ef1d20861d1365d0.jpg

The X203 connector above the BCM.

8a115081c23e3227756e7a41874c7fff.jpg

 

 

 

Sent from my iPhone using Tapatalk

Any chance you have a few detailed pics of the X 203 connector, like the pin location circled. Just to make things as easy as possible. Thanks!

 

My wife just surprised me and bought me a heated wheel on ebay today.

Posted

31b70aac2d1d2ee53a59ad2649c3ac07.jpg

 

You should just be able to flip the connector over like in the picture. And use the surrounding wires around the one over circled. Compare it to yours and you'll see where it needs to go

 

 

Sent from my iPhone using Tapatalk

  • Like 2
Posted

Just to clarify... Is this an X203 or an X201 connector?

 

 

Sent from my iPhone using Tapatalk

Posted

No light at all. I'll have to double check everything.

Hey how did you make out? Did you fix your steering wheel?

Posted

I just got mine in the mail today. For those interested, there's a seller on eBay that has them for $150 shipped. They have the crash avoidance button too, but it doesn't bother me.

 

Clockspring is on the way and hoping I have the correct terminals to make my wire. Will keep posted.

Posted

ill tell you my heated steering wheel gets real hot. idk if i will get this option again. its almost worthless

Posted

ill tell you my heated steering wheel gets real hot. idk if i will get this option again. its almost worthless

You got to be only one who doesn't like it then. I've never heard of anyone not liking it

 

 

Sent from my iPhone using Tapatalk

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Based on what I can tell, yes.   As for updating it, its a mixed bag.  Updates do fix a lot of issues, but occasionally can create some oddities.  They do more good than harm though overall.     Here's what the most current one does and a  V171 Improvements Important: Improvements will vary by model, build configuration, system, and sales region. Not all vehicles have all features. OnStar and Wi-Fi may not work after remote start CarPlay may not automatically reconnect Part of the Driver Attention messaging screen may be in English even though the language is set to something else XM may not work After a dead 12V the radio may set to Arabic at each startup Bluetooth contacts might not be able to sync with the vehicle During an OTA the 12V battery may drain Customer might see a screen telling them to return to the dealer After changing the Wi-Fi SSID or password a device may not disconnect If a device is connected on the 2.4Ghz band, nothing will connect to the 5Ghz one, which could show as slow Wi-Fi speeds Customers might have noticed Wi-Fi dropping in certain areas and reconnecting later Customer might see the top of the screen blinking during Android Auto Android Auto may not connect CarPlay audio might momentarily cut out The "Add Phone" button may be grayed out The radio may not start up   V167 Most Notable Improvements:   Outside Air Temperature is incorrect. -You may see a popup message for Engine Shift. (Corvette Only) After changing the exhaust sound they get a popup that "mode change not applied", even though it was. -When changing volume, the volume bar is for Traffic instead of Audio. -(Corvette Only) Improvements to the placement of buttons and text. -If the customer receives the message "Apple CarPlay Could not connect", the cursor might move in the opposite direction than expected when using the control knob. -Android Auto automatically starts playing their music, even though they have turned that off in settings. -Intermittently they have a red OnStar LED with no OnStar function and/or no audio. -The minimum length of the Wi-Fi password was increased to 12 characters. -The popup message "Driver Attention Check, check your mirrors or Super Cruise will shut down" may not have come up on the display when it should have. -Startup animation added for 20th anniversary of the V-Series on Cadillacs. -The Navigation app received location improvements when going under long underpasses. -In the Navigation app there are filters for charging points that the vehicle cannot use.   V164 Most Notable Improvements Most notable improvements contained in this release may include: Apps Intermittently, an “SD Card Removed” message will pop up in the Navigation app. While in the audio app, the radio may stop working. Trailer Tire Pressure sensors may not be learned in the Trailer app. Not being able to return to the home screen while in the Camera app. After an ignition cycle, the radio might go to a black screen or stop working if using Sirius XM. Spotify icon truncated on Audio app.   SXM When changing power modes with the ignition switch, the HVAC pop up might appear. During startup, the radio will show the brand splash screen then go blank. Receiving a confirmation pop-up when changing drive modes. A “Return to Dealer” message may appear on the radio screen. SuperCruise setting toggle may not work. System After an ignition cycle, the radio might go black or stop working if using Sirius XM (SXM). Settings When performing a factory reset, the radio may stop working. After performing a factory reset, the radio may stop working when trying to switch users. When trying to go into the Language section quickly after startup, the radio may stop working. Projection Wireless CarPlay cannot be connected after unpairing another wireless Android Auto device. When the Android Auto screen comes up to connect wirelessly, the screen may freeze if the Cancel button is pressed. Removed the Apple CarPlay Cannot Connect screen when a device fails to pair during the autoconnect process. CarPlay information may not show up in the audio app. Near Field Communications (NFC) chime may be heard when NFC does not work. The Cannot Connect screen does not pop up after the first connection on wireless CarPlay fails. Apple CarPlay is now functional in Guam. Over the Air (OTA) When a software update is cancelled, the downloading logo may still be displayed. Energy When using the Energy app, the radio may stop working. When plugging in the vehicle, the display might show “Now” instead of “Charging Upon Plug In.” Instrument Cluster Voice recognition can be started while on an OnStar or phone call. When downloading contacts, there is a progress bar and circles on the Recents page of the cluster. The temperature on the cluster and the display may be different. After receiving and ending a call on the secondary paired phone, the cluster may get stuck on the phone menu. Bluetooth Intermittent Bluetooth connection loss.
    • Looking for help troubleshooting a metallic like front end rattle. Figured I’d see if anyone had thoughts before I schedule an appointment with the dealer.   The rattle is fairly loud and occurs primarily when the front driver side wheel hits a bump, even fairly minor road seams. Sometimes does it when the passenger hits a bump but I don’t believe when the rear hits. Rattle still occurs when foot is pressing brake peddle so I think that rules out the caliper rattle I’ve read about. I’ve also checked the running boards and they are tight.   Most noticeable at slow speeds.    Any insight is appreciated. 
    • We try to make cruise the coast. It’s where our favorite casino is. I only want to spectate. Never took a car. Always had one to take. I belonged to a club once. Even when I used to drag raced. It was during test and tune. Probably because I’m not a night owl, party person. 
    • We had a pretty big cars and coffee in Indy this past weekend.  Pretty much anything and everything was there.  
    • Good looking Olds, and TRX!   I haven't been into car shows either. I'm probably not a convert but I did push myself this year to attend a few select events to challenge some assumptions and try to experience car-based social clubs in a different way. I joined up with the local Hagerty group for some cars/coffee events, group drives. A month ago I showed my '94 Camaro I rescued last fall at Radwood. Had a good time, but, there was some sitting around with the car and that's the part of shows I don't enjoy as much. I prefer to be a spectator, walk the show, grab a burger, go home.   Radwood was the only era-limited event, but where it had strict model year limitations, it made it up in variety. Having Jason Camissa there was also a hoot.   Where I see old 50's car shows, doo-wop and winga dinga music stuff fading out, same with "only" vintage muscle clubs, it seems to be the activity-based clubs/events which are gaining strong popularity. Places where all cars and interests come together.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...