Jump to content

Recommended Posts

Posted

anyone ever replaced their rear back window with a power slider? if so have you had any issues? I was quoted $1200 but not sure it's worth the money.

 

If I'm being honest, I'm not sure I'd use it that much, I just like the way it looks compared to the solid window. I know they make manual sliding windows, but I don't want to lose my rear defroster.

Posted

I would have liked to have it but dont think its worth 1200 bucks. If I had to replace it anyway for some reason guess Id consider it.

Posted

Rear slider is one of the things I wish I really would have gotten.

Posted

I had a manual slider on my old truck. Didn't use it as often as I thought I would. I even specifically bought it with it, thinking I'd use it all the time.

Dropping the rear windows is much more effective.

Posted

I get turbulance sometimes if I have all 4 down a little, and really bad if it's just the rear 2.

Posted

anyone ever replaced their rear back window with a power slider? if so have you had any issues? I was quoted $1200 but not sure it's worth the money.

 

If I'm being honest, I'm not sure I'd use it that much, I just like the way it looks compared to the solid window. I know they make manual sliding windows, but I don't want to lose my rear defroster.

my new 2015 2500 hd has a rear slider with defrost so you don't have to lose it.

Posted

my new 2015 2500 hd has a rear slider with defrost so you don't have to lose it.

is it a manual slider? I was told it had to be power slider to keep defroster?

Posted

I wish there was an aftermarket kit that would drop the whole back window (like the Tundra has). That would be worth $1200 to me!

 

Not sure the little box in the middle is worth that kind of money.

  • Like 3
Posted

I've been looking at doing this also on my 2011....when you weigh the cost and how much you'll use it, the decision gets a little tougher. EBay has some decent "buys"......but, it's well......EBay. If you do it, please post pics!

Posted

I get turbulance sometimes if I have all 4 down a little, and really bad if it's just the rear 2.

 

 

is it a manual slider? I was told it had to be power slider to keep defroster?

 

 

Yeah, mine is a power sliding w/defrost. It actually does a good job at eliminating the turbulance when you want to drive with the windows down. The biggest problem is trying to remember to close it at night.

  • Like 4
Posted

I have the slider and I used it once to make sure it worked and that was it I forget its there

Posted

I use mine all the time, the dogs love it and I also use a vaporizer and on the interstate with the window all the way open you can hardly tell.

  • Like 1
Posted

is it a manual slider? I was told it had to be power slider to keep defroster?

I think he was just saying that with the factory slider, you still have defrost.

  • Like 1
Posted (edited)

I guess I'm the only one that didn't want a power slider.. one of the first mods I did after getting my truck.

post-145646-0-90451400-1446253754_thumb.jpg

post-145646-0-53216900-1446253771_thumb.jpg

post-145646-0-90451400-1446253754_thumb.jpg

post-145646-0-53216900-1446253771_thumb.jpg

post-145646-0-90451400-1446253754_thumb.jpg

post-145646-0-53216900-1446253771_thumb.jpg

post-145646-0-90451400-1446253754_thumb.jpg

post-145646-0-53216900-1446253771_thumb.jpg

Edited by Silver ice 6.2
  • Like 3

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...