Jump to content

Is it bad to run your truck in “Auto 4wd”?

aha1987
 Share

Recommended Posts

aha1987 Enthusiast

aha1987

Posted
Posted

Curious to know if any of you always keep your truck in 4wd auto. If so, does it hurt andything and does it effect MPG?

  • Replies 48
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

OnTheReel
OnTheReel

4 AUTO engages the front axles but sends very little power to the front wheels until slip is detected. The power distribution is handled by an electronic clutch in the transfer case.   In au

z1boss
z1boss

I've always ran my trucks in 4wd auto.  No issues at all.  I've noticed that the gas mileage isnt really affected either based on my testing.

Wiggums
Wiggums

Manual states slight drop in gas mileage if set on auto instead of rear wheel drive.    

Posted Images

Controller23 Enthusiast

Controller23

Posted
Posted

Anecdotal, but I had a 2015 that stayed in auto 4wd. It however was owned by my work so I wasn’t afraid to beat it up, and I didn’t track mileage at all. Never had any problems with the truck though.


Sent from my iPhone using Tapatalk

UGADawgs Enthusiast

UGADawgs

Posted
Posted

I think 4 auto keeps the transfer case in open diff mode, so it should be safe. However, if you're on dry pavement, not sure the value doing it. Mostly some mpg loss. If it was raining, I'd definitely use it.

OnTheReel Senior Enthusiast

OnTheReel

Posted
Posted

4 AUTO engages the front axles but sends very little power to the front wheels until slip is detected. The power distribution is handled by an electronic clutch in the transfer case.

 

In auto, there is a slight fuel economy penalty and also more noise / vibration, both due to having the axles engaged and more rolling resistance.

 

Also, in theory, driving all the time in 4 AUTO would increase wear on the transfer case clutch and assorted components.

 

Although it is “safe” to use all the time, you really should be in 2WD unless the road conditions are sloppy. I usually use 4A if there’s been a snowfall in the last couple days and the roads and parking lots aren’t all the way cleaned up. I also have been known to slip it into 4A if I feel like the guy next to me wants to have a little stoplight race. Otherwise it’s 2H basically all the time.

  • Like 8
Wiggums Senior Enthusiast

Wiggums

Posted
Posted

I read that it MPG drops by one if it's kept on Auto 4x4. Not bad for it but if you have unpredictable traction, better to keep it on.

Booger T Enthusiast

Booger T

Posted
Posted
6 minutes ago, Wiggums said:

 

I read that it MPG drops by one if it's kept on Auto 4x4

 

Says who?

Wiggums Senior Enthusiast

Wiggums

Posted
Posted
10 minutes ago, Booger T said:

Says who?

Manual states slight drop in gas mileage if set on auto instead of rear wheel drive.

 

 

Screenshot_20190323_185143.jpg

  • Like 2
Imcrazy Senior Enthusiast

Imcrazy

Posted
Posted

There is no good reason to do it... It will cause additional wear on the four wheel drive system.. Are you new to 4x4 trucks? If you have a locking rear end and you're not off road, there will be very few situations outside of snow that you use anything but 2 high... I will use AUTO if I am trying to get a jump on traffic off the line sometimes because the truck is quicker off the line with it but, beyond that unless there is significant snow on the road there aren't many reasons I can think of that any 4 wheel drive mode is needed if you're on paved roads..

  • Like 2
diyer2 Senior Enthusiast

diyer2

Posted
Posted
37 minutes ago, Imcrazy said:

There is no good reason to do it... It will cause additional wear on the four wheel drive system.. Are you new to 4x4 trucks? If you have a locking rear end and you're not off road, there will be very few situations outside of snow that you use anything but 2 high... I will use AUTO if I am trying to get a jump on traffic off the line sometimes because the truck is quicker off the line with it but, beyond that unless there is significant snow on the road there aren't many reasons I can think of that any 4 wheel drive mode is needed if you're on paved roads..

Agree.

:)

 

Druder Enthusiast

Druder

Posted
Posted

I've accidentally left my truck in auto the day after a snowstorm and didn't notice a difference in driving characteristics but like everyone else said, there's no benefit to it, only cons unless it's raining or snowing.

aha1987 Enthusiast

aha1987

Posted
  • Author
Posted
1 hour ago, Imcrazy said:

There is no good reason to do it... It will cause additional wear on the four wheel drive system.. Are you new to 4x4 trucks? If you have a locking rear end and you're not off road, there will be very few situations outside of snow that you use anything but 2 high... I will use AUTO if I am trying to get a jump on traffic off the line sometimes because the truck is quicker off the line with it but, beyond that unless there is significant snow on the road there aren't many reasons I can think of that any 4 wheel drive mode is needed if you're on paved roads..

Am I new to 4X4? That is a no. I’ve owned more than I can count. Btw, your rear end isn’t locked when you are in auto 4WD. It locks when it senses slipping. Will do the same thing in 2WD

Imcrazy Senior Enthusiast

Imcrazy

Posted
Posted
3 hours ago, Aycock1987 said:

Am I new to 4X4? That is a no. I’ve owned more than I can count. Btw, your rear end isn’t locked when you are in auto 4WD. It locks when it senses slipping. Will do the same thing in 2WD

Yes I knew that about the G80 rear end... The auto mode is really only intended for mixed road conditions, IE partially snow covered roads and getting in and out of slushy parking lots or messy gravel roads. If you leave the truck in auto for a few days accidentally I'm sure you'll be just fine but, there is not really any reason to use auto unless you're off road or the road conditions are poor..

Cpl_Punishment Senior Enthusiast

Cpl_Punishment

Posted
Posted

I agree with the folks who recommend running in 2H unless traction is bad. However, when I'm driving my company's trucks around the plant where I work, I find it will spin a little on the sand and gravel that's all over our roads so I usually shift to 4A so our safety guys don't give me shit. 

UGADawgs Enthusiast

UGADawgs

Posted
Posted (edited)
1 hour ago, Cpl_Punishment said:

I agree with the folks who recommend running in 2H unless traction is bad. However, when I'm driving my company's trucks around the plant where I work, I find it will spin a little on the sand and gravel that's all over our roads so I usually shift to 4A so our safety guys don't give me shit. 

Sand and gravel, yes ?

Clean pavement, no ?

Edited by UGADawgs
z1boss Enthusiast

z1boss

Posted
Posted
On 3/23/2019 at 7:52 PM, Aycock1987 said:

Curious to know if any of you always keep your truck in 4wd auto. If so, does it hurt andything and does it effect MPG?

I've always ran my trucks in 4wd auto.  No issues at all.  I've noticed that the gas mileage isnt really affected either based on my testing.

  • Like 4

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • KARNUT
      2027 GMC Sierra: Official Discussion

      By KARNUT · Posted

      It really is comical when people don’t agree or see the reason some people prefer the older vehicles. They become condescending. All the while they may be busting their knuckles on old vehicles. I have found memories of swapping out engines in my old GM cars in a weekend without much hassle. Unlike today. One wrong move a computer will shut you down. Even on something as easy as a brake job. There’s a pretty comical YouTuber called the car wizard. A garage owner who puts it all in perspective. Another Vicegrip garage that’s shows just how tough the old stuff is. 
    • Jsdirt
      2027 GMC Sierra: Official Discussion

      By Jsdirt · Posted

      I was around and remember that era very well, so I'm calling b/s on that statement. If they were that bad no police department or taxi company would've bought a single one ... but they were used in both services (and fire) for DECADES. They were bulletproof and proven. Even the early 21st century ones weren't too bad! The early models were legendary.   Mine is proof, but people like atlas are blinded by agenda and refuse to believe facts right before their very eyes.   Even decades after they were built, a new generation started driving them, posting all their builds and shenanigans on Grandmarq.net and Crownvic.net. The failures would show up then, since they all were deep past 100k-150k miles by that point, and younger drivers tend to be a little aggressive, especially with vehicles than can lay a one-tire fire for as long as you hold your foot in it. They've more than proven themselves over the decades.   The only thing that'll really take them out is road salt. The bodies and sheet metal were garbage. A victim of the cheapout FoMoCo and GM have been partaking in before then, and since.   Today it's the stuff that counts - the undercarriage that rots away first!    GMs Caprice was no slouch either. Reliable as a stone ax - the opposite of what they build now.    
    • Jsdirt
      2027 GMC Sierra: Official Discussion

      By Jsdirt · Posted

      Let me know how your vehicles do in 10 years. You don't know ******, kid. 😂    There's a reason that Panther platform was used as police, fire, and taxi service for DECADES ... long before you were born, apparently.
    • davester
      Disconnecting Battery

      By davester · Posted

      If your connector also has a big lever to get the connector on and off, you don't want to force the lever either way, as it becomes a bigger problem if you bust the lever or the mechanism it works.
    • davester
      Disconnecting Battery

      By davester · Posted

      It's just useful to disconnect the battery to prevent odd shorting out when unplugging/plugging stuff together.  I also  touch the two cable ends together (after disonnecting) to drain the small amount of stored battery energy in various modules.   I believe the main system where you need to be more concerned with, so you need to do the above and then wait some time, iss when you are working on the air bag system, to prevent inadvertent firing of the air bags.   The in-cab switches are just that, plain switches, it's generally not a problem to swap them in/out.  For my '12, I'll get an error message on the dash if I power up the truck w them unplugged, but that's it (power up= turn the ignition on).   The ITBC located above the spare tire is a computer that manages the trailer brake system.  That is probably more important to have the battery disconnected.  It does have to be programmed to the truck, either before or after it's installed, for it to work.  For my '12, I had a very hard time reinstalling the main connector to it (IDK if yours is the same or not), it turned out the silicon seal was jamming up, preventing it from going on all the way.  I finally got it fully installed by lubing the seal with a bit of dielectric grease, then it slid on and latched in place easily.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...