Jump to content

Recommended Posts

Posted

     Hello, I have a brand new 2018 GMC Sierra SLT Z71 8 speed Crew Cab with the 5.3 engine. I know this has been discussed before, but I haven’t heard anybody say this low of oil pressure

(15 psi) at idle, stopped, in gear, after driving for about at least 30 minutes. Yes, I freaked out the first time I noticed it when the truck only had about 250 miles on it. It now has a little over 2000miles on it. When driving at speed of about 45 miles an hour it’s about 35ish psi pressure which I think is ok, and all other speeds it seems ok. It’s the hot idle (about 600 RPM)while stopped and in gear low oil pressure that has been bugging me ever since I first saw it. It only goes this low after driving for at least 30 40 minutes in warm 85* weather. I know about the two stage oil pump but this just seems low.

        Can anybody please tell me if their trucks run this low of pressure stopped, idling, and in gear, after completely being warmed up? It will put my mind at ease if others have the same results. Even pics of the gauge.

        Thank you,  Steve

 

 

03B424A3-3E31-4EE0-AC2A-7A73F25EAA8E.thumb.jpeg.964207cdcf1e5cc0c928f874f2c7c3c0.jpeg

Posted

Most vehicles will have lower oil pressure in gear warmed up. If it was a stick you could get it down lower by engaging the clutch a bit. There’s a light that would come on if it got to low.


Sent from my iPhone using Tapatalk

Posted

It takes 8 quarts of the 0w20 wt oil which I know is thin.

Just getting this low on a brand new 2018 Sierra seems crazy as when the engine gets older, with miles on it, it will probably go lower..

Never had warning messages thou.

I know the dealer will tell me it’s normal until the warning message appears..

Anybody out there actually have oil pressure that gets this low?

So I should have nothing to worry about?

 BTW Thank you so much for your replies so far.

Posted

It is possible that the one oil pressure sensor that is on your vehicle is one that it's settings are reading at the lower side of average if that makes sense.  

Posted

 That could be.....

 The way I look at it if other people are getting this low of readings in these conditions, I should be good at the end of the day, I would think. 

Posted

My 2018 CC w/ 5.3 w/ 6sp trans does the same at various intervals.  Does not seem to matter if at idle or on highway.  Voltmeter also will dip low too but never had any warning lights/messages.  I have nearly 30k miles on mine now.

Posted
My 2018 CC w/ 5.3 w/ 6sp trans does the same at various intervals.  Does not seem to matter if at idle or on highway.  Voltmeter also will dip low too but never had any warning lights/messages.  I have nearly 30k miles on mine now.


Voltmeter dipping low is normal. GM thought it’d be cool to cause a panic doing this. It’s to prevent overcharging of the battery.

As far as oil pressure, looks ok to me. I’ll drive mine and get back to you. Pretty sure mine’s in a similar spot.
Posted

My oil pressure is all over the place in certain conditions. Especially when the transmission shifts. 2016 Silverado Z71 Crew Cab 5.3L 6spd


Sent from my iPhone using Tapatalk

Posted

 DirtyAndy, it would be great if you got back to me on this.  Problem is you have to drive it for over 30 to 40 minutes to get the readings that low, as far as how mine is. 

 

Thank you guys for all these great replies. So you guys are actually getting as low as around 15 pounds PSI according to the lines on the gauge in the dash?

 The more people that chime in on these low oil pressure’s of about 15 PSi,  on this model year, I think, will make a lot of us feel better that it’s very likely normal .  I would’ve been OK  in the first place, if it was a little above 20 psi at the lowest reading .  All my other previous trucks, never went below around 30 psi stopped, at idle, in gear, after a long drive. 

 The more people that chime in, give us a better idea of how these new trucks really are or what to expect...

   

Posted

Mike,  in my own past experience having the oil pressure jump up-and-down as you’re on the gas and through shifting of the transmission is perfectly normal with any model year in my experience. 

Posted (edited)

In the old days, 12 volts was sent to alternator to kick on charging system when key turned on. Resulted in overcharging of batteries. PCM now cycles alternator on and off to keep from boiling the battery off.

 

0 weight oil in Cali in hot temps getting low oil pressure....no fear. 

 

You can get a 5.3 with 20k miles from a crashed truck on Ebay for $2k. Keep trusting GM and just drive it. Insufficient Oil Pressure= AFM lifter failures via the Melling Bulletin from last year. They make the collapsible lifters for 4 cylinder shut down.

 

https://www.melling.com/wp-content/uploads/2018/03/Melling-tech-bulletin-on-GM-LS-Deactivation-Lifter-Issues-3.1.18-1.pdf

 

Read what Melling says oil pressure is supposed to be.

 

 

 

Edited by Paintor
Posted
Mike,  in my own past experience having the oil pressure jump up-and-down as you’re on the gas and through shifting of the transmission is perfectly normal with any model year in my experience. 

Yeah thanks. I’m not worried about it. Funny thing is that I didnt mention that my oil pressure actually always goes up, never down. A little different than the OP’s situation.


Sent from my iPhone using Tapatalk
Posted

15psi is too low. I wouldn’t feel comfortable driving it. 

 

Hot idle mine hovers in the low 30’s and cruising I see 50+ psi. 

Posted

My 2018 5.3 will drop to 15 psi at hot idle after it gets good and hot, usually after a run on the highway in FL heat.  Im assuming its normal operation considering how thin the oil is required to be.  

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Welcome back! No, it definitely doesn't pass the sniff test. Even "ceasefire" needs an alternative definition these days.    $5.29 at Kroger today
    • That makes sense, and I think you are describing the real product problem. Capturing data is the easy part. If the owner or technician has to manually dig through five minutes of millisecond-level logs, the product has already failed. The device would be at the ECM harness, not at the OBD port, so I agree that data retrieval and event marking need to be thought through carefully. The way I am thinking about the architecture is: The recorder itself should not depend on a phone, app, Bluetooth, Wi-Fi, or cloud connection to capture the event. It should always keep a local rolling buffer and lock the event locally. A button, phone app, or small cabin device would only act as an event marker. If the driver feels a stumble and presses the button 10–30 seconds later, the pre-buffer has to already contain the useful data. For data retrieval, the practical options would be a sealed service USB lead, Wi-Fi download, or a phone/cabin companion device. I would not expect the owner to remove the ECM-side module or work with raw files directly. The cloud or AI side would be for interpretation, not for capturing the event. The truck may have no connection when the issue happens, so the evidence has to be saved locally first. After that, cloud processing could help decode the data, compare it against baselines, and generate a readable report. For the first version, I would keep the automatic triggers conservative and objective: driver event marker bus-off error passive voltage drop / brownout device reset FIFO or queue overflow a normally periodic message disappearing side-to-side communication mismatch, if the topology supports that For “learning normal,” I agree with your point, but I would not want to overclaim it as automatic root-cause diagnosis at first. A realistic first step would be learned baseline comparison for that specific vehicle and operating condition. For example, a value would only be compared against similar conditions: RPM range load / MAP throttle position gear / vehicle speed coolant and oil temperature battery voltage AFM/DFM state, if decoded and validated Then the report could flag things like: this periodic message disappeared compared with its normal timing this value deviated from this vehicle’s normal range under similar conditions the same abnormal pattern repeated after the same type of event the anomaly occurred together with voltage, oil-pressure, misfire, or communication changes But I would still call that “abnormal pattern detected,” not “replace this part,” unless there is enough validated repair data behind it. So the intended product would not be “here is a huge log.” It would need to be an event package: what triggered the capture how much pre/post data was preserved what changed before and after the event whether the device itself reset, overflowed, or saw a bus error selected graphs around the event raw data only as supporting evidence From your perspective, what would make this kind of report useful instead of just another datalog? For example: What are the top 5 parameters or events you would want highlighted first? Would you trust a learned baseline for that specific vehicle, or would you prefer fixed thresholds? How much false-positive flagging would be acceptable before you stopped looking at the reports? What would a one-page report need to show for an independent shop to take it seriously? For misfire, AFM/DFM, oil pressure, or U-code complaints, what would you want the tool to flag automatically?
    • 2024 Silverado 2500 HD LTZ grille no camera Parts list   84603331 84913656 84913657 84913654 84913655 84911567 84911568 85646092 85646093 85797921 85797922   11570637  x10-15   grille/bumper bolts 11546500  x10      grille clips 11571006  x10      push/retainer clips 11546454  x6       nut retainers 11611609  x6       M5 bolts 11610700  x6       molding/trim retainers
    • And use RA's 5% discount code if you buy from them.  google for the code, one is always available.
    • Just don't turn the steering wheel as much?
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...