Jump to content

Recommended Posts

  • 3 weeks later...
Posted (edited)
On 11/8/2021 at 7:49 PM, HotChiliRam said:

Specs??

 

- 2020 High Country 3.0 Duramax

- 6" BDS lift kit 1803H

- 22" x 10" -18 offset Fuel Blitz

- 35" x 12.5" Nitto Ridge Grapplers

- Bilstein 5100's

- EGR flares

- Hypertech inline calibrator

- Bak Revolver X4s

- Weigh Safe hitch 10" drop

 

Edited by Bgill
Posted (edited)

2020 Silverado 1500 5.3 WT 4x4 

 

Snowflake 24X10 +27

Crosswind M/T Mud 37X13.5X24

8 inch ReadyLIFT

No spacers

No rubbing

No trimming

 

truckDT.png

Edited by Lycan LLC
  • Like 3
  • 3 weeks later...
Posted
On 7/15/2019 at 1:27 PM, bamulk said:

Method NV 305 18x9 -12 Offset
Cooper Discoverer S/T Maxx 295/70/18
1.5 Level (Trailboss)
Slight Rub on mudflap on full lock. 

 

IMG_20190713_105657.thumb.jpg.095fd2dcdced67e4bb0eaf6088900032.jpg

This is the exact same setup I've been looking at except the Method 705 with +18 offset.  I'm thinking it won't rub at all as it only kicks the tire outboard 3/4"

Posted (edited)

17x8.5 Method 305 with 0 offset

37x12.5 Toyo RT

Dirt King long travel kit and fiberwerx fenders+bedsides

No rubbing after minor fiberglass trimming near the firewall

20210515_145853.jpg

Edited by Peter S
  • Like 4
Posted
On 9/26/2021 at 7:52 PM, Rich Roche said:

Stock wheels. 35/11.5/R20 Toyo Open Country AT3. 4” Ready Lift. No Rub. 

7E187F52-C287-4142-9C27-FC631A7B81BC.jpeg

F912967F-FA5C-4CC9-8F6F-6BB5D8F0CF62.jpeg

How does this lift hold up? Any issues I have it and mine creaks in the back. (Sorry if not asked in the correct area, just so much information and most of these are trail bosses not LT’s)

  • Like 1
Posted
On 10/21/2021 at 10:42 PM, HK_Crew said:

Method Race Wheels MR317 in 17x8.5 - 0 offset and 305/70/17 Nitto Ridge Grapplers

2DC8A02F-3DFF-4986-845B-8A8D7F584BFB.JPG

C4A9CC55-146C-4B92-9DA0-836891719A56.JPG

Looks great. What lift are you running?

Posted
On 9/1/2021 at 5:26 PM, Ithan Henry said:

Fuel Block 17x9 -12 offset with Falken Wildpeak MTs 35x12.5 all on the stock Trailboss suspension. Had to remove the front mud flap brackets and zip tie the liner back but that was expected. No rubbing going forward, just a slight rub at full lock in reverse. Got this setup about 2 years earlier than expected. Found the set of 5 tires and rims, brand new, for about the price of 3 on Facebook. Had to jump at that deal. 

20210901_155143.jpg

20210901_154814.jpg

Good looking truck!

What front bumper is that?

Posted
On 9/11/2021 at 5:06 PM, johnsills1 said:

20X10 Fuel Tech Anthracite with 305/55/R20 Nitto Ridge Grapplers…..

 

I am having a 4” lift installed on Friday due to rubbing issues and I don’t like the idea of cutting anything to make it work.

 

D4FA744C-BE22-412E-8FCE-BB72828A9D06.jpeg

2765A591-D7DE-40C6-9447-9E211467D102.jpeg

Good looking ride!  

What bumper is that?  Its rare to see one that blends in so well with the front end geometrical shapes.

Posted (edited)

Looking to replace the stock rims and tires on my 2020 GMC AT4.  Looks like a lot of people are running 18X9 with -12" offset on 35X12.5X18.  Does this sound correct and will it rub with the stock suspension?

 

Thanks

Colton

Edited by cjkiefer
Posted
9 hours ago, cjkiefer said:

Looking to replace the stock rims and tires on my 2020 GMC AT4.  Looks like a lot of people are running 18X9 with -12" offset on 35X12.5X18.  Does this sound correct and will it rub with the stock suspension?

 

Thanks

Colton

It'll possibly rub slightly towards the firewall at full lock. Removing the bracket behind the mudflap will clear up some more space. Pretty much guaranteed to rub while at full bump and turning. If you stay mostly on the streets it won't be much of an issue though.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Can someone tell me where the video processing module is in a 2023 Silverado? I'm getting conflicting results that it's in the front passenger area or the rear passenger area behind the seat.
    • Yes I agree, its what amounts to free advertising to let people know about his UOA testing company, and not that there is anything wrong with that but certainly that is a motivator for putting out videos about the science of oil as well as other topics such as oil and air filtration etc. The interesting part I found with his last video is not only the physics behind the reason for the varying wear due to a diesels working torque range causing more bearing load and that higher viscosity oil is of benefit, it was also that the chemistry behind the GM Dexos 0W-20 and the Mobil Dexos licensed 0W-20 are far enough apart that its showing up with a difference in wear even though the two oils are matched in viscosity and in that comparison viscosity was not having the finger pointed at it.    There are a few youtubers out there or one anyway that I have watched a bit of who has gone through the pains of accessing various countries manuals for a certain engine platform and while in the US/Canada it may say use 0W-20 or what have you for some Toyota product, in some other countries it sings a very different tune for the very same engine with the typical traditional oil viscosity/ambient temperature charts to help choose which oil viscosity is correct for the conditions the vehicle will be used in and in some cases its taken an engine in a US manual that states only use 0W-20 as per warranty coverage and yet that same engine in certain other countries may have up to a 15W-40 etc oil option that meets the spec. Another words the guy who is driving through Death Valley or Phoenix and south weather at 120f is often being fed a line of bs by the US system that has forced vehicle companies to restrict the warranty to a specific low viscosity oil for anterior reasons as well as the long drain interval suggestions.    Thankfully youtube is free ( yet anyway ) for viewers to sift through information and of course comes with the good and the bad ( truth and lies ) and we can choose to turn off/not watch what a person finds is bs or just not interested in the topic.         
    • No doubt... But, as someone who doesn't pay for his services, but who has provided a few views/clicks on his Youtube platform, the data around the Mobil oil testing I think does have some value including to "freeloaders" like me.   A lot of what he's doing is likely showing the OE's work in their oil selection, something that many of us had kind of assumed was true all along, a good balance of both excellent protection and efficiency.
    • Lake Speed is drumming up business for his company just by being in the spot-light so he has a vested interest in stoking the 0W-20 fire.  IMO  
    • I knew when I bought my truck that it had off road hill decent or craw control or whatever they call it and rolled my eyes at that but it gets throw on with other options my truck has, I just never had a heads up if the highway speed regular cruise setting had anything to do with the brakes and that took me by surprise. If you've ever been to the top of Pikes Peak and watched those ahead of you on the way down with their brake lights on constantly, one can guess they are probably not gearing down or not enough anyway if their vehicle will allow and a good reason their is a brake check spot part way down where they use an infra red heat gun to check how hot ones brakes are front and rear.    Your right that once one gets out of the front range by Denver and I've not been on that stretch of 285 between Denver and Fairplay myself but I know its high and Fairplay at 10000 feet, Buena Vista at 8000, it drops a bit from there but then your going back up and over the 11000 pass and Durango is at 6500 . So yes your definitely right that 6500 and a lot higher is the theme of going anywhere out in that direction from Denver but hey, the down hill sections give fantastic fuel mileage !.    I don't even look at the fuel pumps for what premium costs here, since I live on a farm and up to this point get fuel delivered I am rarely in front of a fuel pump and when I am, I am often using card lock bulk fuel stations so it tells me what the price is AFTER I buy the fuel. Looking up on gas buddy and converting to US gallons but in Canadian dollars, regular on average of the prices listed was around 5.95 and premium is around 7.00 . That was one reason I did not go for the 6.2 half ton aside from its lack of carrying/towing if one was going by the rule of using premium fuel and until recently one could only buy regular farm gas if playing the few cents off game for farm dyed fuel for a "farm licensed pickup". But yes I hear you on the fuel price difference and like the diesel theme with it often being more expensive then gas it doesn't have quite the charm to it either as it once did although right now here for some reason the price of diesel has come down more so its now inline with the price of regular gas. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...