Jump to content

Recommended Posts

Posted
46 minutes ago, 48548 said:

I need piss breaks.....

Sent from my SM-N975U using Tapatalk
 

Me too. It's an old man thing. ?  On a 26 gallon tank I can go 560 miles standing on my head. 700 if I baby it some and run it down to 2 gallons of reserve (pump cooling).  

Posted
Me too. It's an old man thing. [emoji6]  On a 26 gallon tank I can go 560 miles standing on my head. 700 if I baby it some and run it down to 2 gallons of reserve (pump cooling).  
Stopping to pee is one thing. I can do that anywhere.

Wiggling the truck and trailer into a crowded gas station that may or may not have decent fuel is another thing. And it sucks.

The bigger the tank, the more likely you can drop the trailer and fuel up once you get there. Or at least have more choice in where you fuel on the way.

Sent from my SM-G960U using Tapatalk

  • Like 2
Posted

I have a 2012 dmax the 36 gallon has been fine for me. I also have a short bed.

Sent from my SM-N975U using Tapatalk

Posted
2 hours ago, kstruckcountry said:

Stopping to pee is one thing. I can do that anywhere.

Wiggling the truck and trailer into a crowded gas station that may or may not have decent fuel is another thing. And it sucks.

The bigger the tank, the more likely you can drop the trailer and fuel up once you get there. Or at least have more choice in where you fuel on the way.

Sent from my SM-G960U using Tapatalk
 

Good points all.

 

Dad made himself ancillary tanks for his 75 Ford Camper Special when I was a sprout. 1,000 mile range hauling the slide it. Two 50 gallon tanks under the box and the 20 something behind the seat. 

 

I guess I should have prefaced my remarks with "in my case'....

Posted
Good points all.
 
Dad made himself ancillary tanks for his 75 Ford Camper Special when I was a sprout. 1,000 mile range hauling the slide it. Two 50 gallon tanks under the box and the 20 something behind the seat. 
 
I guess I should have prefaced my remarks with "in my case'....
I have seen a few pickups recently with "shortbed" campers in a longbed with transfer tank in front.

It is interesting that the camper specials manufacturers used to make haven't really been reincarnated.

Sent from my SM-G960U using Tapatalk

  • Like 2
  • 3 weeks later...
Posted

If one manufacturer does not have what I need then I go to another manufacturer. I have owned trucks from Willys, Dodge, Ford, Chevy, and Toyota, depending on what I needed at the time and what was available.

 

Last month I sold my 2500 with the diesel engine and the 36 gallon fuel tank. I plan to buy a 1500 pickup with a gas engine. My first three vehicles were Willys and with their small gas tank any backcountry travel meant bolting on a couple of 5 gallon jerry cans. Go out into the deserts or the forests and there are no gas stations around and you need to take enough gas to get out and to get back. And crawling along on trails the miles per gallon is going to be worse than city miles per gallon with any truck.

 

In terms of gas tank capacity I can go with GM and have a 24 gallon tank or with Ram and have a 33 gallon gas tank or Ford and get a 36 gallon gas tank or with Toyota and get a 38 gallon gas tank. With a diesel engine I could replace the factory tank with one from Titan but this is not an option with a gas engine. For me the GM 1500 pickups are off the list and my next pickup is going to be from Ram or Toyota. Ram also provides an electronic locking rear differential which is icing on the cake.

Posted
If one manufacturer does not have what I need then I go to another manufacturer. I have owned trucks from Willys, Dodge, Ford, Chevy, and Toyota, depending on what I needed at the time and what was available.
 
Last month I sold my 2500 with the diesel engine and the 36 gallon fuel tank. I plan to buy a 1500 pickup with a gas engine. My first three vehicles were Willys and with their small gas tank any backcountry travel meant bolting on a couple of 5 gallon jerry cans. Go out into the deserts or the forests and there are no gas stations around and you need to take enough gas to get out and to get back. And crawling along on trails the miles per gallon is going to be worse than city miles per gallon with any truck.
 
In terms of gas tank capacity I can go with GM and have a 24 gallon tank or with Ram and have a 33 gallon gas tank or Ford and get a 36 gallon gas tank or with Toyota and get a 38 gallon gas tank. With a diesel engine I could replace the factory tank with one from Titan but this is not an option with a gas engine. For me the GM 1500 pickups are off the list and my next pickup is going to be from Ram or Toyota. Ram also provides an electronic locking rear differential which is icing on the cake.
You will like it.... i hate my wifes 2015 grand Cherokee.... more recalls then I have had on all the rest of my vehicles added up in my life. Ecodiesel. Hell, fca can't even make their own trannys... but that is a good thing they went to zf.... my 2012 dmax odo... might have to go. The engine might be broken in.... that was a joke....7c8650d05403bf7dfc38d5f16ddcc22b.jpg

Sent from my SM-N975U using Tapatalk

  • 2 months later...
Posted

I have a 6.2l.  Requires premium gas.  I tow 5k lb trailer for recreation, winter driving.  On the route I travel, nearly 1K miles of it is regular unleaded at the pump.  It is very rural.  No freeways, no exits, no fringe.  This means I have to carry a lot of gas cans or risk damage to the 6.2.  26 gallon tank is pathetically inadequate imo.  Bed tanks aren't legal for gas as far as I know, although I cannot see how five or more jerry cans of gas in the bed is somehow safer.  

Posted

It does not "require" premium but it is suggested to do so for best performance.  You are just fine running 87/89 for awhile.  It will not damage the engine.  Even when towing. 

Posted

Wrong wrong wrong.  :P 

GM recommends using 93 octane gasoline for its top-of-the-line 6.2-liter V-8-equipped trucks. The owner’s manual does state as low as 87 octane is acceptable for the engine. However, to achieve maximum performance and fuel economy you must use 93.

 

So with that being said- you can get by fine for a few tanks of 87.  Won't have the same performance as you would running 91 or 93 but go ahead and do it if 91/93 is not available.  (91 above 3500-4000ft is essentially the same as 93 at sea level)

 

https://pickuptrucktalk.com/2020/10/misleading-these-trucks-recommend-or-require-premium-fuel/

 

So SHUT UP and drive. 

Posted

I’m wondering.[emoji2957] What’s better a 6.2 on regular gas or a 5.3 on reg gas? Or... 5.3 a tune and high octane gas. Or the 6.2? There seems to be more deals on trucks with 5.3s. Bragging rights or saving money with close to the same results. I’m asking for a friend.


Sent from my iPhone using Tapatalk

Posted

Alright.  kidding aside and what not from my previous post- Direct Injection engines will generally provide better performance and even fuel economy with the higher octane fuel like 91/93.  Why?  Well.. I'll refer you to a good article that explains it better then I can.  From that article:
Raising the octane rating (also known as the anti-knock index) doesn't change the energy content of a gallon of gasoline. A higher octane rating indicates greater resistance to knock, the early combustion of the fuel-air mixture that causes cylinder pressure to spike. When higher-octane fuel is flowing through its injectors, the engine controller can take advantage of the elevated knock threshold and dial in more aggressive timing and higher boost pressures to improve performance.

Source:  https://www.caranddriver.com/features/a28565486/honda-cr-v-vs-bmw-m5-ford-f-150-dodge-charger/

 

So.  With that being said, at least for 2019 and older 6.2L direct Injection engines- what i posted in a previous post about it being recommended but NOT REQUIRED holds true.  That is straight from the owners manual.  I don't know if that has changed for the 2020 models but the way I understand it is that they are essentially the same engine as 2019.  So decide for yourself.  But in a pinch?  Yes, you can get by running 89/87 and even 85 up here in the mile high city, for awhile without causing damage.  The computers are able to adjust the timing and what not to compensate to keep it running. 

Posted
18 hours ago, Colossus said:

Wrong wrong wrong.  :P 

GM recommends using 93 octane gasoline for its top-of-the-line 6.2-liter V-8-equipped trucks. The owner’s manual does state as low as 87 octane is acceptable for the engine. However, to achieve maximum performance and fuel economy you must use 93.

 

So with that being said- you can get by fine for a few tanks of 87.  Won't have the same performance as you would running 91 or 93 but go ahead and do it if 91/93 is not available.  (91 above 3500-4000ft is essentially the same as 93 at sea level)

 

https://pickuptrucktalk.com/2020/10/misleading-these-trucks-recommend-or-require-premium-fuel/

 

So SHUT UP and drive. 

Put whatever you wish in your outfit.  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • 2017 Silverado L83 5.3l 6speed transmission Hello, not a new member but havent posted in a while and my old signup info isnt working so had to create a new account. anyways, I have an issue with my truck and hope someone can spread some light on whats happening: -when it goes to 4cyl mode it makes a clunk sound (but not when coasting or going downhill) -when in 4 cyl mode and under load it makes a load pulsating sound (not a tick). -goes away completely when in M5 gear or when plugging in an AFM delete. Im guessing it is one of 2 things but im not convinced of either to be honest. 1. lifter stuck in v8 mode 2. torque converter shudder realistically it doesn't seem like the TC as there is no physical vibration , and it never happens in v8 mode. but maybe? and wouldnt a lifter make a sound whether with load or not? any ideas let me know please. thank you!  
    • Which has made me wonder with the various engine failures of a few brands in the last few years, is it sub par materials such as lifters etc causing failures, or bearing clearances on the crank etc or perhaps bad designing of an engine physically or causing too much load on the components due to the hp/torque they can push out of them. Or is the oil viscosity and additive package of current oils or a lack of oil flow by an oil pump not able to supply sufficient oil at idle or under high load at low rpm. Or is it every item I listed that combined together has pushed the limits so far to the left that there is hardly a margin of safety left and add in some fuel dilution and too long of an OCI and premature engine failure is the result ?. 
    • He is not saying that an SAE *W20 will have more viscosity than a *W40 due to MORE VII polymers. He is saying that although multiple *W40 may post in the PDS the same or similar 100 C and 150 C viscosities that the blenders choice of modifier TYPE and AMOUNT to get his chosen base to grade will not give identical real world viscosities in shear and at temperature. All will pass the SII test but not all will pass the 100 C HTHS (unpublished value) testing the blender does and relies on to get the required by law "percentage improvement' referenced to his last great work.    Tis the problem with the lie. Once told others are required to support it. 
    • I have a `25, 1500 that auto sets on incline. Never knew that at first. I have the electronic shifter. Just think if it didn`t do that? Unlike a mechanical shift that you can muscle out of park, how would you get this thing out? That would be a problem.   What I found out later is, I don`t have to push the button to release. Just put it in gear.   Setting parameters? Don`t know if it`s possible.
    • 2023 GMC 3500 HD, SLE, 6.6L Gas, 4x4, 6 Spd Options:  SLE Convenience Package; Driver Alert Package 1; Spray on Bedliner; X31 Off Road Package; TRAILERING MIRRORS, HEATED POWER -ADJUSTABLE, AUTO DIMMING, WITH TURN INDICATORS WHEELHOUSE LINERS, REAR INC. REAR AXLE - 3.73 RATIO INC. GVWR, 11,350 LBS. (5148 KG) INC. FRONT AND REAR PARK ASSIST, INC. ULTRASONIC     I have been launching my new boat and noticed some things related to the parking brake.. I usually set the parking brake (habit) when on flat ground for typical driving.    When backed down on the launch ramp to launch the boat and I place gear selector into Park, the parking brake activates automatically. My second nature is to set parking brake manually and noticed I was turing the parking brake off.  The parking brake appears to be setting itself automatically.   I looked all over my owner's manual and only found references to being on an incline and manually setting parking brake, or at times parking brake will be auto engaged, but nothing specific to my situation.    When is the parking brake automatically engaged?  Under what specific circumstances?  Can the auto set parameters be changed?     I like the auto set feature.  It would be nice if always engaged when shifted into Park and released when shifted out of Park (like my wifes 2025 RAV4).   Thanks!    
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...