Jump to content

Recommended Posts

Posted (edited)

New to the site, have a 2021 2500hd  with 6.6 gas. Yesterday was turning around in my driveway and heard a bang, then check engine light,  trac light,  reduced engine power,  service parking brake  lights all came on. I can run through the gear shift, but it won't engage any gears. When I have it in r or d if I touch the gas it revs up and speedo keeps going up. Looked at shift linkage and it does move, so I'm guessing a serious internal trans issue?? Anyone else have an issue like this? Thank you , 

Update, just pulled code p215b , output shaft speed correlation 

Edited by Daler442
Posted

Sounds like a transfer case issue.  May have somehow become engaged in 4wd before or during the turning maneuver.

Posted

It was in 4wd already,  had been for 30 to 40 minutes.  Wasn't horsing it. I let it shift to drive, was taking it easy. Just don't get it

Posted

Sounds like it will need to go to the dealer.   I'd discuss the details with your service advisor.  She/He may be able to shed more light on the issue.

Posted

I agree. Sounds like you broke something in the 4wd system rather than the transmission due to making repeated tight turns in 4wd in a high tire traction condition. Unfortunately it’s not really built for that. 

  • 1 year later...
Posted
20 hours ago, Chade85 said:

What was the issue? Was it covered under warranty?

The OP hasn’t visited the site since March of 2022. If you quote him and re-ask the question he should get an email that you quoted him. 

  • 3 months later...
Posted
On 3/13/2022 at 11:16 AM, Daler442 said:

New to the site, have a 2021 2500hd  with 6.6 gas. Yesterday was turning around in my driveway and heard a bang, then check engine light,  trac light,  reduced engine power,  service parking brake  lights all came on. I can run through the gear shift, but it won't engage any gears. When I have it in r or d if I touch the gas it revs up and speedo keeps going up. Looked at shift linkage and it does move, so I'm guessing a serious internal trans issue?? Anyone else have an issue like this? Thank you , 

Update, just pulled code p215b , output shaft speed correlation  ---- was it the trans mine did samething in 2 wheel drive . thanks

 

  • 1 month later...
Posted

I have a 2020 Silverado 2500 HD with the same problem, heard a clunking sound, trac control light came in, park brake light, won't move forward or backwards, show p215b code, revs up when put in drive or reverse, anyone have this happen and what was the problem, how do I repair it?

Posted
On 3/5/2024 at 3:08 PM, Mike Heminger said:

I have a 2020 Silverado 2500 HD with the same problem, heard a clunking sound, trac control light came in, park brake light, won't move forward or backwards, show p215b code, revs up when put in drive or reverse, anyone have this happen and what was the problem, how do I repair it?

Were you also in 4wd on dry pavement like the op? Something gave out in the transfer case is my bet

  • 4 weeks later...
Posted

Just got my 2021 Chevy 2500HD out of the dealership for this problem.  Snapped the transmission output shaft off.  Right where GM welded the speed sensor ring to output shaft.  Service advisor has seen several of these come in, breaks right at the weld.  Fortunately it was covered under extended warranty as the replacement transmission, labor, new cooler lines, and a couple minor other things was just shy of $9k repair bill.  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Your tire pressure issue may just be batteries, you can reset them using tge Ing switch (I think) and the owner's  manual. ChatGTP will b e a faster, better help than Google.
    • The thinking is that starting out in a higher gear makes it easier to avoid applying excessive torque when pressing the gas pedal. In a modern 4wd truck with 4 low and a limited slip or locking rear end, I would use 4 low and try to crawl up the ramp. Sometimes if they are too slippery, you have to back up to let the boat have some bouyancy, and then accelerate briskly to get some momentum to help you pull the through the slippery parts. 
    • I have a Retrax pro that I first had on my 2020 chevy and transferred it to my current GMC.  It stays in the garage most of the time, so hard for me to judge it's long term weather resistance.  It still works perfectly, been very durable.  It doesn't see oil patch usage, but it's not a mall queen.  It keeps most things mostly dry (small leaks) and the security of it is enough to slow someone down but not keep them out for long.  I would buy one again, it works for me.     
    • Thanks to the convenience of Amazon, I was able to get a few things done to the truck today.  I installed Carquest Premium oil and air filters with five quarts of Mobil1 High Mileage 10-30 along with a quart of Pennzoil Platinum 5w-30 I already had.  The latch for the flip up center console lid was broken so I replaced it along with the power mirror switch.  I found my push retainer assortment this morning and reattached the plastic under the bumper and it was only held on with a few screws and retainers.  Then I programmed a new remote keyless entry fob so I can lock my dog in the truck when I take her out with me (I've got to keep the air going for her since it's been in the 100s).  Finally, I ordered some LED interior bulbs and replaced the reading lamps.  The front lights are working fine while one of the back lights only works intermittently and the other not at all.   While under the truck, I found the source of at least one of the noises: the sway bar links need replacing.  I ordered a set of Suspension Dudes links with Code Red bushings.  Never heard of them, but they're made in the USA and have decent reviews.  While making yet another Amazon order, I went ahead and added a set of front tow hooks.  I went with red, since that's the color of the sway bar link and bushings and it should look decent enough on a black and chrome truck.  Speaking of which, it doesn't bug me much, but the passenger side mirror has a chrome cap while the driver side doesn't, so eventually I'll make them match one way or another.  Oh, and I ordered a $20 TPMS reset tool.  No idea if it will do anything for my sensors but it was cheap and will work for the Ford Transit Connect as well.     For tradition's sake, I ordered a new oil change wrench.  I kept the Snap-On 9/16"x15mm GM wrench I bought when I was 18 in the 2006 GMC from the time I bought that truck until the truck was lost.  While I was tempted, there's no need to spend $80 for a new SO wrench, or even $50 with shipping for a used one on Ebay.  I just bought a Duratech 15mm extra-long ratcheting wrench to do the job as needed.  It works, and if I like that wrench enough, I'll buy the set.  
    • The recall is for exactly this issue - those drain holes combined with the limited environmental capability of the tailgate electronics card inside the tailgate were a problem. The “safety issue” was the potential for the tailgate to spontaneously open, but all kinds of tailgate misbehavior can occur from water contamination of that control card.    There is no real fix yet. The initial recall just disabled the tailgate. Later, when parts became available, they would replace bad parts with new parts of the same bad design. My dealer is going nuts because the few times I let them get their hands on my truck, my tailgate is off due to a slide-in camper installation. They really want to cut my tailgate wires, but I won’t give them the chance. I will let them get their dirty hands on it when a real fix (redesign) is available.  My tailgate, which works just fine with sealant plugging the drain holes, will remain safe in a dry storage crate until then.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...