Jump to content

What did you do with your truck/shop today

SarahsGMC

By SarahsGMC
in The Off-Topic Bar

 Share

Recommended Posts

Mckenzie Senior Enthusiast

Mckenzie

Posted
Posted
throwing together some ideas and crunching some numbers while i was bored sitting in my forest policy today and im really thinking im going to be able to have the trucks on some 37x13.5 inch mud grapps over summer!

I thought you were gettin some LT headers?

I was and still am but I'm going to wait untill I can get an in person BB tune shortly after the LT header install because the truck is going to be nothing but pipe after the headers no X pipe or nothing and I want to have the tune done to make it run good. Should have the money this summer to do both !

 

 

Sent from my smartass iPhone using Tapatalk

  • Replies 16.9k
  • Created
  • Last Reply

Top Posters In This Topic

  • Chris

    2024

  • RyanbabZ71

    1417

  • Jsdirt

    1327

  • SarahsGMC

    1181

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

C25A1guy
C25A1guy

Took my wife to labor & delivery. Daughter born.

Chris
Chris

I drove across town to pick up my degree since im still waiting on parts

srwoolc
srwoolc

Took my truck into the back country of Colorado.     Sent from my SAMSUNG-SM-G930A using Tapatalk

Posted Images

timmyleejohnson Enthusiast

timmyleejohnson

Posted
Posted

I took apart the back end of my suburban due to an old water leak and I couldnt for the life of me get rid of the smell. So I pulled up everything, treated the floor for very minor surface rust, removed and cleaned the carpet and laid down lots of baking soda. Its all back together, not too pic heavy because I was trying to get it done in one shot.

 

image-2.jpg

 

 

Some of the panels that came off, the huge wheel well panels were outside drying in the sun after being hosed down.

 

image-1.jpg

KMGZ400 Senior Enthusiast

KMGZ400

Posted
Posted

I took apart the back end of my suburban due to an old water leak and I couldnt for the life of me get rid of the smell. So I pulled up everything, treated the floor for very minor surface rust, removed and cleaned the carpet and laid down lots of baking soda. Its all back together, not too pic heavy because I was trying to get it done in one shot.

 

image-2.jpg

 

 

Some of the panels that came off, the huge wheel well panels were outside drying in the sun after being hosed down.

 

image-1.jpg

 

screw that carpet, i would rhino line it

zach1990 Senior Enthusiast

zach1990

Posted
Posted
Grille and bow tie plasti dipped. I really like the look. Yes, the bumper is dirty.

Nice bumper now zoom out an change angles so we can see the mods :lol:

 

 

Sent from my iPhone using Tapatalk

kstruckcountry Senior Enthusiast

kstruckcountry

Posted
Posted (edited)

That's the only thing I've changed recently. I'll put up another when I do dat tire rotation. :lol:

You really can't see the grille much, which is what I was going for.

Edited by kstruckcountry
  • Like 1
Chris Senior Enthusiast

Chris

Posted
Posted

I installed my new parking lights with an amber bulb for a DRL

4e4yjahe.jpg

 

 

Sent from my Samsung Galaxy S4 using Tapatalk Pro

  • Like 1
LongrangeLauber Senior Enthusiast

LongrangeLauber

Posted
Posted

Since my truck is lifted I think the DRL's look badass when I see them in the reflection of the car in front of me, especially when they are basically on their back window lol

  • Like 1
Chris Senior Enthusiast

Chris

Posted
Posted

sabajeqa.jpg

 

Sent from my Samsung Galaxy S4 using Tapatalk Pro

kstruckcountry Senior Enthusiast

kstruckcountry

Posted
Posted

Since my truck is lifted I think the DRL's look badass when I see them in the reflection of the car in front of me, especially when they are basically on their back window lol

I can see my double parking lights. :pimp:

Chris Senior Enthusiast

Chris

Posted
Posted

Also had to purposely fail a smog test because the DMV won't grant an extension without a fail. Damn waste of money. Got a new cat. Ready to pass but it needs new knock sensors still

 

Sent from my Samsung Galaxy S4 using Tapatalk Pro

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...