My denali

[burnerET]

So Im going to have my Black Bear tune done tomorrow, and I just realized I haven't really shown any of the other stuff Ive done to my truck. This tune has me excited, so heres somethings Ive done so far. I replaced the fogs with Rigid DOT Fogs and brackets, the headlights with morimoto sierra spec kit. Wired floorboard lighting for the front and back seats with XK Glow LED. This weekend I just installed the Bakflip VP bed cover and a BEDRUG Mat inside. Id like to install some AMP Steps next. Overall been really pleased with this truck minus a few little things here and there. Sorry I know its a little pic heavy

 

 

 

 

 

 

 

[galliher_nc]

Looks good. Your truck a 5.3L or 6.2L?

[Tattooo]

Looks great !

[burnerET]

its a 5.3

[SouthpawHD]

Nice!

[SleeperZ71]

Very nice and a good looking rig! Good job on the mods, super clean truck

[ccdies]

nice, wished mine was a denali

[thewhitestallion]

What is the wire loom running from between the bed and cab to the inside of the bed?

 

Regardless of what it is, it is very clean looking.

[Tek74]

Nice truck.

I'm not fully understanding what I'm seeing in Pic #5

[ClemsonFan]

Looks good man. How do you like the Rigid SAE lights? Easy install? Do they match the color of the LED strips in the headlights?

[Travis Whitmore]

Those are the bed rail drains for the bakflip cover. Not sure how well they work, my cover is pretty far from being water tight.

[burnerET]

Those are the drain tubes for the cover. I took the caps to the drain holes on bed, and cut them so the tubes would go through and sit back in, to try and not look so awkward. So far its held most of the water out, washed a couple days ago and didnt notice anything, but sitting out in the rain for hours the other day, got a small amount of water. Nothing to complain about, to me. Of course this was the next day after I installed, so it hadn't really had time to sit and seal in the sun yet. I guess only time will tell. Overall, I am happy with it

[toro1966]

Any issues with the bedrug over the spray in liner? Did you have to cut it? I noticed you only have the bedrug on the bottom and not up the sides. Looks sharp!

[burnerET]

It's good. No issues with it on the spray in. It comes prefabricated to your trucks bed specs, and dual sided velcro holds it in place. Yea I wasn't really a fan of the whole bed being covered in it.