Jump to content

Recommended Posts

Posted

So i just purchased a 2018 Silverado 1500 5.3 LT with the 6 speed and 3.42 rear end. I traded in my 2015 Canyon for it. I was running a tune from Trifecta Performance and loved it. I searched but could not find anyone on here running their tune? Anyone using Trifecta Performance, love it? Hate it? Thanks 

Posted

I've never even heard of them.. majority run blackbear~ 

Posted

The 2 days it has been installed the 6.2 engine idles and runs a lot smoother with no earth shattering power increases butt dyno detected. Low throttle openings don't have the notchy surging feeling. The 8 speed shifts hold rpm a bit longer 1800-2200 and are very normal with no clunking ( I didn't really have a lot before). Haven't towed yet but higher shift points should help there also. Overall not a huge difference from engine tweaks I made with HP Tuners before so similar tweaks are in the AFM Disabled tune. Last summer the IAT's were really high and there was some knock retard going on while I was scanning. Hopefully that condition is resolved in this tune. I will do more scanning when time permits and when going on vacation towing a TT.  AFE Intake and Borla cat back are the other mods.

 

Overall the pkg makes the truck feel much more refined as it should have off the showroom floor. The difference the intake and exhaust mods made are still there.

Posted

I had a trifecta tune on my 2013 Cruze 1.4turbo that I had before the Silverado, night and day difference. Was pretty neat too I could turn the tune off by turning the cruise switch on. And performance with the cruise switch off.


Sent from my iPhone using Tapatalk

Posted

I had trifecta on my 2015 Colorado and made a huge difference. I got the Diablo for my 2016 5.3 Silverado and was nowhere near as noticeable of difference. I'm tempted to try BlackBear since they address more areas and specific to your vehicle. 

Posted
The 2 days it has been installed the 6.2 engine idles and runs a lot smoother with no earth shattering power increases butt dyno detected. Low throttle openings don't have the notchy surging feeling. The 8 speed shifts hold rpm a bit longer 1800-2200 and are very normal with no clunking ( I didn't really have a lot before). Haven't towed yet but higher shift points should help there also. Overall not a huge difference from engine tweaks I made with HP Tuners before so similar tweaks are in the AFM Disabled tune. Last summer the IAT's were really high and there was some knock retard going on while I was scanning. Hopefully that condition is resolved in this tune. I will do more scanning when time permits and when going on vacation towing a TT.  AFE Intake and Borla cat back are the other mods.
 
Overall the pkg makes the truck feel much more refined as it should have off the showroom floor. The difference the intake and exhaust mods made are still there.
I saw a post on trifecta a while ago and at the time was the only company that claimed to be able to tune the 8 speed trans without getting the TCM unlocked from HP tuners. Can you confirm this? I'm really interested in getting my 8 speed tuned because its horrible.

Sent from my SM-G950U using Tapatalk

Posted

During the tune process you can see brief ECM TCM messages in the software. other than that the trans does hold RPM's longer than it used to and shift more purposeful. IMO the tune would go well with larger tires crowd. Driving it a few more days I just had the cruise control OFF yesterday which is sport mode in the tune. To add what i said before low throttle response is smooth as butter and the engine/trans just delivers it with no shudders or vibrations. I dont doubt the trans was tuned it does behave differently. The security system that locks the TCM IMO is a lot like the software locking they had on Blue Ray DVD's or satellite receiver cards. Once the key is compromised a new lock cant easily be re added and it is only a matter of time before more learn that trick.

 

For anyone with the 8 speed issues I would say it is worth a shot. My own opinion as to why the 8 speeds are clunky I have said in other threads. The tune seems to employ the same things I found in HPTuners that helped mine not be clunky ...and the additional benefits are totally worth it to me in time i didn't have to do it myself.

Posted

UPDATE:

I mainly got the Trifecta tune hoping for a bit more torque for towing. First week I was mainly driving to work and would leave it on Eco mode with cruise control ON to see what kind of mileage it was good for. There wasn't a big difference other than super smooth running and +.5 mpg.

 

I have in sport mode with CC off mostly all week and there is noticeably more torque down low. From the moment you press the pedal she starts pulling hard and just picks up more as rpm's rise. I barked the tires a couple of times just messing around taking off from lights. The Trans shifts are still really smooth. Still happy I spent the $$$.

  • Like 2
  • Thanks 1
Posted

@Pearl2017  Which level of tune did you choose from Trifecta?  I see they have 3 levels Advantage, Advantage +, and Elite..I was already leaning towards them for our 2.0L Turbo Malibu but since it seems they got the 8 speed tranny figured out may have to get one for the 6.2 truck I have too

Posted

Advantage+ ...in trying to compare the 3 by reading I didn't see TCM tune as part of stage 1 pkg. Opted for stage 2 with speedo adjust later if needed. I also read somewhere that if later you want to upgrade you just pay the difference. Elite or stage 3 I think is for a heavy modder.

 

Pulled the ~2500lb trailer+SxS last weekend ...more of the same, loads of torque and clean shifting.

Posted
On 3/21/2018 at 7:51 PM, Rich7930 said:

So i just purchased a 2018 Silverado 1500 5.3 LT with the 6 speed and 3.42 rear end. I traded in my 2015 Canyon for it. I was running a tune from Trifecta Performance and loved it. I searched but could not find anyone on here running their tune? Anyone using Trifecta Performance, love it? Hate it? Thanks 

Rich, I'm in the same boat as you, I traded my 2015 Canyon for my 2018 Silverado. I couldn't be happier on the swap. I did have the Trifecta Elite on my Canyon and I loved it!  I have ordered the Elite for this truck too, I cannot wait to get it installed. Since my truck is currently 100% stock, I opted for the Elite again so I can get the tune modified each time I do an upgrade.

Posted

It talks about the TCM tune right under the explanation of the different AFM modes. says they can do 6 or 8 speed

  • 1 month later...
Posted

I installed the Advantage + in my 2017 6.2L.  Tranny shifts nice, but i'm seeing a 2+ mpg decrease in mileage in "Eco Mode" .  They advertise up to 2.4 MPG increase, which i wasn't expecting, but sure didn't expect to see a noticeable drop.    This is the 5th truck i've tuned -2 from Blackbear, 1 from Livernois for my ecoboost, and 1 from HP but this is the first time i've had a tune noticeably decrease mileage on a road trip when cruising at 60.  On the others I've seen a 0-1mpg increase with Blackbear doing the best. I e-mailed Trifecta for feedback but wasn't real impressed with their response. They said the MPG display is an average, yadda yadda, I explained I'm not using that display on the dash, i'm calculating based on fill ups from the same gas pump, at the same station.  Their response was " Not much we can do about your hand calculations".  That made me laugh.  Overall it's not a bad tune, but for the money i'm going back to Blackbear on my next GM tune.  I had a few bugs on a Blackbear tune several years ago and their customer service was over the top. 

Posted

Do you have a CAI or catback exhaust? I have both CAI and Borla and mileage is definitely not down unless i wanna hear the ROAR lol. Not sure why yours would be different?

 

After driving quite a bit on the tune IMO the Eco mode is not for driving in traffic. It feels just as lazy as stock and you need to push the throttle further open to take off. With ECO OFF the torque pulls right off idle and makes the truck feel lighter than it is on a lot less throttle shifting around 2k. My guess is that mode is plenty rich on fuel throwing the old emissions test @2200rpm out the window. :-)

 

On the highway in eco mode i did pick up 1+ mpg. and when i get off the fwy I turn off ECO. will be pulling a trailer cross country tomorrow in tow mode.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,980
    Total Members
    8,960
    Most Online
    Fishboat
    Newest Member
    Fishboat
    Joined
  • Who's Online   3 Members, 0 Anonymous, 481 Guests (See full list)


  • Latest Articles

  • Posts

    • Hey guys, sorry for the confusison about this. This wasn't my experainnce, it was copied and pasted fom the net. 
    • The problem with failure rates or increase failures are there’s people who don’t have a problem. What are you doing wrong they say. We had 4 5.7 GM diesel’s in the family when they came out. One was flawless. My uncle who happened to be the most abusive. Early rotary engines were known to use oil. I abused my first car so bad in six months I replaced the clutch, transmission and rear end. It didn’t use oil. My brother in law has a 2013 Tahoe and an older Yukon. The Yukon has 280K miles. The Tahoe around 175K. He runs them to about 300K. If his lifters fail before that time he would consider it a failure. My Hondas, I know people hate it when I mention them. Identical engines. One with cylinder deactivation one doesn’t have it. One shudders when the eco light goes on or off. Cylinder deactivation. But wait! According to the web. It can happen with lock up too. So now people in the know are changing the oil and transmission fluid more often. Then you read it could be a programing issue. So what do you do? There’s lots of money involved. I see three ways to deal with it. One only works if you don’t drive lots of miles. Lease, never get out of warranty. Or only buy older vehicles with a good track record. They all have bad runs. Usually when there’s a change. Even Toyota and Honda. 
    • Question @diyer2 on this line if you please. Are you saying the shudder is the system turning on and off at the frequency of the shudder? Guess I'm asking if you are saying you have seen it do this with the bi-direction scan tool in graph mode? If so have you been able to discern the 'trigger'. Something is telling to cycle rapidly.    My truck just started doing this recently. 197K on the clock. My response has been M5 anything under 55 mph. I treat it like a lugging stick shift. Gear down and let it spin a bit. Engauge M5, then tow mode and then M6 lets the trans stay in 5th but the AFM is active. Smooth like Skippy.    My thought was that as a machine ages the friction gets lower and as the system is load based, the lower friction would allow it to turn on at ever lower rpm until it reaches the lugging point. And yes I am ignorant of any minimum rpm requirement for the system. If you know that would be useful information.    As you know I run a Scan-Gauge II which allows me to watch the On/Off of the signal to the VLOM. While in the shudder mode I'm not seeing is cycle at that frequency or at all for that matter outside the triggers @newdude posted a few years back. Now is it possible that the refresh rate isn't fast enough to catch it? Maybe. It is why I asked my first question about graphing and trigging parameter.     As we have observed from members here the failure point is all over the map miles wise as you note yourself in your opening post. That by itself begs a few questions like fellows that comment on these lifters failing even after the system has been disabled. Long after. 😬   https://www.enginelabs.com/news/tech-tips-replacing-ls-active-fuel-management-lifters-with-melling/   The Gen5 lifters operate the same as the LS versions. In fact they are the same lifter.    https://www.enginelabs.com/tech-stories/sorting-out-gen-v-lt-lifter-failure-with-a-simple-valvetrain-fix/        
    • UPDATE 2: Steering wheel control backlights and control of the cluster can supposedly be achieved by adding a wire to pin 20 of the cluster and tapping it to pin 2 of the main clock spring harness. I'm going to give it a shot - will update  
    • GM Global A pickups 2019-2022 can do OTA programming for the radio.  GM VIP (GM Global B) can do OTAs for almost every module on board.  So a 2022.5 and newer pickup can do OTAs for recalls like the 2.7 fuel flow recall.  EVs get OTAs that improve one pedal driving, radio issues, HVAC issues, updated battery management software, etc.     So age of the vehicle/what GM electrical platform its on will alter what amount of updates can be pushed on OTAs.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...