Jump to content

Recommended Posts

Posted

As someone with a back that has landed me in bed for days, a diet change helped quite a bit. For some reason, I am very susceptible to inflammation. The pain was excruciating and it got better whenever I was in bed because I wasn't drinking Coke or eating candies out of the jar. Now, it's healthy food and I try to eat food that lessens inflammation such as eating more tomato sauce, more olive oil, and avoiding alcohol and sugar. And it also got rid of my psoriasis I had for over ten years too, it's also a form of inflammation.

Going to the chiropractor didn't work and I was still getting shooting pains in my back when the discs bulged and pinched the nerves. Nobody would operate on it because the discs were fine, just inflammed. I had cortisone shots and the doctor suggested a diet change which did wonders for my back. Now, I'm working on stretching it again because I was stiff for over three years!

Posted

It could be the seats, I like the seat in my 2020 but I hated the seats in my 2017 Chevy Silverado to the point I had to sell it with only 42000 miles and I took a bath. Both have lumbar and heated and cooled seats but that 2017 was brutal on my lower back. Before I bought a 2020 I rented one for a week to see. I never could figure out why that 17 hurt me like it did. So lucky buddy I know what your going threw.

Posted

I broke T12 and L1 over 15 years ago. It was bad enough that it took me out of the Marines. I don't mind the seats in my 2020 Silverado. I've had it 4 months, and already have 7,300 miles on it. Most of that came from moving from Virginia Beach, VA to San Diego, CA. We took the long route and a month. I haven't any back pain that I can remember while in this truck. My 2008 Saturn Outlook was a different story.

Sent from my SM-N960U using Tapatalk

  • 2 months later...
Posted

With two-way lumbar support it is a luck of the draw on how you fit.  My two other vehicles have 4-way lumbar support, which means I can dial the support exactly where I need it. That said, the AT4's seat's lumbar support is not ideal, but close enough for me. I've sold other cars because the 2-way lumbar support hit me to low on my spine and "hurt" more than helped.

Posted (edited)

I have been driving the heck out of my Denali and not one single back issue. Love the seats.

I had rented a Tundra and it was brutal on my back as well, took months to recover.


My Trax seats are horrible, but that stays at my cabin for quick trips to town.

The Wrangler is surprising good.

 

Edited by gregus73
  • 3 weeks later...
Posted (edited)

I would totally recommend you see a chiropractor. It will definitely solve your pain. After I had a minor car crash, I began to have severe back pains. I passed lots of medical tests, but the result was that it isn't a medical condition. Many people recommended me to see diamondchiroomaha.com. He is known to be one of the best chiropractors in the US with the best team. He was the only specialist that really listened to my issues and treated them. I would not go or choose elsewhere! I feel so much better now.

Edited by Olivoil
  • 1 year later...
Posted

I hear you on the original poster here, the gmt900 and K series seats leave a lot to be desired imo. The gmt-800 seats were basically lazy boy recliners, the seats in my 2014 are not even on the same playing field with how far a step back they were, and it's not like the k series and up trucks didn't have the interior room for them either!  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...