Jump to content

2005 GMC Sierra 1500 Electrical Issues

Jordan Walter
 Share

Recommended Posts

Jordan Walter Enthusiast

Jordan Walter

Posted
Posted

I was having electrical issues on my 2005 GMC Sierra 1500, which is at 197,000 miles. The issues were things like pulsing lights (interior and exterior and low voltage fluctuation (14.0v to 11.8v) so I replaced the alternator with a premium 160amp remanufactured one from CarQuest. Now my voltage seems high, sitting at 14.9v-15.2v during idle. The pulsing went away, but now it pulses when I rev the engine. I will leave it at about 1500 RPMs and it will steadily pulse until I release the gas. Is this an issue with the alternator or something else?

EightTrackHits Enthusiast

EightTrackHits

Posted
Posted

Is the battery light still on?  I had an alternator problem with a Trailblazer, battery light would not go off, connections were tight.  I checked continuity of all the connections to their next assembly and found that the wire carrying the pulse width modulation signal (PWM) was open.  The fault was fairly close to the connector and I fixed it with a pigtail I cut from a unit in a junkyard.

 

You mentioning pulsing also makes me wonder if it is in the PWM circuitry, but if it is, it is likely not an open PWM wire as that would cause the alternator to give max output all the time.

 

Good luck and let us know.

 

Another member had similar problem, but he never followed up with his fix: 

 

Mr. Z71 Enthusiast

Mr. Z71

Posted
Posted

Jordan... just for the heck of it run a temporary ground wire from battery negative to the truck body and see if there is any difference. I've seen this type of problem on older vehicles where the factory grounds looked good but were no longer doing the job. Won't cost you anything to try.

Jordan Walter Enthusiast

Jordan Walter

Posted
  • Author
Posted

Well after driving the truck for a couple days, the voltage seems to start out high - 14.8 to 15.2 volts, and then slowly drop after about 25 minutes down to 12.8 and hovers between 12.8 - 13.1v. If I turn on the head lights it slowly climbs back up to normal 14.3-14.5v. I read in the manual about the RVC (Regulated Voltage Control) and I'm wondering if it's just part of that?

EightTrackHits Enthusiast

EightTrackHits

Posted
Posted

Yes, the changing voltage levels that you are describing is normal, but the discernible flickering or pulsing of interior lights isn’t.  Is that still happening?

EightTrackHits Enthusiast

EightTrackHits

Posted
Posted

A good description of the charging system can be found in this post from an Avalanche club.

 

https://www.chevyavalanchefanclub.com/cafcna/index.php?threads/lights-flicker.52489/

 

Another thing that could cause the flickering is the battery.  Just because a battery is charged to 14vdc doesn’t necessarily mean that it can keep providing current under load if it is unhealthy.  Of course this could also just be some random electrical component someplace in your truck.

 

My 05 has the works, heated seats, electric fans, nice radio, and I haven’t noticed any flickering.  If you’re issue was not intermittent, and you were closer- we could just swap batteries for a bit.  If that didn’t work, you could start pulling fuses to non-essential circuits until you noticed the flickering diminish.  There is the off chance that it is in one of the control modules.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • ChristopherDobson
      Vehicle Payments

      By ChristopherDobson · Posted

      Monthly payment is only part of the equation. With today's prices and interest rates, I'd look at the total monthly cost: payment, insurance, registration, fuel, maintenance, and expected repairs. A vehicle that fits comfortably into your budget is usually the better choice than stretching for a higher trim. I've also kept my vehicles longer over the past few years. New cars have gotten expensive enough that driving one for 10+ years, while staying on top of maintenance, often ends up being the most cost-effective approach.
    • Grumpy Bear
      OCI, not when but why?

      By Grumpy Bear · Posted

      10 Ford and Chevy engines proven to reach 300,000 miles   You may note a common 3K OCI on this list of gas motors. I skipped over the diesels. Dh'O. 
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      Thanks newdude!  By the time manual selection is needed, I'm probably too much of a control-freak to depend on the transmission sensing braking to activate automatic downshifting.  I would be anticipating the situation and already be manually downshifting.   This truck replaced a 2004.5 LLY diesel with the Allison 5-speed.  Putting it in T/H made noticeable differences (when the torque converter locked, upshift points, downshift behavior).  On this 2024 gasser with the 10L1000 I haven't been able to detect much, if any, difference.  Ok, I can never tell now when the torque converter locks up.  But I also don't notice differences in shifting.  For downhills, I've probably already manually downshifted by then anyway.  Since it's also more awkward (than the 2004.5) to engage/disengage I don't even bother.  Or maybe it doesn't really matter with just a 3k lb. camper in the bed?   Thanks also for the list of reasons the charging system might select various voltages.  However, what I am seeing doesn't fall into any of those categories.  It very definitely, and very consistently, rises after coasting/braking.  Maybe not immediately, but not very long after coasting/braking.  Very consistently drops voltage when no longer coasting/braking.  It might also be interacting with the camper battery charging (I might disconnect the camper and see if it changes the charging behavior).  I also need to recheck turning on headlights for when I want to force it to charge the camper.   Another JR, in June I converted the camper to LiFePO4.  Since it's not a good idea to try to charge lithiums directly using truck, I installed a Victron Orion XS DC-DC charger (which BTW is AMAZING!!).  Being cheap, I only had to buy that one item (besides the battery, of course) to do the conversion.  The camper OEM 120v battery charger (only 19 years old and works perfectly) and the truck feed the input to the DC-DC charger (not at the same time).  But I didn't want the camper charger feeding back to the truck so I kept the old separator.  I considered replacing the separator with a 30amp diode but that means more work and might add another 1/2 volt drop.  One thing that surprised me was the voltage drop over the long 10awg wire run, so I can only charge smoothly at 8 amps (because the DC-DC charger is completely configurable).  Another reason I don't want an added voltage drop with the diode.  I might also be a little lazy but all this work is being done under the sink with a small cabinet opening.    
    • davester
      cam upgrade in CA

      By davester · Posted

      apparently CA smog is (or at least was)  checking that the vehicle is using the oem and/or a ca smog approved tune, so I expect you'll fail inspection doing it.
    • davester
      Possible lifter tick after DOD delete

      By davester · Posted

      yes, leaking exhaust will mess up o2 sensor readings, which in turn messes up fuel trims.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...