What have you done to your K2 today?

crafferty · February 2, 2016

I have the same thoughts about them "just stopping"...It appears Bushwacker has a trim piece, but I haven't been successful locating them.

sc

Sent from my iPhone using Tapatalk

3dCarbon has some fender flares coming out that do a great job of following the factory body lines.

Sent from my SM-G900P using Tapatalk

Kander41 · February 2, 2016

Got backed into in the doctor's office parking lot!

Sent from my SAMSUNG-SM-G890A using Tapatalk

Kerrslight · February 2, 2016

. Kerr what lift and tire set up you have on your all terrain?

2.5" Front level and 2.5" block in the rear. 20x10 Fuel Maverick currently wrapped in stock 275/55 Goodyear SRA

Sal9012 · February 2, 2016

truck looks bada$$ - wonder if there's a way to get those RC flares to curve in and flush down to the bumper cap so it just doesn't square off in the very front...to me it looks like they did the right thing on the back flares but the front one just stops....? maybe it's my OCD showing through...!

you and me both bro. i didn't notice when i ordered and i didn't see it until it was installed ( i wish they were like the LUND elites) plus the color matching is a bit off.

if they don't grow on me i may just replace them.

side view is not that bad

i just waiting on the Amp Research XL boards to arrive now....it never ends.....

Edited February 2, 2016 by Sal9012

crafferty · February 2, 2016

you and me both bro. i didn't notice when i ordered and i didn't see it until it was installed ( i wish they were like the LUND elites) plus the color matching is a bit off.

if they don't grow on me i may just replace them.

side view is not that bad

i just waiting on the Amp Research XL boards to arrive now....it never ends.....

The fenders not matching would drive me crazy. I had a similar problem and sold mine.

Sent from my SM-G900P using Tapatalk

Sal9012 · February 2, 2016

The fenders not matching would drive me crazy. I had a similar problem and sold mine.

Sent from my SM-G900P using Tapatalk

yup, i used the shop paint option and big mistake, should have taken it to my guy. it bother the crap out of met, plus i am not happy with the front part wither, i may just buy the bullet and order the lund ones and get it done correctly this time. money down the drain...