Jump to content

SOLD 305/45R22 Nitto Terra Grappler G2's

eppieguy

By eppieguy
in Classifieds (Buy/Sell/Trade)

Recommended Posts

eppieguy Senior Enthusiast

eppieguy

Posted
Posted

4 Barely used Nitto Terra Grappler G2’s, 12/32 tread left, brand new they have 13/32 tread, have about 6,000 miles on them, no holes, no patches, no curb rash. They still have the hairs on the sidewall! I lifted my truck and bought the same tire in a bigger size. My loss your gain. New on Discount Tire they are $1,384.00 plus tax, asking $1,050.00 for the set. I will not sell separately. Cash only, local pick up only. Located in NJ

Tire2.jpg

tire1.jpg

7ultra Enthusiast

7ultra

Posted
Posted

 Nice tires  Eppieguy.  I hope you sell them. I just bought a set of Michelin premier LTX. In the stock size of  275-50-r22.  To be mounted on my OEM 22 inch chrome wheels .  Which will be going on my HC this Saturday. Here’s a pic of the tires.

37099AF6-B9AD-44C6-A4B8-F5E992CC9955.jpeg

eppieguy Senior Enthusiast

eppieguy

Posted
  • Author
Posted

They fit without the level kit, I had them on for about 2k and then installed the level.

7ultra Enthusiast

7ultra

Posted
Posted

 That’s good to know.   And here’s a pic of the wheels. These wheels and tires was on my wife’s 08 avalanche four 18,000 miles before I pulled them off.

5A2C1F35-1E5D-430B-A8F9-D18C0B9D1463.jpeg

Fltmech Enthusiast

Fltmech

Posted
Posted
1 hour ago, eppieguy said:

They fit without the level kit, I had them on for about 2k and then installed the level.

 

1 hour ago, eppieguy said:

They fit without the level kit, I had them on for about 2k and then installed the level.

Was that with the stock wheels? I had 305- 55-20 on my 15 Sierra with stock wheels and a 2 in. Level.

 

 

 

1 hour ago, eppieguy said:

They fit without the level kit, I had them on for about 2k and then installed the level.

 

eppieguy Senior Enthusiast

eppieguy

Posted
  • Author
Posted
29 minutes ago, Fltmech said:

 

Was that with the stock wheels? I had 305- 55-20 on my 15 Sierra with stock wheels and a 2 in. Level.

 

 

 

 

Yes, with the OEM 22’s.

  • 2 weeks later...
  • 2 months later...
hotrodz37 Senior Enthusiast

hotrodz37

Posted
Posted

Eppieguy, do you have any photos of your truck with these tires on it? Thinking of going with this size on my Sierra but think they might look a hair too small with the non-round wheel openings on the GMC. Sorry this is off topic. Thanks in advance! 

Archived

This topic is now archived and is closed to further replies.

Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      2 speed transfer case optional now?

      By newdude · Posted

      This is a 1/2 ton thing ONLY.  All HDs 2020-2026 have the two speed transfer case, with Autotrac as an option.     1/2 tons 2019-2026, regular 4x4s come with a single speed case (no 4LO!), and trucks with Z71 ordered, or all Trail Boss trucks come with the 2 speed case.  2 speed case is also an option on WT, and is also standard on High Country.  
    • newdude
      Different requirements for oil filters?

      By newdude · Posted

      2013 5.3 still to this day calls for the PF48 filter.  Which as a 15psi bypass pressure.     There is a TSB, 17-NA-157 that talks about the PF-63 and PF-64 filters which have a higher bypass rating of 22psi.    TSB HERE - temp.xml   "Beginning in 2012, the oil pumps began to regulate main gallery feedback instead of pump out pressure. This means that the oil pump now does not begin to regulate until pressure is built up to the main gallery. This change reduces the amount of time it takes to provide oil to the engine bearing and lifters during extreme cold start conditions.  Main gallery feedback oil pump control systems are present on the following engine families which use Spin-on oil filters: Small Gas Engine (SGE), Large Gas Engine (LGE), High Feature (HFV6) Gen2 and Small Block Gen5 gasoline engines. These engines with the main gallery feedback oil pump control systems are factory built with an ACDelco® oil filters"   It also calls out what engines use those filters.  The gen 4 small blocks were not on that list (LMG, LC9, L9H, L92, L94, L20, L96).  Gen 5 small blocks use the higher pressure filter.          That all said...   Your 7045 Napa filter is the PF63 equivalent, with 22psi bypass.  You are already using the higher bypass pressure filter.  You CAN keep using it, you don't technically have to use it though.  
    • Grumpy Bear
      Different requirements for oil filters?

      By Grumpy Bear · Posted

      Do you know WHY the filter relief setting was increased to 22 psig?    When the new system goes into the second stage the pump volume ramps up considerably. It was found that the 15 psi filter bypass setting put the filter in bypass on a warm engine when the second stage was activated. Raising the filter bypass setting forced the filter to do what it designed to do. Filter. Preventing debris from circulating during high load, high rpm operation.    So next question is how did GM find this out? VLOM/lifter failures and a deep dive by Melling Corp.    Last question. Is it required? Look at it like this; a motor may be equipped with a rev limiter. But it only works if the set point in reached. That 22 psig setting only matters if the pressure differential across the filter media exceeds 15 psig during normal warm operation. Second stage kicks in around 3000-3500 rpm.    I can't answer your question because I don't know you and how you use the truck. But I think there is enough information here to let you decide for yourself. 😉
    • Coastie05
      give me some tips to make my truck look better

      By Coastie05 · Posted

      Go back to OEM wheels. 
    • newdude
      2020 Trailboss 6.2 replacement

      By newdude · Posted

      Probably not their first rodeo, so it should go as planned most likely.  Typically the service manager or tech doing the swap will put some seat time to shake it down after they get it all put back together.  We usually put 50-100mi before we hand them back so if something happens, its not after you get it.  A coolant leaks, oil leaks, a ground left off or loose, vibration, etc.     The new engines so far have been good?  There's been a couple that have popped out there again (the replacement engine) but most have been okay.  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...