Jump to content

Engine Hour screen on DIC

MTY55
 Share

Recommended Posts

MTY55 Enthusiast

MTY55

Posted
Posted (edited)

I've been through the owners manual, Through all the settings on the DIC setup. I'm trying to eliminate the engine hours screen thats the first thing that pops up when I get into my truck. I'd be happy with the GMC logo greeting me ,or even a blank page with the mileage. Has anyone figured out how to change this.

IMG_20200911_075453.jpg

Edited by MTY55
  • Like 1
cltsig Enthusiast

cltsig

Posted
Posted

I see arrows.  What happens if you click left or right on the steering wheel?

MTY55 Enthusiast

MTY55

Posted
  • Author
Posted
1 hour ago, cltsig said:

I see arrows.  What happens if you click left or right on the steering wheel?

Tried it don't do a thing

 

chadman Enthusiast

chadman

Posted
Posted

Go over to settings, then info page options.  From here, you can deselect engine hours. Hope this is what you were looking for.

steelcity Enthusiast

steelcity

Posted
Posted
1 hour ago, chadman said:

Go over to settings, then info page options.  From here, you can deselect engine hours. Hope this is what you were looking for.

That didn't work either. Mine were deselected. Still,  every time I open the door engine hours are displayed as pictured above.

  • Like 1
MTY55 Enthusiast

MTY55

Posted
  • Author
Posted
2 hours ago, steelcity said:

That didn't work either. Mine were deselected. Still,  every time I open the door engine hours are displayed as pictured above.

Looked there and my was unchecked too.

 

rick08 Enthusiast

rick08

Posted
Posted (edited)

What trim level displays the idle hours?

i have a ‘19 Sierra that does not.

It shows in the owners manual that it displays idle hours.

Edited by rick08
steelcity Enthusiast

steelcity

Posted
Posted (edited)
2 hours ago, rick08 said:

What trim level displays the idle hours?

i have a ‘19 Sierra that does not.

Mines a 2020 AT4

Edited by steelcity
econometrics Senior Enthusiast

econometrics

Posted
Posted
1 hour ago, OnTheReel said:

I think it’s a 2020+ thing. My 19 doesn’t either.

Yeah, 2019’s don’t. I wish mine did. A lot of my engine hours are idling. 
 

I’m also perplexed by this. It had the little arrow on the bottom corner of mine, but I’ve yet to find a way to advance the screen using any control. 

redwngr Senior Enthusiast

redwngr

Posted
Posted

Does it go away as soon as the truck goes to ACC or ON ? 

 

Does it do it if the remote start is used so truck is already running before door is opened?

 

 

Lots of vehicles will display the odometer when the door is opened and ignition OFF. 

If it reverts to operator desired screen when electrical goes to ACC or ON, I guess I don't see the harm. 

 

bamorris2 Enthusiast

bamorris2

Posted
Posted
Yeah, 2019’s don’t. I wish mine did. A lot of my engine hours are idling. 
 
I’m also perplexed by this. It had the little arrow on the bottom corner of mine, but I’ve yet to find a way to advance the screen using any control. 

I have a 2019 Sierra SLT. It has an engine hours screen that pops up every time I start the truck.
econometrics Senior Enthusiast

econometrics

Posted
Posted
3 minutes ago, bamorris2 said:


I have a 2019 Sierra SLT. It has an engine hours screen that pops up every time I start the truck.

Right. But it does not show “Idle Hours” under it, like the 2020s do. 

Booger T Enthusiast

Booger T

Posted
Posted

The engine hours and idle hours displays on my 2020 LT when the door is opened, as soon as you shut the door it goes out and a nice bow tie emblem greets you. I really don't understand what is so annoying about it.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • PBNB
      Wiring Help, Please

      By PBNB · Posted

      Looks like you have it figured out. Did you run a sensor into the rear diff housing?    What sort of diff temp swings would you see towing or not? I have wondered how hot it can get 
    • tjonesdfw
      2021 with Intermittent AC Cooling Issues

      By tjonesdfw · Posted

      Dealer just confirmed that GM is "out of AC compressors."  Not sure if all 2019 to 2026 trucks use the same compressor, but a shortage like that is hard to believe.  
    • Atlas
      Wow I'm in a pickle. (Broke down truck) and a story.

      By Atlas · Posted

      I think we're reaching the end of constant projects/work.   The water pump bolt appears to have self-sealed, as it's not leaking anymore. I'll take it, and, I'm ready should it self-unseal! I was also getting an oil leak at the front oil pan seal and timing cover and came to find a pan bolt on the corner wasn't even finger-tight. Too easy. And, it was. But, it appears tightening it has reduced a leak producing spots on the ground every time I parked, to just a weep, leaving an occasional dot on the cardboard that lives under it while parked. That's acceptable on a 30 year old engine in my book. I do hate leaks, but, replacing the pan seal is quite the job.   The rear washer line is reconnected and the sprayer works, although getting an intermittent washer fluid drip off the bottom. I think it's just residual...the reservoir filled up the channel in the rear floor and drained down into the upside-down spare tire/wheel. So there are residual puddles all over under there, will wait a few days for it to spill out and dry before I go chasing a potential leak.   The door speaker...no dice. Speaker works just fine, it's that channel in the factory amp that's gone bad. Can't win 'em all. And, whomever buys this will probably tear out the factory radio for something more modern anyway.   I put about 110 miles on it yesterday. Put a lot of wind and heat into it with some mountain driving. Still runs great. Near the top of the pass I got off on a gravel side road and put about 10 miles on with 4hi engaged. Works great.   If ya squint, she's mint! God I wish these were still in production. I can see why they're not. They're rudimentary bordering on agricultural. They began life as a pickup truck and then modern society demanded the rear be enclosed for kids and crap. They're still a pickup underneath, and that gives them lots of ride character, sway and bounce and bump steer. They're alive on the road, and, at least for purposes of nostalgia, it makes driving one a lot of fun.   The Check Engine light did come back on the pass, P0134 for the upstream O2 sensor dropping out. Putting heat into the exhaust causes it after about 10-15 seconds of increased load at higher RPM. The downstream sensor is completely mangled (someone clearly had a rough time removing it, but they didn't replace it?) so I'll just put two in it. For what, mostly to cure the CEL, I can tell the cat is damaged. It's not plugged or fractured, but it's not catalyzing. There's some guilt in not fixing it, but at a cost of $500+, the truck just won't get driven much under my watch. I dislike the smell...running the truck in the shop even with both doors open and the overhead fans blasting, I still reek of pre-cat exhaust. Sticks to clothing and everything else.   Window motor (I'm dreading this), and tires, and that should be about it. 50/50 on Starfire Solarus H/T's, or spending $20 more per tire and going with Cooper Discoverer RT's. I like the look of the RT's a lot more, but is it worth it? I've got a really good (just very old) Toyo Open Country XTX on there now and I like it.  
    • tjonesdfw
      Shift to Park Message Warranty Claim

      By tjonesdfw · Posted

      From what I've seen, they "could" sell the switch but designed the assembly such that the switch can't be readily removed and replaced without removing a plastic locating pin.  Sure appears aimed at forcing the end user to purchase a $900 shifter assembly instead of a $20 switch.  Thankfully I still have some extended warranty left...  this one has had warranty repairs almost every 5K miles from the day I bought it.  
    • ENJOYLIFE22
      Adding GM factory trailer brake controller

      By ENJOYLIFE22 · Posted

      did anyone get this figured out?

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...