Jump to content

2021 2500hd trans problem?

Daler442
 Share

Recommended Posts

Daler442 New Member

Daler442

Posted
Posted (edited)

New to the site, have a 2021 2500hd  with 6.6 gas. Yesterday was turning around in my driveway and heard a bang, then check engine light,  trac light,  reduced engine power,  service parking brake  lights all came on. I can run through the gear shift, but it won't engage any gears. When I have it in r or d if I touch the gas it revs up and speedo keeps going up. Looked at shift linkage and it does move, so I'm guessing a serious internal trans issue?? Anyone else have an issue like this? Thank you , 

Update, just pulled code p215b , output shaft speed correlation 

Edited by Daler442
sheath Enthusiast

sheath

Posted
Posted

Sounds like a transfer case issue.  May have somehow become engaged in 4wd before or during the turning maneuver.

Daler442 New Member

Daler442

Posted
  • Author
Posted

It was in 4wd already,  had been for 30 to 40 minutes.  Wasn't horsing it. I let it shift to drive, was taking it easy. Just don't get it

sheath Enthusiast

sheath

Posted
Posted

Sounds like it will need to go to the dealer.   I'd discuss the details with your service advisor.  She/He may be able to shed more light on the issue.

Another JR Senior Enthusiast

Another JR

Posted
Posted

I agree. Sounds like you broke something in the 4wd system rather than the transmission due to making repeated tight turns in 4wd in a high tire traction condition. Unfortunately it’s not really built for that. 

  • 1 year later...
Another JR Senior Enthusiast

Another JR

Posted
Posted
20 hours ago, Chade85 said:

What was the issue? Was it covered under warranty?

The OP hasn’t visited the site since March of 2022. If you quote him and re-ask the question he should get an email that you quoted him. 

  • 3 months later...
yucca New Member

yucca

Posted
Posted
On 3/13/2022 at 11:16 AM, Daler442 said:

New to the site, have a 2021 2500hd  with 6.6 gas. Yesterday was turning around in my driveway and heard a bang, then check engine light,  trac light,  reduced engine power,  service parking brake  lights all came on. I can run through the gear shift, but it won't engage any gears. When I have it in r or d if I touch the gas it revs up and speedo keeps going up. Looked at shift linkage and it does move, so I'm guessing a serious internal trans issue?? Anyone else have an issue like this? Thank you , 

Update, just pulled code p215b , output shaft speed correlation  ---- was it the trans mine did samething in 2 wheel drive . thanks

 

  • 1 month later...
Mike Heminger New Member

Mike Heminger

Posted
Posted

I have a 2020 Silverado 2500 HD with the same problem, heard a clunking sound, trac control light came in, park brake light, won't move forward or backwards, show p215b code, revs up when put in drive or reverse, anyone have this happen and what was the problem, how do I repair it?

Pryme Senior Enthusiast

Pryme

Posted
Posted
On 3/5/2024 at 3:08 PM, Mike Heminger said:

I have a 2020 Silverado 2500 HD with the same problem, heard a clunking sound, trac control light came in, park brake light, won't move forward or backwards, show p215b code, revs up when put in drive or reverse, anyone have this happen and what was the problem, how do I repair it?

Were you also in 4wd on dry pavement like the op? Something gave out in the transfer case is my bet

  • 4 weeks later...
MRanderson New Member

MRanderson

Posted
Posted

Just got my 2021 Chevy 2500HD out of the dealership for this problem.  Snapped the transmission output shaft off.  Right where GM welded the speed sensor ring to output shaft.  Service advisor has seen several of these come in, breaks right at the weld.  Fortunately it was covered under extended warranty as the replacement transmission, labor, new cooler lines, and a couple minor other things was just shy of $9k repair bill.  

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • AlVeron
      Manufactuer's Defect - Paint Failure - Cherry Red High Country 2021 Suburban

      By AlVeron · Posted

      This is NOT impact damage nor neglect. There were previous class action lawsuits because of such paint preparation st GM manufacturing plant. Not just the Cherry Red Color. This paint is applied in three processes to obtain the desired color.  The manufacturer will cover for 36 months or 36k miles only. That rust is actually corrosion because of the paint process failure. Corrosion is covered for 100,100 miles or a certain months. However their corrosion doesn't include this type. Go figure. Clearly manufacturer knew from previous paint issues. This started 3 weeks ago out of the blue.  
    • richard wysong
      Wow I'm in a pickle. (Broke down truck) and a story.

      By richard wysong · Posted

      Is it time to put a piece of tape over the CEL? 
    • davester
      2015 Silverado 3500 right rear turn indicator failure

      By davester · Posted

      consider doing electrical testing?  I would guess some power or ground wire/connection has a problem.   alldata.com has wiring diagrams, connector pinouts and diagnostic procedures you can use to find where the problem is.
    • davester
      My First Project and GMC has me stumped

      By davester · Posted

      can you tell if the reader is actually trying to get codes, and the pcm is reporting none, or is your reader just silently failing because it's not communicating with the pcm?
    • Atlas
      Wow I'm in a pickle. (Broke down truck) and a story.

      By Atlas · Posted

      Any joy with this truck seems to be short-lived.   The CEL for P0172 ("bank 1" too rich) is now "intermittent".   I'm not sure where to check, or re-check, and my energy to keep chasing problems with junk is wearing thin. The P0172 seems to set as I'm coming to a stop, completely off the throttle, when fully warm. At least, that's what it's done the 3? times it's set.   Everything appears normal on the scanner EXCEPT long term fuel trim. There's only one bank on this vehicle because it's an OBD 1.5 with only one upstream O2 sensor. At idle, it's around -16.4% and will dip to -18% occasionally at idle or off-throttle. LTFT approaches 0 when throttle is held at 2500rpm. Short term appears normal, much closer to zero all the time. The LTFT tells me the engine is running rich at idle but compensating at higher load. But, why?   The EVAP purge valve doesn't appear to be leaking/sucking fuel vapor continuously. Is it sticking just as I come to a stop and the engine is choking on fuel vapor and sets the P0172? But that doesn't explain the persistently negative LTFT. Disconnecting the purge valve doesn't seem to make any difference.   I suppose that leaves another dang issue with the fuel injector. A leaking fuel pressure regulator, a new leak in the spider, or a leaking fuel injector/poppet valve I didn't see, or a small crack in one of the spider legs.   The vacuum line leading to the fuel pressure regulator doesn't have raw fuel in it. It doesn't even smell like fuel when it's pulled off, not until you suck air through it, then you can tell it leads to a fuel component. I'd consider that normal? Nothing is signaling this is a FPR issue from the outside, at least.   The oil smells like fuel but it's not building volume. I've noticed most oil in most engines smells like fuel to some degree so it's hard to say if the smell is an issue or not. Or if the engine just still smells like fuel because the crankcase was full of it a few hundred miles ago. But it's been changed twice since that original issue of the leaking fuel line dumping fuel into the intake.   Patience is running very thin. Every win seems to be accompanied by two steps backwards, or another issue that leads to removing at least the top half of the intake manifold. Enough! LOL

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...