Jump to content

What did you do with your truck/shop today

SarahsGMC

By SarahsGMC
in The Off-Topic Bar

 Share

Recommended Posts

  • Replies 16.9k
  • Created
  • Last Reply

Top Posters In This Topic

  • Chris

    2024

  • RyanbabZ71

    1417

  • Jsdirt

    1327

  • SarahsGMC

    1181

Popular Days

Top Posters In This Topic

Popular Days

Popular Posts

C25A1guy
C25A1guy

Took my wife to labor & delivery. Daughter born.

Chris
Chris

I drove across town to pick up my degree since im still waiting on parts

srwoolc
srwoolc

Took my truck into the back country of Colorado.     Sent from my SAMSUNG-SM-G930A using Tapatalk

Posted Images

RyanbabZ71 Senior Enthusiast

RyanbabZ71

Posted
Posted

I agree.

 

If he wasnt a mod the ban hammer would have been swung lol

Chris Senior Enthusiast

Chris

Posted
Posted

 

If he wasnt a mod the ban hammer would have been swung lol

Do you want him gone? $50 and an accident could happen
  • Like 2
Conky Conky Enthusiast

Conky Conky

Posted
Posted

Looks good conky conky where are you located looks like beautiful country

Saskatchewan Canada. Nothing special out here in the prairies the mountains in BC is a really nice place.
Daryl LBZ Senior Enthusiast

Daryl LBZ

Posted
Posted (edited)

 

If he wasnt a mod the ban hammer would have been swung lol

Haha! I've been dying to see his truck since he bought it.

What did you do!?

Nothing, just curious about something.

Edited by Daryl Z71
SlavO Enthusiast

SlavO

Posted
Posted

At the dealer talked my little brother into getting this over the dc. He's finishing up the paper work b38a2e3ccd173b84cf4ff6bb3b6f8ed8.jpg

  • Like 4
Daryl LBZ Senior Enthusiast

Daryl LBZ

Posted
Posted

At the dealer talked my little brother into getting this over the dc. He's finishing up the paper work b38a2e3ccd173b84cf4ff6bb3b6f8ed8.jpg

Nice truck.
  • Like 1
Chris Senior Enthusiast

Chris

Posted
Posted

Did ny brothers fuel pump. Still have to button it up tomorrow 4784faf01c971d6dd717c5a555cb0a23.jpg

Daryl LBZ Senior Enthusiast

Daryl LBZ

Posted
Posted

Did ny brothers fuel pump. Still have to button it up tomorrow 4784faf01c971d6dd717c5a555cb0a23.jpg

That's good your hooking him up like that. I knew you were a nice guy deep down.

Chris Senior Enthusiast

Chris

Posted
Posted

That's good your hooking him up like that. I knew you were a nice guy deep down.

I made him do most the work. I instructed him and used my tools. I did spend a lot of time under it though
Daryl LBZ Senior Enthusiast

Daryl LBZ

Posted
Posted

I made him do most the work. I instructed him and used my tools. I did spend a lot of time under it though

Sound better than working on my brothers truck. He watches while I work because he'd rather play Xbox.

Chris Senior Enthusiast

Chris

Posted
Posted

Sound better than working on my brothers truck. He watches while I work because he'd rather play Xbox.

I told him if i do it, he will be my bitch and will learn the job.
  • Like 1
Daryl LBZ Senior Enthusiast

Daryl LBZ

Posted
Posted

I told him if i do it, he will be my bitch and will learn the job.

Lol! I'll have to remember that for the next time my brothers truck needs work.
99silveradoz71 Senior Enthusiast

99silveradoz71

Posted
Posted

I've got a couple more pics I need to move off the phone. We're expecting a warm day tomorrow, so if things fall into place, she'll get a wash and there'll be more photos taken.

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • newdude
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By newdude · Posted

      No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • jaszr2
      Active Grille Delete

      By jaszr2 · Posted

      Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • jake111
      Gasser Subforum Has Been Quiet - - So, Regenerative Braking and Using L10

      By jake111 · Posted

      I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
    • devonthegreat
      anyone interested in a 2002 Chevy Silverado 4x4 parts truck NYC

      By devonthegreat · Posted

      **SOLD** Please end or delete post. thank you
    • PBNB
      Tire pressure for 37s

      By PBNB · Posted

      Do you think this width might affect the chalk test with a higher pressure closer to 65psi? I think lowering the pressure makes sense to get the tread to lay flatter

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...