What offset for Fuel Hostage??

[sdsand32885]

Offset and backspacing is such a pain in the ass when you dont know much about it. Im about to have my 2011 Silverado lifted in the next wk or so and dont know which offset to get. Ill have the 6 inch basic Fabtech kit and 35 inch Toyo m/t's put on and dont know if the -12mm or the -24mm offset would look better...I want some lip to show but dont want to rub. Ill be getting the 20x10. Anyone help me out with this? Pics would help alot.

[blackout07]

Just get -24. Either way don't be surprised if they rub some.

[ruggedlife]

yeah youll be cuttin... are they both 10" wide? the -12 will keep it in more and reduce the extent of trimming

[sdsand32885]

Ya they're both 10 inches. I finally found a Silverado with the -12 and it looked really good. They had to trim quite a bit cause it was on a leveled nnbs with 33s. I'm ok with cutting some plastic or hitting it with a heat gun and pushing it in. If I get too close to metal I'll throw a body lift on it. I've seen some moto metals with -18mm on the 6 inch Fabtech and they fit fine so the I'm not worried about the -12 now. Thanks for the responses guys. You really have to get on forums and figure all this shit out. Talking to 4 wheel parts gets frustrating.

[sdsand32885]

Just get -24. Either way don't be surprised if they rub some.

 

What part of Texas you in man?

[blackout07]

4wp is trash. If you're okay with cutting, definitely go with the -24. It will look better and give a bit of a wider stance.