Jump to content

Recommended Posts

Posted

I know most people on here would see this as a blessing, but i am one of the few that actually likes the feature - i took in my RST over the weekend for its first oil change, and drove yesterday with the AC off for the first time since (live in PHX), i then noticed that the Auto Stop feature wasn't kicking in. DIdnt think much of it so this morning, another sub 95 degree morning i decided to roll with the windows down and no AC - and still the Auto Stop isn't working. Any ideas?

Posted

Yes, you can only temporarily shut it off from what I've read - and this gets reset every time the truck is shut off.

Posted

Looks like there are lots if reasons:

 

The climate control settings
require the engine to be running
to cool or heat the vehicle
interior.

The vehicle battery charge
is low.

The vehicle battery has recently
been disconnected.

Minimum vehicle speed has not
been reached since the last
Auto Stop.

The accelerator pedal is
pressed.

The engine or transmission is
not at the required operating
temperature.

The outside temperature is not
in the required operating range.

The vehicle is in any gear other
than D (Drive).

Tow/Haul Mode or other driver
modes have been selected.

The vehicle is on a steep hill or
grade.

The driver door has been
opened or the driver seat belt
has been unbuckled.

The hood has been opened.


The Auto Stop has reached the
maximum allowed time.

  • Like 1
Posted

Check to see if some bum helped themself to your new battery when it was in for the oil change.  It's been known to happen.  

  • 2 months later...
Posted

I got the same problem. I do like this feature but it stop working now.  I know it will disable when the outside temperature too low. But now Its about 35- 45f. So I wondering what is going on with my new Silverado 1500 2019 

Posted

I don't care much for it but it seems to be random. I noticed it doesn't do that a couple minutes after starting the car. Sometimes I don't drive it for weeks and notice it takes longer for the autostop to kick in. I am assuming it needs to engine to feed the battery up. It's just a guess, I don't know. I don't drive it much anymore, probably 3,000 miles a year. It is no longer used at the ranch.

  • 4 weeks later...
Posted
On 8/26/2019 at 10:53 AM, jessez24 said:

I know most people on here would see this as a blessing, but i am one of the few that actually likes the feature - i took in my RST over the weekend for its first oil change, and drove yesterday with the AC off for the first time since (live in PHX), i then noticed that the Auto Stop feature wasn't kicking in. DIdnt think much of it so this morning, another sub 95 degree morning i decided to roll with the windows down and no AC - and still the Auto Stop isn't working. Any ideas?

I have a new 2019 Sierra that the Auto Stop did not work after the first 500 miles. I have had it in the shop 4 separate times and the GM techs cannot figure it out.  Each time GM resets it and it works for 300 miles or less then stops working again. Now this is strange as we got 6” of snow and the first time I put the truck in 4x4 I noticed the Auto Stop started working after I shifted back to 2 wheel drive. Truck has 16,000 miles and I will let the dealer know that it is working now but hopefully it is not a problem in the future.

Posted (edited)

Same here after my first oil change along with the 2 recalls all done in one appointment, it stopped working for me. It’s hovering around -5C or so here but don’t now if that’s the threshold. 
 

Update:  So after a two days, Stop/Start is working again.  Even in around -12C feels like -20C according to local weather reports.  

Edited by SilveradoRST
Posted

This is not very scientific, but I've noticed this happening lately too. I'm in North Florida (Southern border of GA, a few hard freezes a year, some frost, etc) and since it's been cooler it hasn't seemed to auto stop. Again, not scientific, but that's what I've been noticing.

Posted

I only have around 150 miles so far but the autostop feature on this 2019 6.2 10spd is a lot more noticeable than in my 2009 Tahoe Hybrid with 217k miles on it. I will have to research how they are restarting the engine in these newer products but whatever it is, it is not nearly as smooth as the Hybrid Tahoe from 10 yrs ago.   

Posted
3 hours ago, Dnt said:

I only have around 150 miles so far but the autostop feature on this 2019 6.2 10spd is a lot more noticeable than in my 2009 Tahoe Hybrid with 217k miles on it. I will have to research how they are restarting the engine in these newer products but whatever it is, it is not nearly as smooth as the Hybrid Tahoe from 10 yrs ago.   

It uses the starter in a traditional manner.  Didn't the hybrid use the starter as a motor to move the vehicle and get it going?

Posted (edited)

The GM TwoMode Hybrids from a few years back utilize 2 electric motors inside the special 2ML70 transmission and use a  dampener in place of the torque converter, it does not have a "starter' in the conventional sense the electric motor inside the transmission spins the engine (aka ICE) through the dampener to start it. The transitions are smooth as silk, really some awesome technology. It was just too expensive for GM to manufacture I guess. 

I needed a 4x4 for work and something that I did not have to worry about getting scratched/dented and that was CHEAP to buy. At $6,600.00 this Tahoe fits the bill perfectly and is really a fun truck to drive. I have put 23k miles on it in a year and it has performed well for a "Beater Ride"  

I think you are correct on the new GM trucks they seem to be utilizing the regular starter which creates a noticeable shake. i may just turn the silly AutoStop thing off I don't think that I will be able to tolerate it. 

2009 Tahoe Hybrid.jpg

Edited by Dnt
added info
Posted

i live in upstate NY and yes it wont engage if your truck is still cold as hell and the heater is cranking, particularly if you're one of those guys who cranks his thermo to high. It's a thermostat people. Treat it like your house and set it at your desired temp (68-73) and leave it. It'll heat and cool as fast as it can and then calm down.

 

anyhow, It usually takes a good 5-10 minutes before it's happy and then will kick off at a stoplight. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Sad thing is that this doesn't have to be the case. LSPI can be solved without a reduction in TBN. Swap Ca for Mg.  Cats are not a issue if the OEM can get a ring and valve guide seal even at SN levels of SAPS. Dizzy is purring like a kitten with a bowl of warm milk. 200K of Full SAPS oil and zero detonation issues and nice a clean inside and out. This shouldn't be an issue. It isn't 1920.    Tell ya what AMSOIL SS is excellent at, internal cleanliness. The new formula is even a step up from their already outstanding cleanliness levels. Can't say the OEM offering is quite that clean. There marketing suggest the SS is cleaner.     That is the only defense with at shelf oil. Nothing wrong with them if you ignore the marketing and OEM 'recommended' OCI and use a thimble full of common sense. 😉 You go sir. 
    • I started with a folding cover by BAK PAC on my 2500. It went bad after close to 5 years. Bent and vinyl coming loose. Contacted BAK and they gave me a very good discount on a Revolver. Had it a number of years. Mostly outdoor storage. Some garage storage. Vinyl started to come loose. Still under warranty so they replaced to cover. Sold the 2500, bought the 1500 and got another revolver for it. Had it a couple years now and no issues. I store it indoors. Got a bit of discount when buying it as well. If you are seeing problems, contact BAK or real truck and let them know. Customer service was pretty good. But I think they changed their warranty.
    • I agree, there is no one answer fits all as every rig is different, one may be pulling some little aluminum fishing boat while another is towing a monstrosity that weighs a lot and hopefully the owner if the rig has some prior experience to know what drive mode they should choose.    It also struck me and this is from watching a few of those boat ramp escapades videos in the past, Ford being one of the vehicles that has the auto front axle hubs and sure enough its found out that one hub has crapped out and won't engage and may not have manual hubs to even select on both sides so they are on the boat ramp stuck with no four wheel drive and spinning .... they flat out need a tow to get up the ramp and deal with the vehicles new found issues. That can happen to all brands of pickup, finding out either four wheel drive or 4 low isn't working right at the time its needed it to work as some electronic crap has failed. 
    • Its possible you never had the joy of the crappy boat launches we tend to have around here or really some of them are just grades down to the river if its a river scenario and the conditions change all the time with the river levels and silt deposits. Some of the lakes we went to years ago, there was no such thing as a cement pad that went down into the water that the trailer stayed on, it was gravel maybe up to the water line and then duck crap much beyond that so sinking the boat tires into mud. Of course some of the more established lakes had a cement bar type boat ramp but sometimes it was covered in green slime closer and certainly within the water and a two wheel drive had all sorts of fun if one had to touch that slime with the rear tires.    A neighbor of mine had made a comment years back with his chev truck that was probably about the same year as yours but a half ton extended cab 4x4 and he a a fiberglass boat with an inboard so it wasn't a feather weight and he had gone out to one of the large popular lakes in the area and don't ask me how this happened but he was in two wheel drive as he figured he didn't require four wheel drive for that boat ramp and somehow upon pulling the boat out he twisted one of his drive axles. I suspect it must have spun and then grabbed on the cement ramp and shocked it to the degree of twisting it. He would have had the standard 8.5 or whatever it was axle housing as the 9.5 ring gear like my truck has also has larger drive axles as far as I know. Anyway he was feeling a vibration driving home and had it checked out and a shop found that the tire/hub was wobbling because of the axle had twisted so in went a new drive axle. After that bad experience he said he made sure to put it into four wheel drive to lower the stress on the rear axle. Of course that is where an HD truck can handle a lot more stress and no doubt these newer half tons with their larger ring gears probably have larger drive axles as well to match vs back in the day. 
    • Desirable - as in does someone WANT one, aspire to have one. Could reasonably buy any car they want and CHOOSE these instead.    I didn't watch the video, why did they win?
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...