Improving turning radius

[Stand By]

Being in a recreation area, I've been seeing some of the fastfoods advertising to place the order at the speaker and pull off to the side and they will bring it out to you.

[Stand By]

I'm in a recreation area. A lot of drive through's allow for rv's by bringing your food out to you after you order.

[pokismoki]

if you narrow the rear track , so change back spacing on the rear rims, by about 2" this should tighten up your  turn radius,

[TLS]

Coming from past trucks, my 2015.... I think has the worst turning circle.

 

Does anyone have wheel cut angle for various era trucks?  I'm thinking it's getting worse.

 

My old '75 and '76 C/K series turned VERY sharp....and by that I mean the wheel cut angle.

 

My '90 K-3500 for being an extended cab long bed, at the time seemed like it cut less, but was still a very maneuverable truck.

 

My '04 2500HD Reg cab was like a car.  Turned fine (thanks to the short WB), but it really seemed to have a sharp wheel cut angle.

 

Fast forward to my '15 2500HD (ext cab long bed)....this thing is ridiculous!  I seriously think the wheel cut angle has changed dramatically.  I used to snow plow with all of the above, and never had issues.  I don't with this 2015, but feel like it's entirely too hard to swing around.

So does anyone have data on wheel cut angle over the different models of the past?