Jump to content

Recommended Posts

Posted

Hello everyone. I ordered a 2020 and got it March 2020. Now I have about 15k miles on it. A few 500 mile trips. A month or so ago on a trip from northern IL to TN i got a rock that cracked the windshield and it spidered within minutes. On the same trip I took a rock or something from the road glancing and hit my drivers door marking a scratch down to the metal. Did an insurance claim got the door painted and windshield replaces at 10k miles. 
 

Yesterday I noticed the same exact type of scratch on the drivers rear door. Mid door, down to the metal. And also a chip in the glass right in front of my view. 
 

is this just bad luck or is others having issues like this? I have stock tires goodyear trailrunner and mudflaps on my LTZ with no lift. Has anyone used a service to fill in a glass chip and also the AC delco 4:1 paint pen? Don’t want to do another insurance claim but this is ridiculous. Also it’s now winter in IL. Not sure if it needs to be above 50 to use the paint pen... didn’t say on the box. 
 

thanks for your insight. 

Posted

I feel your pain on the windshield I hit a rock with mine on the way home from the dealership replaced at 81 miles.

Posted

Glass chip repair works great if it's smaller than a quarter and not spreading.  Definitely cheaper than a full replacement, and many insurance policies cover it with no deductible.  They may refuse to do yours as it's in front of the driver and the repair does leave some distortion.  I had a few windshield chips repaired on my old Canyon.  No issues 10 years and 200,000 km later.

 

In the meantime, don't crank the heat before getting it looked at.

Posted

Cracked windshield on a 35 mph road from the car passing me on the other side of the road. It hit by the edge of the A pillar and was across my windshield by the time I left work 4 hours later.


Sent from my iPad using Tapatalk Pro

  • 4 weeks later...
Posted

You are not alone. My 2020 SLT picks up chips and scratches if you look at it funny. Luckily the dealer has been repairing them for free. I drove a loner Buick while they had my Truck, repairing paint,  and I noticed that it was covered with rock chips. Must be a bad year for paint. You can ask the dealer for paint as well, sometimes theirs match a little better.

Posted
7 hours ago, Terry104 said:

You are not alone. My 2020 SLT picks up chips and scratches if you look at it funny. Luckily the dealer has been repairing them for free. I drove a loner Buick while they had my Truck, repairing paint,  and I noticed that it was covered with rock chips. Must be a bad year for paint. You can ask the dealer for paint as well, sometimes theirs match a little better.

Your dealer is fixing that for free?  Wow.... I haven't needed to ask but that's pretty amazing

Posted

That’s funny I’m from New Jersey and bought brand new 2017 Denali from Laura in St. Louis and after I got home and was cleaning it and noticed some paint imperfections in the dealer said this is normal wouldn’t do anything for me…

Posted

I was very happy to let my 2017 Silverado Siren Red go earlier this year... every panel had rock chips on it. I also cracked the windshield before 10k... I know I'm in Alaska but my 2003 and 2011s were no where near this bad with the same conditions.

 

It's sad to say even with MSRPs jumping sky high the new normal is to have paint protection film installed for another $2k+ to make sure you keep your paint attached.

Posted

Rock chips in windshield and paint are bound to happen eventually no matter what you do. I just got my first chip in windshield on my '20 w/17k miles. I have had to replace the windshield at some point with my last two trucks due to chips and/or cracked. Just remember to get windshield coverage on insurance so no deductable to replace.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • I'm looking at carpal tunnel surgery on my left hand and lumbar fusion. 
    • While waiting for parts I have been working on installing the AC compressor, new accumulator, and orifice tube. Also changed out the high side ball valve (original). The orifice tube that was in there wasn't too bad. Slightly dirty, a little bit of junk, but not blocked. Glad I changed it out.   The accumulator, which should have been a 5 minute job, may have just burned $50. Put some PAG in it, wrote the date and mileage on the side, fresh o-rings and gooey'd up the threads and rings with Nylog. Got everything connected and snugged and was going to vacuum down the system, and....   My manifold gauge won't fit on the port. It's not an R12 service port. It LOOKS like an R134 service port but the diameter is a hair too large. There's a sticker on the accumulator that says it's designed to be used with R12 and R134a systems only. So it's not R1234yf. Even if I reduced the diameter slightly with a file, the shoulder on the port is too large so the quick-connect valve won't lock on. I'm stumped. It's going back, and 50/50 on if they'll give me a refund.   Also, I did a fuel pressure test.... Key on, the gauge spikes to about 60psi and quickly bleeds off, like 2psi per second. The fuel isn't going into the plenum, no smell, starts fine, so I'm guessing there's a bad check valve in the pump and the fuel is just draining back into the tank. oh, hell. But, it shouldn't be a problem, pump primes just fine and the truck starts right up. It just means I can't really ever use fuel pressure to verify a leak at the injector or intake.
    • Got this yesterday out of nowhere. Truck is a 25',6.6 gasser with 8k miles.  Only semi anomaly is that the truck had been sitting, uncranked for 6 days. Elec Stability Control showed immediately upon cranking, not while driving. No drivability issues, just the message. Battery didn't seem to be weak when cranking over.  I drove it, killed it, let it sit a few hrs with no avail.  Truck is 100% stock. No damage. 
    • This can be done.  It is not cheap and requires an instrument cluster swap with custom programming, new steering wheel with the controls on it, and a special jumper harness.   The cluster upgrade - 12.3” Digital Cluster Upgrade – 2022.5–2026 Silverado / Sierra (T1 Refresh Pickup) - WAMS   The wheel upgrade - Steering Wheel Upgrade Kit – 2022.5–2026 Silverado / Sierra (T1 Refresh Pickup) - WAMS   The column harness upgrade - 2019 - 2026 Silverado / Sierra: Steering Wheel LIN Bus Harness - Harness Dr. - DIY Done Right     The problem with doing all of this?  You pretty much can't have any programming done to your truck that involves the cluster ever again.  The dealer won't be able to program the cluster as GM's system will only pull data for the cluster the truck came with.  So it would be advised also to turn off over the air updates.   TLDR;  Should have bought an LT double cab?  You'd have a power seat, the wheel controls, the cluster, all things that you've been seeking in your various posts so far about your new WT regular cab.  
    • I was unaware of that, thanks for updating me.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...