Jump to content

Recommended Posts

Posted

That is the 03-06 Platinum

I've been looking for ways to dress up the interior some more, and this is definitely one of them.

Posted

Yeah that looks good. I thought it was the upscale new-body one - thought I saw that same dash in a '10 Escalade a while back. Memory ain't what it used to be, though ...

  • Like 1
Posted

I've been looking for ways to dress up the interior some more, and this is definitely one of them.

The denali one isnt bad. Im thinking of changing to it. Also rhe SS gauges are nice
Posted

I'll check those out too. I love the 800 interior design it's just a little bland.

A little Rustoleum can go a long way
Posted

A little Rustoleum can go a long way

I've never been good with paint. Always runs or never turns out right.

Posted

I've never been good with paint. Always runs or never turns out right.

Light coats
Posted

I'll just send it out to you lol!

You dont want to see my rates
Posted

Started looking for a replacement for the '91. Not getting rid of it, just retiring it from work duty. I need something for puling, the 2014 I sold was good at it, but not great.

So, the search for a 3/4 ton begins, and I've gotta say the Ram 2500 is winning. A 6.7 Cummins, solid axle 4x4, 6 speed manual, CCLB with 70k Kms for $31K CDN. Compared to a 6.0 gas, 4x4, CCSB 6 speed auto with 80k Kms for $39k... Both 2012's both comparable in options (the GMC has power seats and the Ram doesn't)...

Posted

Cummins hands down ... although I'm partial to the 12-valve, mechanically injected, no b/s engine.

Posted

I have a very low opinion of the newer light Cummins. Expensive to fix and poor mileage. I don't think there's any way you'd get far past 200,000 without major repairs. Ours blew a seal in the turbo and drank all its oil. Pricey rebuild.

 

Sent from my SM-G920V using Tapatalk

Posted

Are the newer manual Cummins engines still detuned? I know at some point the manual got a much less powerful version of the engine. With modern automatics there is no reason to go manual, especially on a diesel. Lost boost on every shift? No thanks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Have considered installing a DC to DC charger in your camper to replace your isolator?  
    • Common failure.  You need to replace the fuel door housing.   The painted cover transfers over to the new housing.  To remove the old one there is 4 spots where you poke the plastic to release it.  
    • No such thing as regenerative braking on a pure ICE vehicle.     Regenerative braking is the re-capture of energy from electric motors and stores it in the battery pack.  So hybrids, PHEV and EVs have regenerative braking.     What you are seeing is the charging system changing modes is all.  Its likely entering charge mode for some sort of reason is all.  All of the charging modes will be listed below.   As for L10 vs D.  L10 turns off automatic grade braking.  L10 puts you in control of grade downshifts where in D it will automatically do it based on brake pedal position and other factors.  Otherwise L10 and D drive exactly the same aside from that one aspect.    Battery Sulfation Mode The BCM will enter this mode when the interpreted Generator output voltage is less than 13.2 V for 45 minutes. When this condition exists the BCM will enter Charge Mode for 2–3 minutes. The BCM will then determine which mode to enter depending on voltage requirements.   Charge Mode The BCM will enter Charge Mode when ever one of the following conditions are met:   Windshield wipers are ON for more than 3 s. Climate Control Voltage Boost Mode Request is true, as sensed by the HVAC control module via serial data. High speed cooling fan, rear defogger, and HVAC high speed blower operation can cause the BCM to enter the Charge Mode. The estimated battery temperature is less than 0°C (32°F). Battery State of Charge is less than 80%. Vehicle speed is greater than 145 km/h (90 mph) A current sensor malfunction exists. System voltage is determined to be below 12.56 V When any one of these conditions is met, the system will set targeted generator output voltage to a charging voltage between 13.9–15.5 V, depending on the battery state of charge and estimated battery temperature.   Fuel Economy Mode The BCM will enter Fuel Economy Mode when the estimated battery temperature is at least 0°C (32°F) but less than or equal to 80°C (176°F), the calculated battery current is less than 15 A and greater than −8 A, and the battery state-of-charge is greater than or equal to 80%. Its targeted generator output voltage is the open circuit voltage of the battery and can be between 12.5–13.1 V. When fuel economy mode is active, the generator is not charging, only maintaining open circuit battery voltage. The BCM will exit this mode and enter Charge Mode when any of the conditions described above are present.   Headlamp Mode The BCM will enter Headlamp Mode when ever the head lamps are ON (high or low beams). Voltage will be regulated between 13.9–14.5 V.   Start Up Mode When the engine is started the BCM sets a targeted generator output voltage of 14.5 V for 30 s.   Tow/Haul Mode (if applicable) Pressing the Tow/Haul Mode button located on the center stack, the vehicle system voltage is raised and the remote (non-vehicle) battery will be charged. Having the headlamps on will raise the system voltage and if the Tow/Haul button is applied it will not serve any purpose. The voltage is regulated between 13.9-14.5 V.      
    • Hello from Australia Just sharing that there is now a way to delete the active shutters entirely with just a plug in module. Opens up tons of room to light bars etc.
    • I have an observation and a question... 1) I watch the voltage closely because I have had to dial in the cut-in/cut-out voltages of the battery separator to my camper.  The "smart" charging drives me nuts.  Anyway, I noticed that when coasting for a while, and especially if lightly using the brakes (though not necessary), the voltage goes up from mid/high-13 volts to mid/high-14 volts.  Then it drops back down after stopping or going again.  Consistently!   The only explanation I can come up with is REGENERATIVE BRAKING!  Well, maybe that's a little bit of an exaggeration, but it's certainly free extra battery charging.   2) Driving on mountain roads I will use L and vary the max gear.  Things straighten out and I end up in L10.  Sometimes I leave it there for a while.  Is there any difference between L10 and D?   
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...