Jump to content

Recommended Posts

Posted

RX350s in!

Question.

 

While I'm

Installing this HID kit I was looking at the projector upgrade here. Would it be too much light output to replace the projector and have the kit? Also... I have a shop doing the headlight work for me but can the projector be swapped out without opening the entire headlight?

Posted

Sorry everyone, I am a little late to the party on this subject. I've got a 2015 Sierra 4x4 7z1 and like everyone else the headlights are lacking.

Is there anyway to just change the bulb, plug and play, that would increase the light? Also, might the Denali OEM headlights work as a replacement?

 

Sorry, just looking for a simple solution, nothing complicated.

 

Don't know if you were meaning to replace your headlights with the 2015 body style Denali or the 2016 but what I can tell you is that the headlights on the 2015 Denali are no better than the SLE's and SLT's. I had to put HID's in mine just to be able to see at night. GM definitely went backwards on the Sierras as far as headlighting went. I had a 2011 Sierra before the 2015 and it would light up the world with standard halogen bulbs.

  • Like 1
Posted

The TRS kit looks good. Anyone know if this will work even though I got the GMC bulletin upgrade (BMC voltage changed)?

Posted

could not take it anymore - the horrible 14 lights or lack there of ...

got the morimoto and what a world of difference! any doubts buying this kit? dont' have any...it is top notch

35w 4500k

  • Like 1
Posted

The TRS kit looks good. Anyone know if this will work even though I got the GMC bulletin upgrade (BMC voltage changed)?

It will work

 

Sent from my SM-N920V using Tapatalk

Posted

Anybody running the opt7 LEDs off amazon I had xenon market 6k hids was down to driverside low beam and passenger fog light driver side fog and passenger low beam went out and I was leaning towards going led just wondering if I should do that or stick with hids as I have read that the hids are still brighter

 

OPT7 LED Headlight Bulbs w/ Clear Arc-Beam Kit - H11 (H8, H9) - 60w 7,000Lm 6K Cool White CREE - 2 Yr Warranty https://www.amazon.com/dp/B00VNBDWPK/ref=cm_sw_r_cp_awd_80DkxbCGE64BF

Posted

 

 

 

I haven't found anyone that has installed the LTZ projectors into the Work Truck Trim but I have seen a few LT to LTZ swaps and everyone says they are plug and play so you should be okay. I am posting a link to a similar thread below:

 

http://www.gm-trucks.com/forums/topic/153376-2014-silverado-headlights/

 

Well I bought the GM projector headlights and now ready to do the upgrade to the FXR but keep reading about TRS?? What or who is this?

Posted (edited)

 

Well I bought the GM projector headlights and now ready to do the upgrade to the FXR but keep reading about TRS?? What or who is this?

TRS = the retrofit source.

https://www.theretrofitsource.com/

 

It is an online retailer that specializes HID/led headlights and conversions.

 

Fastheadlights

www.fastheadlights.com

as far as I know is the only company that has a Bolt on adapter for the Silverado LTZ/ projector headlights. They both sell the parts for the HID kits but only fastheadlights has the FXR projector mounting adapter.

Edited by Alexantics
Posted

morimoto - TRS...

what a world of difference...not the best pic but.

i am surprised GM hasn't gotten their ass sued over the old halogen projector bull shit....they are down right dangerous.

IMG_2474_zpsjni3xozt.jpg

  • Like 1
Posted

Hi, I am new here but the HID thread has gotten me very interested as I just got a 2014 GMC Sierra with the projectors. Boy do the lights suck! Has anyone used or have any information or opinions about the Enlight Alpha series HID light system? They have a great video on youtube showing how to install the system. I want to do something about the lights just not sure who to go with or which system would be better. I'm not ready, yet, to cut the headlight casings or I would definitely be going with the Fastheadlights kit.

 

Posted

Hi, I am new here but the HID thread has gotten me very interested as I just got a 2014 GMC Sierra with the projectors. Boy do the lights suck! Has anyone used or have any information or opinions about the Enlight Alpha series HID light system? They have a great video on youtube showing how to install the system. I want to do something about the lights just not sure who to go with or which system would be better. I'm not ready, yet, to cut the headlight casings or I would definitely be going with the Fastheadlights kit.

 

Morimoto HIDs from The Retrofit Source. They have a Sierra spec kit that has everything you need. I've had the kit in for 3-4 months now without a single issue. Just installed a kit for my brother in law on Saturday as well. I think I read every post on every thread in this forum about HIDs before I finally pulled the trigger.

 

Sent from my SM-N910V using Tapatalk

Posted

What is brighter and whiter from Morimotor DS2? 4300 or 5000?

  • KELVIN AND LUMENS (35W)
  • 3000K: Golden Yellow (~2800 lm) 4500K: Warm White (~3500 lm) 5500K: Pure White (~3400 lm) 6500K: Cool White (~3200 lm)
  • Like 1
Posted

 

  • KELVIN AND LUMENS (35W)
  • 3000K: Golden Yellow (~2800 lm) 4500K: Warm White (~3500 lm) 5500K: Pure White (~3400 lm) 6500K: Cool White (~3200 lm)

 

 

Thank you

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Oil pump noise was discussed before.  I will try to remember to record a remote start later this morning. 
    • There are probably a few threads talking about fuel mileage but this one seemed to fit the stats I have seen based on my typical local driven route but with different outcomes based on different seasons/temperatures. I have a few hundred pounds of items that consistently ride on the truck at all times such as a bak flip cover, rubber bed mat, tools and extra fuel so I would be something over 8100 lb without me in the truck. All these examples are based on a 100 mile round trip to a town plus running around town so maybe 110 to 120 miles in total for a trip. Using regular fuel and I assume it always has some ethanol in it but don't know the percentage they blend in. Also speed wise I am going at 62 mph and non aggressive driving although less speed yet if its crappy winter condition roads. I am going by an initial reset of the computer generated fuel use numbers averaged over a couple of thousand miles or so for each weather/season so they may be more optimistic then actual hand calculated numbers. Basically this is painting a picture of doing the same drive but seasonal conditions and temperature being the major variable to the end result. Oh and although I am in Alberta Canada, I am converting it to miles per US gallon so there is no confusion.    So winter time it gets cold here, no real surprise there and the roads can be clear at times but also often have packed rough snow or are are driving through loose snow ( they do a poor job of plowing the highways ) and yes this includes the extra idle engine time due to trying not to freeze ones butt off. 12.7 mpg is what I was getting during the winter months on average.    Then during the spring when it was around the freezing point and the highways are clear of snow, I was getting around 14.25 mpg.   Summer time, I have been getting around 15.15 on average but certainly some of the trips showed quite a bit better fuel mileage, so much depended on how much or little I had driven around town and number of engine restarts after sitting for a while at each location. But stating a best fuel mileage trip to town pretending that is what the truck gets on average is fooling ones self for sure !.      As I said in a different post, I had driven a 645 mile trip over a couple of days stint to a different destination then these other daily to town examples above, and was done during the summer with nice weather and not bucking a head wind, also keeping at 62 mph and its a rolling landscape type highway drive ( this isn't southern Alberta or Saskatchewan flat lands ) Hand calculated fuel mileage in this case though and it came out to 17.65
    • On my wife's 2020 Blazer (~69000 miles), we started to notice the brakes pulsating at faster speeds. Typically around town you don't notice anything, but highway/interstate driving you will notice it. I decided to pull of the front tires and look at the brakes. I figured with the milage, the pads should be wearing out to their life span, but they actually looked decent. Still with "meat" on them. One pad has a ridge wearing in it, and that same rotor is showing the ridge too. That's not the concerning part...the other rotor appears to have a raised bump on it!  The picture make it look like a pimple! Very odd and strange! NOTE: These are the factory brakes and rotors.   I'm attaching pictures of the front brakes and what they look like ate ~69000 miles.
    • 2024 Chevrolet 2500 HD Custom 6.6 Gas Canadian built Truck  I tried to search for my previous thread on this topic but cant find it so my apoligies  for starting another one    #1   Since we have owned our truck purchased new it has this strange noise after using the remote start function  you press the remote start and you hear it start but right at the end of it starting it almost seems like it wants to start again after the truck is running .   There is no gap in time it is right at the end of the start . Almost sounds like when you have started a car/truck and its running and then you try and start it again and you get that grinding noise ,sort of     #2  You can only hear this if you are standing outside of the truck and near the truck  you cant hear it when you start the truck from inside  the cab . So it may very well be happening when starting the truck that way as in normally    #3   This only happens when it is started after sitting . For how long I don't know but it happens after sitting overnight for sure and it wont do it if you stop the engine after starting and then start it again  I have had it in to the Dealership before concerning this but they did not have the truck  when it was cold to hear it . Now its back in the Dealership left it overnight so they could possibly hear the problem . They said they tried and nothing happened . Well they did not know what they were listening for . I started the truck remotely and BINGO it makes the noise . Oh that sounds weird they say . We need to look into it ! I have left for this week at the Dealership    Does your 2024 2500 HD gas do this ?  Any of you fellas care to take the time and trouble to film this operation from a cold start  so I can hear what your sound like  Really  would like to know if this is anormal sound  Thank You Fellas !!
    • 2026 Z71.  The other day I was backing a trailer into the barn.  The alarm was going off just because the trailer was in the field of the warning sensors when you get too close to something.  For some reason now the warning alarm doesn't work anymore.  It used to go off when I was just normally backing my truck into garage.  I still have the guidelines in the back up camera.  Is there a button or something to push to turn the sound/Alarm on and off?  I have the touch screen in this truck.  There isn't a "P" on the dash except for the parking brake.  I can't find anything in the touch screen under settings or vehicle.  Thank you in advance.  
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...