Jump to content

Recommended Posts

Posted

I really like your setup! I think I may go with this on my '14. You have a 2" level right? What brand did you go with? How much did you feel the 2" effected the ride? Thanks

 

2" Level and i dont feel like it messed with the ride much at all. I like it more with the level on it... but I also have the bigger 10 ply tires, which stiffen up the ride quite a bit.

It rides great though! Way smoother than my 2008 did.

Posted

Hello all

Like many I have read this until my eyes bled. Today I installed rc 2.5 front only with 275/65/r20 on 2016 slt 6.2 crew cab with std bed and z71 package. I have the 20" chrome clad wheels. After callingv 3 dealerships they are the same offset at the other 20's. 27mm. I was a little nervous about the tires but I couldnt be happier.

My initial measurements were

Front 36.5

Rear 39.75.

From ground through middle of tire to wheel well.

 

After was

Front 39

Rear 39.75

 

Results

Ride is stiffer but enjoyable and very smooth. Tires run great. I haven them at 50 psi and they move effortlessly. No real loss of power that I notice. So far I had some rubbing at full lock to the right only. I will have to check in the morning but very minor.

No regrets and love the way it rides and looks.

Hello all

Like many I have read this until my eyes bled. Today I installed rc 2.5 front only with 275/65/r20 on 2016 slt 6.2 crew cab with std bed and z71 package. I have the 20" chrome clad wheels. After callingv 3 dealerships they are the same offset at the other 20's. 27mm. I was a little nervous about the tires but I couldnt be happier.

My initial measurements were

Front 36.5

Rear 39.75.

From ground through middle of tire to wheel well.

 

After was

Front 39

Rear 39.75

 

Results

Ride is stiffer but enjoyable and very smooth. Tires run great. I haven them at 50 psi and they move effortlessly. No real loss of power that I notice. So far I had some rubbing at full lock to the right only. I will have to check in the morning but very minor.

No regrets and love the way it rides and looks.

Posted

Hello all

Like many I have read this until my eyes bled. Today I installed rc 2.5 front only with 275/65/r20 on 2016 slt 6.2 crew cab with std bed and z71 package. I have the 20" chrome clad wheels. After callingv 3 dealerships they are the same offset at the other 20's. 27mm. I was a little nervous about the tires but I couldnt be happier.

My initial measurements were

Front 36.5

Rear 39.75.

From ground through middle of tire to wheel well.

 

After was

Front 39

Rear 39.75

 

Results

Ride is stiffer but enjoyable and very smooth. Tires run great. I haven them at 50 psi and they move effortlessly. No real loss of power that I notice. So far I had some rubbing at full lock to the right only. I will have to check in the morning but very minor.

No regrets and love the way it rides and looks.

Hello all

Like many I have read this until my eyes bled. Today I installed rc 2.5 front only with 275/65/r20 on 2016 slt 6.2 crew cab with std bed and z71 package. I have the 20" chrome clad wheels. After callingv 3 dealerships they are the same offset at the other 20's. 27mm. I was a little nervous about the tires but I couldnt be happier.

My initial measurements were

Front 36.5

Rear 39.75.

From ground through middle of tire to wheel well.

 

After was

Front 39

Rear 39.75

 

Results

Ride is stiffer but enjoyable and very smooth. Tires run great. I haven them at 50 psi and they move effortlessly. No real loss of power that I notice. So far I had some rubbing at full lock to the right only. I will have to check in the morning but very minor.

No regrets and love the way it rides and looks.

I also run 275/65 r20s that roll good but lowering my tire pressures to 40 made it ride better with no loss in mpg. I have read of others going lower.

 

Sent from my SAMSUNG-SM-G890A using Tapatalk

Posted

I also run 275/65 r20s that roll good but lowering my tire pressures to 40 made it ride better with no loss in mpg. I have read of others going lower.

 

Sent from my SAMSUNG-SM-G890A using Tapatalk

I have the same size and I am running 35#psi and the ride is nice. I would like a wider tire preferably but I don't want rubbing(I don't have rub now, after 2 zip ties).

 

Sent from my SM-N910V using Tapatalk

Posted

I am not on board with tuning yet -- even just a speedo calibration.

 

I went to Disney World over the weekend; I have the TA KO2 in 275/70R18 at 40PSI. I do have a Range AFM device so my V4 mode was disabled both directions. I averaged 70-75mph

 

Heading down from Jacksonville to Orlando: computer said average fuel economy was 16.4mpg

 

Heading up from Orlando to Jacksonville; computer said average fuel economy was 18.0mpg

 

I am fairly certain that by not calibrating the speedometer for the new 33.2" tires causes everything to be quite wrong--trip, odo, fuel economy calculations, etc? Is that correct?

 

I feel like they are seriously wrong because I went to Disney World not too long ago without the lift/larger tires/AFM device and the fuel usage (in terms of filling up) was about on par with my previous trip. Cash wise it didn't seem like I used all that much fuel compared to before.

 

Interested in your thoughts--overall I am in love with tires and the level!

Posted

Guys I'm curious on something. For those that installed a leveling kit and also installed the 2 inch rear block. Was a shock extender for the rear needed due the increase in lift?...Or does it work fine without a extender?

 

Sent from my Nexus 6P using Tapatalk

Posted

Guys I'm curious on something. For those that installed a leveling kit and also installed the 2 inch rear block. Was a shock extender for the rear needed due the increase in lift?...Or does it work fine without a extender?

Sent from my Nexus 6P using Tapatalk

I had the 2 inch rear block installed on my Silverado in place of the factory and no shock extender was needed-at least that's what the shop that did the install said. The ride doesn't seem any different to me.

Posted

Guys I'm curious on something. For those that installed a leveling kit and also installed the 2 inch rear block. Was a shock extender for the rear needed due the increase in lift?...Or does it work fine without a extender?

 

Sent from my Nexus 6P using Tapatalk

If you're replacing the factory 1.25" block with a 2" block, you don't need longer shocks (or extensions). That extra .75" isn't enough to make a difference. However, if you stack a 2" block on top of the factory block, or replace it with a 3" block (which is a better option), then longer shocks are recommended.

Posted

OK thanks guys. Yea I was thinking just the 2 inch right now. I think if I went with 3 inches my rear height is ~39.25 now and that would make 41-42. I don't want a rake in the truck

 

Sent from my Nexus 6P using Tapatalk

Posted

Had some 295/60r20 Toyo MT put on my truck this weekend. Zip tied the liner back and no rubbing besides on the sway bar at full lock. I only have a 2.5" Traxda leveling kit on the front.

BBB2E350-B994-4349-A064-87B59E63F165_zps

  • Like 5
Posted (edited)

Installed my 2.5 motofab levelling kit and added a 1" rear block on top of factory block. Within 1/8" of level

post-153946-0-05283400-1454467574_thumb.jpg

post-153946-0-05283400-1454467574_thumb.jpg

post-153946-0-05283400-1454467574_thumb.jpg

post-153946-0-05283400-1454467574_thumb.jpg

Edited by Jibroussard
  • Like 1
Posted

Rough Country 2" leveling kit, Cooper Discoverer STT's 33x12.50x20.

 

11388726205_26ae2b361f_b.jpg

Can you add more pics of your cooper tires? Also how have they held up?

  • Like 1
Posted

Installed my 2.5 motofab levelling kit and added a 1" rear block on top of factory block. Within 1/8" of level

Can you get a pic of the leveling block that you have in the rear? Thnx

Posted

Had some 295/60r20 Toyo MT put on my truck this weekend. Zip tied the liner back and no rubbing besides on the sway bar at full lock. I only have a 2.5" Traxda leveling kit on the front.

BBB2E350-B994-4349-A064-87B59E63F165_zps

Truck looks sharp!!!

 

I think i will be getting toyo MTs when i do my lift.... Only on 33s right now with a level.

 

I need the white handles and mirrors!!!

 

Sent from my Note 4 on Tapashit

Posted (edited)

Can you get a pic of the leveling block that you have in the rear? Thnx

Dont have on of the block on the truck as i am not at home right now but let me get a screenshot of what i bought Edited by Jibroussard

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,889
    Total Members
    8,960
    Most Online
    smandy
    Newest Member
    smandy
    Joined
  • Who's Online   2 Members, 0 Anonymous, 536 Guests (See full list)


  • Latest Articles

  • Posts

    • Holy s**t - not much of a parts thrower you say? You BLASTED that thing with the parts cannon!  You'd have been probably $1,000 ahead if you had just brought it to a competent shop rather than shotgunning a bunch of parts it clearly didn't need.   Just FYI - oil additives are really, REALLY good at ONE thing ... and that's emptying your wallet. They're ALL useless gimmicks.   If that has the L94 or L99, then #7 is an AFM cylinder. I'd suspect a failed lifter in that case.   If you leaned on wiring, sensors, and/or connectors while changing the oil, you'll have to check all that to be sure pins didn't get pulled out, connectors broken, etc.. Old wire loom that was barely adequate when new is certainly brittle by year 19 - make sure wires aren't chaffed and shorting out somewhere where you might have leaned. or supported yourself on it.   If your a mechanic, why didn't you just find out what you were missing and troubleshoot from there??  TIMED spark, fuel PSI / injector pulse, air, compression.  Can't make ANY money going the parts cannon route.
    • LOL! Are you joking?? That wax SUCKS! 100% gimmick made to "look" good.    After just TWO winters I had severe surface rusting in patches over 90% of the frame. Only reason it looks great in the pics is because I SATURATED the frame every single fall with used motor oil for 14 of the 16 years I owned it. Otherwise it would've been sent to the crusher 8 years earlier with the speed it was rusting prior!    I sold that POS 3 years ago. Was a gigantic headache the second it rolled off the showroom floor. Brakes pulsated on the TEST DRIVE. Door trim fell off the 1st week! Interior squeaked and rattled, and the drivetrain clunked after 2k miles. 4x4 switch failed shortly after. Front end - ball joints, struts, hub bearings - all failed between 38k-50k. Engine started burning oil at 50k. Rear and and transmission failed before 100k. Nothing but problems, and frustration with the piss-poor engineering designed to make you give up. Well, it worked! Nothing on that truck was easy to remove ... except the wheels. They haven't figured out how to screw that up yet. Give 'em time ...   I won't make that mistake again. EVER.   Such fond memories ... https://postimg.cc/K1qf23tS  https://postimg.cc/gallery/X02z64J  https://postimg.cc/gallery/mHSRXZv  https://postimg.cc/gallery/D4mMRfL
    • Different monitors do their test only under conditions specific to that monitor.  you MIGHT find the drive cycle conditions for the monitor that isn't ready on this site: https://lemon-manuals.la/   If it's not there, then it should be on alldata.com for your truck, but it requires a paid subscription.   And you need to know which specific monitor isn't ready.
    • from another thread   Update...although the truck sometimes seems to idle weird and the transmission shift a little weird, I've driven about 7,000  miles and no issues.   However, the way GM has handled my rental reimbursement, the situation when my truck quit, and the recall in general has led me to this point...I have driven a GM vehicle for the past 46 years and unless I buy a C3 Corvette, this is the last GM vehicle I will ever own. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...