Spacer size needed for 35x12.5 on stock AT 20's

[mdes0]

Hey folks, looking for some guidance. I have a 14 Sierra AT with 20's and an RC 2.5 lift installed. Looking to replace the OE tires with Toyo 35x12.5's, not sure if I'm going with At or MT yet. I figure I will have to use spacers with the stock rims to avoid any rubbing. Anyone have any idea how I can figure out how large of a spacer I would need to pull this off?

Matt

[LTZ2014]

First off you'll need more then a 2.5" lift/level to clear 35's unless you do some serious inner fender trimming. 33's would work better for your setup. A meaty 33 with 1.5" wheel spacers would look great.

 

 

Sent from my iPhone 5 using Tapatalk

[Dirtbiker]

You will need a six inch lift to run 35's with no rubbing.

[Silverado4x4]

Your not going to run 35s with just a 2.25 lift without major rubbing.

[polito7095]

got my truck with 2.5 lift and with 35/12.50/r20 lt was rubbing but I cut just what was rubbing and im good now I copy from this video

 

 

Watch "2007 Silverado 20" wheels 305/55/20 Nitto Trail Grapplers How to trim the fender" on YouTube

 

[mdes0]

got my truck with 2.5 lift and with 35/12.50/r20 lt was rubbing but I cut just what was rubbing and im good now I copy from this video

 

 

Watch "2007 Silverado 20" wheels 305/55/20 Nitto Trail Grapplers How to trim the fender" on YouTube

 

You have any pictures? What backspacing do your wheels have?

Thanks,

[polito7095]

I don't know if I got spacer I bought it like that and was rubbing thats why I DiD the cutting I have two weeks with the truck

[LTZ2014]

That almost looks like the RC 3.5" kit. The rear looks lifted too.

 

 

Sent from my iPhone 5 using Tapatalk

[polito7095]

Like I say I just bought the truck and the dealer told me that was 2.5" and I like it im going to check one more u going to be off on u speedometer I am and I have to fix that