Jump to content

2020 2500HD console to jump seat swap

Craig Deary
 Share

Recommended Posts

Tommy 503 New Member

Tommy 503

Posted
Posted

Hi I found your guys feed online while looking to swap out my 2021 Jump seat out of my 2500 LT Z71 Custom to a center console. My jump seat is Black leather with top and bottom store. If anyone still has they’re center console that they are looking to sell please let me know. Looking for Black. 

  • 2 weeks later...
  • Replies 39
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Posted Images

Inglewood11B New Member

Inglewood11B

Posted
Posted

Looking to trade my jump seat with top and bottom storage for a console. 2021 GMC 3500 Jet Black cloth interior. I live in North Idaho but willing to ship. 

brose05 New Member

brose05

Posted
Posted
On 1/8/2021 at 2:23 PM, Tommy 503 said:

Hi I found your guys feed online while looking to swap out my 2021 Jump seat out of my 2500 LT Z71 Custom to a center console. My jump seat is Black leather with top and bottom store. If anyone still has they’re center console that they are looking to sell please let me know. Looking for Black. 

Email me... [email protected]

kustomkruisers New Member

kustomkruisers

Posted
Posted

I’m looking to do a similar swap. I have a black cloth jump seat with top and bottom storage that came in my 2020 HD LT. looking to swap to a full center console. 

Austinamp Enthusiast

Austinamp

Posted
Posted

Has anyone been able to remove a center console for a jump seat and relocate the buttons to keep the rear heated seats? 
 

or remove the wireless charging from the console and have it installed into the top of the jump seat? 

  • 1 month later...
JG Timourian New Member

JG Timourian

Posted
Posted

I want to order a new 2021 Silverado 2500HD. The highest options all require the bucket seats, I think some electronics are installed in the console.  My previous trucks were all at the highest level trim that would keep the front split "bench" seats.  It is annoying though - GM has the dash swoop down a bit in the center, so you still don't get the open space, or the knee room, one would like. Better of course than the console for many purposes.  So this time I am going to order with the buckets in order to get the features I want - but I am hoping a custom shop will be able to do a swap for me. If they could also chop the dash back in the center that would be a plus.

  • 4 weeks later...
Brannon84 New Member

Brannon84

Posted
Posted

I have. 2020 AT4 I’m needing to convert. Does anyone have a jump seat they want to trade? Also my truck has the wireless charger and Bose speakers, am I going to have issues taking out the console? 

Brannon84 New Member

Brannon84

Posted
Posted

I have. 2020 AT4 I’m needing to convert. Does anyone have a jump seat they want to trade? Also my truck has the wireless charger and Bose speakers, am I going to have issues taking out the console? 

reagle Enthusiast

reagle

Posted
Posted
12 hours ago, Brannon84 said:

I have. 2020 AT4 I’m needing to convert. Does anyone have a jump seat they want to trade? Also my truck has the wireless charger and Bose speakers, am I going to have issues taking out the console? 

where are you located?

motorcare Enthusiast

motorcare

Posted
Posted
On 1/28/2021 at 7:59 PM, Austinamp said:

Has anyone been able to remove a center console for a jump seat and relocate the buttons to keep the rear heated seats? 
 

or remove the wireless charging from the console and have it installed into the top of the jump seat? 

I keep the usb outlets covered with tape when not in use; as you can see it gets a little dusty sometimes. The heated seat buttons have plenty of room, I put the key fob antenna next to it, the left side outlet fits tight, and the right side piece is fairly large so would only fit tilted. Jump seat came out of a 2016.

buttons.jpg

Beaujames83 New Member

Beaujames83

Posted
Posted
On 1/8/2021 at 2:23 PM, Tommy 503 said:

Hi I found your guys feed online while looking to swap out my 2021 Jump seat out of my 2500 LT Z71 Custom to a center console. My jump seat is Black leather with top and bottom store. If anyone still has they’re center console that they are looking to sell please let me know. Looking for Black. 

I just bought a 2021 LTZ 3500 with center console. I’m wanting to swap out for a middle seat. Let’s get in contact if you are still looking for a console.

  • 3 weeks later...
Bluefintunas New Member

Bluefintunas

Posted
Posted
On 4/26/2021 at 10:45 PM, Beaujames83 said:

I just bought a 2021 LTZ 3500 with center console. I’m wanting to swap out for a middle seat. Let’s get in contact if you are still looking for a console.

I’ve got a 2021 LT middle seat in charcoal cloth that I’m looking to swap for a console. Let me know.

  • 2 months later...
Ferdi New Member

Ferdi

Posted
Posted (edited)

When the mid console is removed...

 

1.. is there a hole in the carpet underneath the console?

Like with the Fords?

 

2.. do you need to re-do certain parts of the lower dash (like with the Ford superduty)? With ford you have to install the cupholders to fill up the hole.

 

3.. is there any wiring under the console that needs to be rerouted?

 

Or...is it as easy as unbolting the console, take it out and mount the jump seat?

 

I'm not technically inclined, but remove a console and bolt in a jumpseat I can do.

 

If it's fairly easy, I'll be buying a High Country or LTZ fairly soon.

 

 

I hope someone has a step by step instruction and hopefully with some pictures...

 

Thanks

 

Ferdi

Edited by Ferdi
Grammar mistakes
  • 2 weeks later...
Dmax1981 New Member

Dmax1981

Posted
Posted

I am looking for a new truck and would prefer an LTZ, but there is not one single truck I can find that doesn't have the center console. Heck, I can't even find an LT model that is even remotely close to my home. For any folks that have done this to the 2021-2022 models, please give us a detailed guide. I would like to order a truck without the console, but I am being told I wouldn't get it till spring. My thought as long as the modification isn't too in depth, I may just do the center console to jump seat conversion. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Chuck FB
      Oil Consumption

      By Chuck FB · Posted

      So speaking of oil consumption with my L8T as I just changed the oil yesterday and made the switch over to Amsoil SS 0W-40 from the Mobil 1  5W-30 Truck and SUV I just dropped out. 2900 miles on that oil as well as  68 hours on that oil ( so used to equipment with an hour meter and that becomes valuable information to compare with others as well ). Once again the oil use was so very little, I am going to say it dropped under 1/16 of an inch on the dipstick. No towing was done and this interval was from early spring until now.    One interesting item to note is that going by the 5 quart jugs I was using before from Mobil, it was showing that I was putting in 8 US quarts to bring it to full if not slightly over the full mark according to their jug markings. Granted I did allow more drain time this time and in part because the engine oil was only lukewarm as I started it and let it idle and not for long enough to get the oil itself hot ( the engine was up to operating temp ). The oil in that state just seemed to take forever for it to drip out but not only at the drain plug but at the oil filter housing as well, perhaps I had never quite gotten all the oil out before and I could have still waited longer but as it was I waited well over 3 hours. I think next time if I have the time I will do an experiment by dropping the oil and lets say leave the pan under it for 15 minutes, then switch to another pail and let it drip out overnight and measure how much more oil comes out. So this time and yes I ended up getting it just over the full mark as I was experimenting with trying to get the level to the add mark after I had run it and then waited some and then added a bit and waited for a certain amount of time for it to settle to the add mark. I very well may not have waited long enough for that experiment but I got to the add mark, then dumped in a full quart and waited some and checked and then waited some more and it crept up more ... and then finally oops, it was slightly over full some hours later when it really had settled all it would. I find this engine sure takes time for the last bit of oil that gets poured in to finally make its way into the crank case. I can only guess at how much too much I added as per maybe a 1/10th of a quart. I had poured in 8.5 quarts going by the quart containers as per 8 quarts and 16 us ounces. I was shocked at how much this was off compared to the prior oil changes and if those larger jugs and they are not marked accurately enough or they contain slightly more than what they say, or the drain time factor made that much of a difference. But I know on this forum there have been others who have said they have put well over 8 quarts in their L8T and now I have also going by the Amsoil true quart containers. Its a confusing convoluted mess up here in Canada with some oil manufactures packaging is in true US quarts, some is also in true US quarts containers on an even number of quarts but also marked in liters which becomes the odd ball volume of a fractional amount of liters. Then there is the Liters only containers, no US markings as its a true metric container and only measured in Liters to an even number of Liters. But remember we used to have Imperial Gallons and Imperial quarts as well !. 
    • Atlas
      2027 GMC Sierra: Official Discussion

      By Atlas · Posted

      Holy smokes. Clearly not a deal on that truck. I just mean in general, matte or painted trim is becoming more normative than chrome, but I know the Black Optics packages on various vehicles are being sold as uplevel trims. They look really good, but sheesh. It's just paint and plastic.
    • Grumpy Bear
      Some Assembly is Required

      By Grumpy Bear · Posted

      I Wouldn't Know Where to Begin    Oh I know where I would begin but I'm just one of over eight billion people on this rock. Eight billion versions of where the goal post is. How large it should be. How far to kick from. What ball is the right ball. Elevation. Age.....are you getting the point? It isn't about disagreeing with one individual. It's about agreeing only with one individual. One's self.   Agreement comes when multiple people hold the same point already. THAT is the goal of an education. Building the Social Contract. That thing that allows us to all read this sentence. We've agreed on the alphabet and how to arrange those letters into words we agree upon whose meanings hold true for everyone entering into that contract. Those words arranged into a sentence form an idea and several sentences strung together in a paragraph convey an argument for or against or inform the reader of a state, condition or perhaps reveal a things nature. Paint a word picture. Make oneself known.    This contract is not limited to words although they are often explained by words. Things like numbers and their usefulness. Physics, Chemistry, Medicine, Music, Art and so on.    The frequency of middle C (C4) is 261.63 Hz is a first principle. We build on that to make music we all can enjoy even if we all can not compose or play. You don't have to master it to make it enjoyable and useful.    So why is the Beginning so difficult? Why is agreement so elusive?   Everyone "Signs" the contract (when receiving that education in obtaining it)  but fewer and fewer in this world have any intention of living by that contract. They find exploiting that contract more advantageous. Disruption. With intent. Without intent. In Ignorance. In your face. With a double dog dare you. With a hold my beer. In resistance to that contract and in spite how it looks on us. It permeates the very air we breath.    In this way the contract is subject to advantage. Abide by it when it serves you, disregard it when it doesn't. Unpredictable and self-serving. Corrosive.....Toxic........   It says a lot about a persons character to disregard the contract, the truth, first principles. None of it good.        ********************************************************   https://medicine.yale.edu/news-article/character-vs-personality-who-we-are-and-who-we-aspire-to-be/   Just an interesting article.   
    • Jus Cruisin
      2027 GMC Sierra: Official Discussion

      By Jus Cruisin · Posted

      It costs $5,250 for the Yukon Nightfall option (black wheels, emblems and illuminated black GMC grill badge). What a "deal". 
    • Ralph Reale
      Android auto could not connect

      By Ralph Reale · Posted

      I keep getting the above error message on my 25 Sierra.  If I reset the infotainment unit (via the phone hang up button) it will work again for a day or 2.   But I dont want to do have to reset  all the time. Works fine in my 2023 Corvette. On both vehicles I connect wirelessly.   I have a Google Pixel 10 Pro XL, phone is up to date.  Any Ideas.  See attached  

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...