Jump to content

Recommended Posts

Posted

When I bought my Avalanche almost two years ago the engine and compartment looked new. I never had the service department say that was a maintenance procedure. I use to routinely at the car wash spray it down. I had a truck years ago throw a check engine light and run rough and I stopped doing it. My wife’s Genesis engine compartment is grimy so I’m thinking about it. Thoughts?

Posted

Occasionally I do a light cleaning on the engine compartment just to refresh it and get the dust away.  I NEVER use a pressure washer.  It's more like just wetting down the surface with some light soapy water and using a brush or sponge on the obvious areas.  I never try to scrub it hard or get a lot of soapy water directly on the alternator for instance.   PLaces like beneath the hood and the fender liners come clean pretty easily. Then just a light spray rinse with a water hose.  I never had a problem afterwards.  I usually start up the truck anyway to move it away from the wash area and let it run a minute to dry off.  This is a bout a once a year routine for me.  Good Luck!

  • Like 1
Posted

I have cleaned under the hood for years once a year.  I use Super Clean. Cuts grease better. Like it better than Purple Power. 

Cool engine. 

Fill this up and spray down with straight Super Clean. Do not dilute. This is easier than a spray bottle.

iPower GLSPRYBOTTLE1000 38oz Hand-held Manual Pump Pressure Garden Sprayer Bottle with Adjustable Nozzle for Lawn, Garden

I use this because you want to keep everything wet before you rinse. If it dries it's harder to remove and may leave residue.

Rinse with a garden hose. Set hose nozzle to a mild spray. Not a forceful stream. This way water isn't forced into places it shouldn't be.

If there is a place with dirt grease build up, spray directly with a stream form the sprayer until the dirt grease is gone. It will come off this way but requires using more Super Clean.

I have never had a problem doing this. Always a COOL engine is my preference.

If you do it yearly it's easier and faster than letting the motor get real dirty. 

I have used this method to clean the underside of a vehicle also.

  • Like 2
Posted

I just spray mine down with Simple Green and then rinse it with the hose with no nozzle on the end.  Let the water flow run down everything.  Easy and no  pressure to force water into connections and such.

 

Then when I'm done, I take it for a drive to dry it off, at least for what might get on the engine and want to sit in pockets that the water wouldn't normally drain off of.

 

Like on my 2002, the knock sensors were bad for collecting water.  I know these new engines are completely different but still what would it hurt.

  • Like 1
Posted (edited)

This is the method I use: 

If you do this about twice a year no running water is required. I've never put a hose to Pepper. 

 

 

Edited by Grumpy Bear
  • Like 1
Posted
2 hours ago, Black02Silverado said:

I just spray mine down with Simple Green and then rinse it with the hose with no nozzle on the end.  Let the water flow run down everything.  Easy and no  pressure to force water into connections and such.

 

Then when I'm done, I take it for a drive to dry it off, at least for what might get on the engine and want to sit in pockets that the water wouldn't normally drain off of.

 

Like on my 2002, the knock sensors were bad for collecting water.  I know these new engines are completely different but still what would it hurt.

+1 on the Simple Green. Works great. I'm due for an engine bay clean-up pretty soon

  • Like 2
Posted

I hand clean mine and while it is not perfect it is not a filthy either. Anyone who uses a hose to wash down their engine compartment is chancing it imo, from the alternator to the coil packs and all the electrical connections just far too much to worry about imo getting wet.

  • Like 1
Posted

Throw-away microfibers and Simple Green. Or waterless wash solution if it’s a newer vehicle and just dusty.

 

Thought I’d get cute and degrease the engine on my Honda Enduro over at the coin-op back in the day. Couldn’t get it restarted after, and had to walk the thing back home about 8 blocks. 


That was it for using a hose on any engine. I’m sure a modern vehicle would handle it a little better than a 70s motorcycle but still not worth it to me.

Posted

I use my foam cannon attachment for the hose or pressure washer, then rinse it off or use the pressure washer.

 

It's an electric pressure washer so I'm not zinging it with 3000psi.

Posted

After six years my engine compartment is dusty but not dirty.  A couple of years ago a tech at my dealership wrote in my service record that there were signs of rodent activity in my engine area.  There were tiny footprints in the dust.  I had the truck checked thoroughly and it appears the intruder was just passing through.  I cleaned off the tracks and now check regularly to make sure the dust is undisturbed! 

  • Like 1
Posted

I do a mini cleaning under the hood at each full service (5K) and a major clean twice a year. Even a quick wipe down during oil level checks. Now nearly 7 years old and a 150K on the clock and it has never looked worse than this. A little bit of cleaning often is more fruitful than once a decade for keeping it looking new and running cool. And yes it is this clean between the pan the lower shield too. 

It was a little dusty this day 

😱

 

IMG_0165.thumb.JPG.e970dbe4414abe53829584b49a9a1b54.JPG

Posted

almost jealous of you engine cleaners.

 

 

 

 

almost

 

Back when I detailed cars to be sold I believe I just shot some stuff with simple green and purple power and just wiped it all down.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • I'm surprised nobody seems to offer a solution like the start/stop device I put in my new truck. Remembers my setting when shutdown. And while it still starts up in start/stop, it stores/evaluates what mode it was in when shut down and will change it whithin a second or 2 of startup. It'd be nice to have something like that for the DRLs.
    • 2015 Sierra 1500 here. Leaks from the sunroof to front driver side and soaks carpet. How do I fix this? Thanks!
    • I will be doing that for sure, but I need to solve who has/ where I can find a bidirectional scan tool that will support OBD 1.5. I'm kicking myself because I ebay'ed a Snap On MT2500 that I didn't think I'd ever need anymore. D'oh!! I'd rather not buy another, so I'll contact a few local shops to see if they have one and how much they'd want to do the procedure. I'd rather have the ability to do it myself... I wish there was a modern tool that could do it all, but I'd have no idea what to buy.   The theory with the pulled timing is that it mimics a rich condition. The delayed spark causes incomplete burn and the O2 sensor picks up low oxygen levels. That's interpreted as a rich condition so the PCM pulls fuel and that shows up in the deeply negative fuel trims.
    • An ultra wealthy man had the most beautiful daughter. But, there was a problem. Everything she touched would melt in her hands. No matter what, Metal, Wood, Stone. Anything she touched would melt. She could not feed herself. Because of this, men were afraid of her. Nobody would dare marry her. Her father was despaired. What could he do to help his daughter? He consulted doctors, scientists and anybody who could solve this problem. Finally one of them said, "If your daughter touches one thing that does not melt in her hands, she will be cured." He was overjoyed and came up with a plan. The next day, he held a competition. Any man who could bring his daughter an object that would not melt in her hands would be given billions of dollars to marry her. Three extremely intelligent and handsome young men took up the challenge. The first brought a very heavy steel rod, But alas, when the she touched it, it completely melted in a matter of seconds. He sadly went away. The second brought a beautiful diamond, knowing diamonds were one of the hardest substance in the world and would not melt. But alas, once she held it in her hand, it melted. He too was sent away disappointed. So now, there was one left He was very nervous & sweating. He approached the daughter & said, “put your hand in my pants pocket and feel what is in there." She did exactly what he asked. She felt something very hard. She held it in her hand, squeezing it as hard as she could. It did not melt & remained extremely hard. Her father was overjoyed. Everybody was overjoyed. She was finally cured. Nothing never, ever melted in her hand again. They married and they both lived happily ever after, raising a wonderful family. Question: What was in the the groom’s pants pocket??? Answer below ↓ M&Ms of course! They melt in your mouth, not in your hand. What on earth were you thinking?
    • There's a bunch of tea leaves that you've read, but in any case the delayed timing is unusual. Not sure how that relates to the rich at idle vs. 'normal' while driving.   If you're in this deep, might be worth investigating, and re-learning the sensor. What have you got to lose? Plus, it properly fixes the timing cover leak.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...