Converting Gen 3 LS to Gen 4 Vehicle

[Dillion Padgett]

I recently bought a (Gen 3) LQ4.
I'm trying to swap this into an (Gen 4) 07' Silverado which uses 58x Reluctor, 4x Cam Gear, Front Timing Cover/Crank Sensor, and 2 Knock Sensors located in the sides of the block.

I have a (Gen 4) Truck, So the timing cover/ crank sensor/ knock sensors can be used. I also have a (Gen 4) ECM/Harness.
I know I need to get 58x Reluctor Gear put on & get a 4x cam gear already

My questions are as follows:
1. Can I put a 4x Cam Gear on a (Gen 3 Cam) ? or do I need to get a (Gen 4 Cam) for the (Gen 4 Cam Gear) to work ?
2. Can I use the (Gen 4 Knock sensors) on the side of the (Gen 3 LQ4) ? Just drill/tap & mount them ?
3. If I keep the (Gen 4 Fuel Setup) could I just install that on the (Gen 3 LQ4) ?

Any help or advice will be appreciated.
I'll be documenting everything so others will have better knowledge when putting a Gen 3 Block into a Gen 4 Vehicle. 
Thanks guys !
 

Edited September 1, 2022 by Dillion Padgett
Edits to grammar