What have you done to your K2 today?

[bdkidd01]

Yea I agree it's over stayed it's welcome, just haven't taken the time to take it off yet!

 

 

Sent from my iPhone using Tapatalk

[tenscourts]

Today I installed Air Lift Loadlifter 5000 Ultimate air springs (although I haven't connected my air lines yet). I just taped up the fittings. I get my compressor and tank next week.

 

Sent from my Nexus 5X using Tapatalk

[pgamboa]

Where did you get the frame tubes from? The post above yours seems to have his inserted the opposite. Didn't these were available. Looks like they are on amazon.

Edited October 2, 2016 by pgamboa

[CP4]

Where did you get the frame tubes from? The post above yours seems to have his inserted the opposite. Didn't these were available. Looks like they are on amazon.

eBay

 

http://m.ebay.com/itm/322214207376?_mwBanner=1

 

 

Sent from my iPhone using Tapatalk

[pgamboa]

eBay

 

http://m.ebay.com/itm/322214207376?_mwBanner=1

 

 

Sent from my iPhone using Tapatalk

 

Thanks! I just ordered a set from Amazon and ordered some from eBay similar to your link. Thanks again!

[Doobs41378]

Yep, I pulled into a convenience store parking lot on the way home from the dealer to get a drink, and pulled off the plastic dealer emblem while I was there.

 

 

I told the dealer if he could get the sticker off he had a deal. The sticker came off before I left.

[pgamboa]

If you have done something to your 14 and would like to share,please post here. Please don't post the How to in this thread.

 

Have a little time to install the tail gate light bar, replaced the bed light bulbs with led and install footwell led light..

 

Bed light replaced with this: http://www.ebay.com/itm/111217352865?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649#ht_1381wt_1181

They are super bright..

Tailgate led bar with reverse: http://www.ebay.com/itm/400624564281?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649#ht_2571wt_1155

Not too bad for the price.

footwell led,1 led per area : http://www.oznium.com/prewired-superflux

They are super bright.

driverside:

Passenger:

Rear :

Enjoy!

 

I just ordered some of these for my next project. I see that you tapped into Pin #1 on the BCM #7 connector (Dome Light Control Circuit). Where did you tap into grounds for each LED?

[cbrsilv15]

I grounded mine on a good bolt by each led. Grounded the ones in the back to a center console bolt and the fronts were grounded up under the dash.

[Tim Rasmussen]

I installed the pop & lock on my 2015. Super easy install and is giving me the itch to do more.

 

 

Sent from my iPhone using Tapatalk

[cbrsilv15]

 

Got these finished up yesterday and hopefully installed later today.

[cbrsilv15]

With the fogs and bulbs on.

 

 

 

 

It took about 45 mins to swap these out. In the rain too. Lol. It looks so damn good. Hopefully getting some more paint for the grille this week.

[Silvern Sentry]

In the rain

 

[cbrsilv15]

Had the wife hold an umbrella over the lights when I swapped them. Easy.

[crafferty]

With the fogs and bulbs on.

 

 

 

 

It took about 45 mins to swap these out. In the rain too. Lol. It looks so damn good. Hopefully getting some more paint for the grille this week.

Now you need to paint the grille surround.

 

Sent from my SM-G930V using Tapatalk

[cbrsilv15]

In the works. Getting a price on supplies this week.