stamped steel control arm ball joint pop out

[jipi121]

I want to know if someone have problems with a 2" level kit and stamped steel control arm. I heard that some people have the ball joint that pop out with 2.5 and 3" level.

I wanted to install a 2" level kit and replace the rear block with a 2", but now I hesitate if I just install a 1.5 "level kit.

[BlueTopaz14]

I have a 2.5 RC on my 2014, put it on at 10,000 and am now at 53,000 with zero problems


Sent from my iPhone using Tapatalk

[AgDoctor]

I have a 2.5 RC on my 2014, put it on at 10,000 and am now at 53,000 with zero problems


Sent from my iPhone using Tapatalk

Yours has cast steel Blue, he is talking about the new stamped steel that the 2017 and up has, though some 16's had them also.


Sent from my iPad using Tapatalk

[MarcS]

Its a known issue, Ready Lift even says on their website that their kit is not for use with stamped steel control arms due to ball joint failure.

[BlueTopaz14]

Yours has cast steel Blue, he is talking about the new stamped steel that the 2017 and up has, though some 16's had them also.


Sent from my iPad using Tapatalk

Ahh gotcha, I didn’t read that part, my mistake!


Sent from my iPhone using Tapatalk

[15_silverado]

Get a 3.5 inch kit that comes with new, redesigned tubular steel Upper control arms.

Superlift or rough country