Jump to content

Recommended Posts

Posted
1 minute ago, nw96 said:

I agree, the reason I will never use them again. They just kept saying something "impacted" the bottom left corner. 

Probably a moot point now as I am sure that glass is long gone so lesson learned...next time (with any issue) make them show you the "evidence" they are basing their conclusions from.

Posted
19 minutes ago, nw96 said:

I looked in to the insurance route, $500 deductible, in the end wasn't worth taking the hit on my insurance record over $700.00

I agree with the other post about glass and rates.  If your state doesn't have 'glass' protection, then it would go under comprehensive.  Comprehensive claims don't count against you.  The only time they may become an issue is if you have a string of them over a short period of time.  I have a lower comprehensive deductible than my collision; the price difference was not very significant.

Posted
58 minutes ago, nw96 said:

In the end no help from the dealer. Glass guy said it looked like something burned but the wiring looked fine. It cost me about $1200 ($900 for the window and $300 to my Chevy dealer for "diagnosis labor").  Showed them this and other posts but they didn't seem to care and said they've never seen this. I've bought 3 new Chevy trucks over the years from them. Pretty sure this is the last one. I did file the NHST complaint, not sure it will help. 

 

Also the dealer left my backseat out to "make things easier for the glass installer" however the glass installer did not need it out so got stuck putting it back in myself. Not a fun by yourself lol. 

Also, thanks for filing the complaint!

Posted

So even though it wont let me post the video of the smoke. I took a screenshot of the smoke minutes before it shattered and u can zoom in and u see there is no chip! U can also see a little smoke easily mistaken for a dirty window. I will also post the pic of "point of impact" so u can zoom in to that spot of before pic.  Also the dealer is about 15min away so the drive there could have caused that spot to chip off. The spot is right by that black contact box that was smoking. And glass guys said excessive heat could definitely cause that spot.

Roseville GMC lost our buissness too. Google reviewing individual dealerships is a good way to let people know who the bad ones r because a couple peoples dealer actually helped them!

 

Also glass is usually an exception to ur deductible. Mine covered it and state farm didnt care that it was caused by the truck i told them what happened too.

 

 

Screenshot_20190221-195111_Gallery.jpg

Screenshot_20190221-195059_Gallery.jpg

Screenshot_20190221-195040_Gallery.jpg

Posted
53 minutes ago, Lee_lee said:

So even though it wont let me post the video of the smoke. I took a screenshot of the smoke minutes before it shattered and u can zoom in and u see there is no chip! U can also see a little smoke easily mistaken for a dirty window. I will also post the pic of "point of impact" so u can zoom in to that spot of before pic.  Also the dealer is about 15min away so the drive there could have caused that spot to chip off. The spot is right by that black contact box that was smoking. And glass guys said excessive heat could definitely cause that spot.

Roseville GMC lost our buissness too. Google reviewing individual dealerships is a good way to let people know who the bad ones r because a couple peoples dealer actually helped them!

 

Also glass is usually an exception to ur deductible. Mine covered it and state farm didnt care that it was caused by the truck i told them what happened too.

 

 

Screenshot_20190221-195111_Gallery.jpg

Screenshot_20190221-195059_Gallery.jpg

Screenshot_20190221-195040_Gallery.jpg

Oh man!  Please tell me you're going to submit a complaint with https://www-odi.nhtsa.dot.gov/VehicleComplaint/?!?!

 

This is some of the BEST proof we've come across for our issue.  GM has to step up with this problem especially with your proof.

 

 

Posted
28 minutes ago, Lonnie Burkett said:

Just had this happen to my truck yesterday. So far I have the dealers telling me this never happens. Have made a appointment to get replaced by Safelite. 

Broken Rear window.jpeg

Well, there's a huge thread of people that 'this never happens' to....

 

I'd have them investigate the defroster before just taking on the bill...

Posted

Thanks to this thread I was able to shut my rear defroster off before the window shattered! My son heard a hissing noise and when I looked back saw the smoke just to the drivers side of the power sliding glass, turned off the defrost and it stopped. Since I work at a dealer it is in the shop now, my service department said they've seen a few blown out windows but apparently non of those customers described the same hissing and smoke I experienced. 

 

Waiting to see what they find, as of now it sounds like it was a short of some kind that keeps blowing the fuse.

Posted
3 minutes ago, BPIRKOLA said:

Thanks to this thread I was able to shut my rear defroster off before the window shattered! My son heard a hissing noise and when I looked back saw the smoke just to the drivers side of the power sliding glass, turned off the defrost and it stopped. Since I work at a dealer it is in the shop now, my service department said they've seen a few blown out windows but apparently non of those customers described the same hissing and smoke I experienced. 

 

Waiting to see what they find, as of now it sounds like it was a short of some kind that keeps blowing the fuse.

Really hope your service department can get to the bottom of it.  I saw smoke coming out of the black box on the sliding window but shut it off in time.  I also smelled a burning smell.  You and I are the only lucky ones to have avoided a shattered window.... so far.

  • Like 1
Posted

I will pass along what information I can, he is checking grounds right now. I did see a document regarding a water leak in that area, not sure if that has anything to do with it. 

Posted
1 minute ago, BPIRKOLA said:

I will pass along what information I can, he is checking grounds right now. I did see a document regarding a water leak in that area, not sure if that has anything to do with it. 

I have a water leak coming in from my OnStar antenna :'( but not sure that is related.  They are going to replace the antenna with a new design.  Apparently, the old design has an opening in the rubber where water can flow in...

 

I've heard of leaks at the back of the cab if the egress filters fall off.  There are two squares between the bed and cab that allow air to flow out when the cab doors are closed.  If those come off, then water would enter the cab (but that is a couple feet below the rear window)...

 

Thanks for letting us know.  You should also report it to:  https://www-odi.nhtsa.dot.gov/VehicleComplaint/

Posted
16 minutes ago, BPIRKOLA said:

Luckily I am just under my 36k warranty, it was some kind of short and where it is requires the rear glass to be replaced. 

 

This is the bulletin about the water leak, I never noticed a water leak but it is the same area I had the smoke. https://gm.oemdtc.com/8793/water-leak-under-back-glass-from-power-sliding-window-2014-2016-chevrolet-silverado-gmc-sierra

Ah wow, thanks for sharing that.

Posted
37 minutes ago, Aaron Ch said:

I have a water leak coming in from my OnStar antenna :'( but not sure that is related.  They are going to replace the antenna with a new design.  Apparently, the old design has an opening in the rubber where water can flow in...

 

I've heard of leaks at the back of the cab if the egress filters fall off.

There’s guys with brand new trucks with the “new” design antenna that have/had leaks

 

Also the third brake light is another area that these trucks can leak multiple threads on here. Guy I work with had his replaced three times and was still leaking. He said f it cause everything was soaked drove it over to the Furd stealership literally next door and traded for a F150. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • That should answer the maximum depth difference between the stock and the PPE so its not hugely lower. As to the PML pan, they don't make any claims that it fits the L8T with the same transmission and in fact leave their information confusing, however on the surface it says "for Duramax" and so its hard to say. I know a while back and not sure which brand it was that specifically stated that the extra capacity pan that particular company made did NOT fit the gas version. 
    • There are several versions of the 5100's. Some for stock height, some for leveled, some for lifted.    Side note. I finally had a chance to tow with my 30' gooseneck with about 10,000 lbs of material on it this past week. Hands down the 5100's made the trailer towing much more stable and comfortable. I even had 10 cmu blocks in the bed. What a difference over the stock shocks. 
    • According to PML, the stock pan is 4.3" deep - (PML info): Dimensions: at deepest area, PML pan is 7 inches, stock pan is 4.3 inches    PPE is 5.4" so roughly 1.1" deeper than stock
    • I had not realized that PPE has come out with a version of a cast aluminum oil pan specific to being able to fit onto the 10L1000 with the L8T engine sometime this spring. I was doubting that anyone would come out with something beyond what Dorman had in more of a direct factory pan swap. I see from one comment that is on the PPE site that they found the pan to be tighter to install then the factory unit and having to flex the exhaust down to fit it. I didn't lookup any specs if they have any as per how much lower it hangs but as it holds more oil and has fins outside the pan it would no doubt hang a certain amount lower.    I looked back at the site and they do have some depth measurements to get a rough comparison to the factory pan total height or hang down if you will at the front and rear of the pan so that will give a good idea how much further down this pan would end up being for ground clearance issues.    2024-2026 GM 6.6L Gas 10L1000 Heavy-Duty Cast Transmission Pan – Pacific Performance Engineering    
    • I'm in constant amazement over the number of people that do oil maintenance by how they feel, what they were told, what materials cost, what brand A claims vs brand B.     Come to think of it, this behavior isn't exclusive to oil. 🤔 They drive this way too. 😬   There is a 20 plus page thread on BITOG on Mobil 1 Advanced Clean vs Valvoline Restore and Protect it would be amusing if it were not so........humanly pitiful.   Last Sunday we were are sitting at services and listening to a speaker talk about Jesus parable of the wide and narrow gates and he said something that hadn't dawned on me but totally fit the way people in general are about just about everything. He said there are so few people on the narrow path leading to a good reward not because the the narrow gate was hidden or hard to find but because the wide gate leading to a bad end it so darn easy and uncomplicated to follow!!!             
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...