What Have You Done With Your T1 Today ?????

lapoolboy · October 23, 2020

On 10/21/2020 at 6:54 PM, ausomecasey said:

Nice! Got a full side profile pic?

Finally got a pic during daylight hours!

Dani2005 · October 23, 2020

32 minutes ago, childstoys said:

@Dani2005 - I have to say I'm not one for white trucks.... But Holy S4!T!

I agree with @eppieguy. This is one of the nicest T1 rigs I've seen yet. Great setup, beautiful truck. Good luck with the mods!

I probably won't look to lift mine for quite a while.... Going to be looking hard at those coil overs when I do. They are sharp. Please report back on your experience with them.

Thanks! It has been a crazy week but she sits high and pretty now

The shop (#OakleyOffroad) set the shocks to 4 and it's great. She doesn't have the boat feeling driving on the freeway or going over bumps. They advised to bump it to 8 when I tow or go up to the mountains.

Im sure I'll tweak it up or down a notch to find that sweet spot. It's nice to have that flexibility.

ausomecasey · October 23, 2020

1 hour ago, lapoolboy said:

Finally got a pic during daylight hours!

Haha, thanks, I definitely like them. Gonna save this pic for some future inspiration in case I decide to upgrade wheels.

BlackLS · October 23, 2020

Not today............... but installed new Zone Offroad control arms.

TXguy · October 24, 2020

On 10/22/2020 at 4:11 PM, Philipgonzales3 said:

Follow up to my other reply. I think you may have been asking about the knee bolster panel, under the steering wheel. That would make a little more sense since it is a PITA to remove. I did not remove that panel. I installed the switch with the panel attached. Enough clearance to easily run the wire and put the locking nut behind the switch. Have a look before drilling because if you go too far towards the parking switch a piece of plastic or something would obstruct the locking nut a bit.

Yes I was asking about the knee bolster. Thanks for the information.

TXguy · October 24, 2020

3 hours ago, BlackLS said:

Not today............... but installed new Zone Offroad control arms.

What lift are you running? I assume not but did the control arms make any differences you can feel?

BlackLS · October 24, 2020

18 hours ago, TXguy said:

What lift are you running? I assume not but did the control arms make any differences you can feel?

BDS Lift and and noticeable difference in the ride.

lapoolboy · October 24, 2020

Put exhaust tips on and washed it

romclean1 · October 24, 2020

1 hour ago, lapoolboy said:

Put exhaust tips on and washed it

Looking sharp! The wheels you picked are a excellent match to the truck, great choice.

romclean1 · October 24, 2020

On 10/20/2020 at 11:17 PM, Philipgonzales3 said:

installed the Amp Research manual override switch for the Power Steps. I think it came out pretty good. Called for a 3/4" drill bit and biggest I have is 1/2" so I made it work lol.

hey thanks for posting this, ordered up a switch and installed it today in the same spot. Totally worth the $40 to have some manual control and the switch looks like a pro installed it

lapoolboy · October 24, 2020

23 minutes ago, romclean1 said:

Looking sharp! The wheels you picked are a excellent match to the truck, great choice.

Thanks bud

Deviant_Opinion · October 24, 2020

Put exhaust tips on and washed it

Where did you get those tips. I hate the fake built in tips

Sent from my SM-N975U using Tapatalk

Philipgonzales3 · October 24, 2020

43 minutes ago, romclean1 said:

hey thanks for posting this, ordered up a switch and installed it today in the same spot. Totally worth the $40 to have some manual control and the switch looks like a pro installed it

Awesome! Yep, I feel the same way. Totally worth it.

TXguy · October 24, 2020

2 hours ago, BlackLS said:

BDS Lift and and noticeable difference in the ride.

Oh great. I didn’t think the control arms would make a big difference. I have the same ones setting here ready to install. I went with the zone lift though. Hopefully I’ll get everything on next weekend.