2017 Chevy Silverado spindle/spacer lift.

[CA1500AL]

I have a 2017 Chevy Silverado LT RWD with a 5” Maxtrac spindle lift and a 2” strut spacer to equal 7” of lift. I want to replace the 2” strut spacer with a 3”. I want to know if anyone else has done it? Or if anyone has some advice. 

[Nasty]

6 minutes ago, CA1500AL said:

I have a 2017 Chevy Silverado LT RWD with a 5” Maxtrac spindle lift and a 2” strut spacer to equal 7” of lift. I want to replace the 2” strut spacer with a 3”. I want to know if anyone else has done it? Or if anyone has some advice. 

To much unless you add an aftermarket upper control arm. Even then i wouldn't do that

[CA1500AL]

52 minutes ago, Nasty said:

To much unless you add an aftermarket upper control arm. Even then i wouldn't do that

What would you do? i bought the truck used and this is what was already on it. i just want something safe and reliable. its an everyday driver and i want to clear 35'' tires on the same wheel setup i have now, the rear is fine with a 4" block.

 

is there any other lift kits out there that can give me the same lift without having to add cross members?

[Nasty]

What would you do? i bought the truck used and this is what was already on it. i just want something safe and reliable. its an everyday driver and i want to clear 35'' tires on the same wheel setup i have now, the rear is fine with a 4" block.
 
is there any other lift kits out there that can give me the same lift without having to add cross members?

There is not to my knowledge

Sent from my SM-G955U using Tapatalk