Jump to content

Infotainment Screen Issue

clauerman
 Share

Recommended Posts

clauerman New Member

clauerman

Posted
Posted

My infotainment Screen is only working and half the screen and that's not even correct.  Any ideas what to do here? I've restarted everything a few times.

IMG_20200412_184052660.jpg

Mikedfw Enthusiast

Mikedfw

Posted
Posted

With one issue I had with mine (not the same issue), it fixed itself after I left it overnight, not sure why, but restarting it when the error happened did nothing. If it isn't fixed after a few hours or the next morning, probably need to take it to the dealer.

Sent from my SM-N960U using Tapatalk

JimCost2014 Senior Enthusiast

JimCost2014

Posted
Posted
33 minutes ago, clauerman said:

My infotainment Screen is only working and half the screen and that's not even correct.  Any ideas what to do here? I've restarted everything a few times.

IMG_20200412_184052660.jpg

Welcome to the site

 

Providing more info will help, year of truck, trim level, miles, how long has it done this, do you have factory nav, what IO? code is on your RPO sticker in your glovebox?

Vicarod Enthusiast

Vicarod

Posted
Posted (edited)

That's a 2019 and up bezel / infotainment system.

RPO code will be on B pillar down low.  Need a bar code app to read it.

Edited by Vicarod
  • 1 month later...
Bernard Byrd New Member

Bernard Byrd

Posted
Posted

My 2019 Silverado infotainment system sometimes has a blank screen when I first start my truck. Sometimes it will also act as if everything is ok but the touch screen will not respond and the manual buttons will not respond, so whatever station and volume was on the day before is what you are stuck with. sometimes I can turn the truck off and wait a few minutes and it will work. Then there are times that I stuck with either a blank screen or yesterdays station. I took it to the dealer and of course they could not find anything wrong.  Do anyone else have this problem and can it be fixed?  HELP!

Blank Radio.jpg

  • 3 months later...
MillerD Enthusiast

MillerD

Posted
Posted
On 4/12/2020 at 6:50 PM, clauerman said:

My infotainment Screen is only working and half the screen and that's not even correct.  Any ideas what to do here? I've restarted everything a few times.

IMG_20200412_184052660.jpg

 

MillerD Enthusiast

MillerD

Posted
Posted

I also am having problems with my infotainment/touch screen in my 2017 1500 Sierra Denali with 42,000 miles.  The radio randomly changes channels, switches from Nav/Radio/Home etc.  It also does not respond to my touch on the screen.  Additionally I am having problems with transmission clunking, retractable running boards, brakes, and chassis rust.  Other than that its a great truck!

eppieguy Senior Enthusiast

eppieguy

Posted
Posted
26 minutes ago, MillerD said:

I also am having problems with my infotainment/touch screen in my 2017 1500 Sierra Denali with 42,000 miles.  The radio randomly changes channels, switches from Nav/Radio/Home etc.  It also does not respond to my touch on the screen.  Additionally I am having problems with transmission clunking, retractable running boards, brakes, and chassis rust.  Other than that its a great truck!

You’ll probably be better off posting in the K2 section as this is for the 19-20 trucks. It’s a different infotainment system on the new trucks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Latest Articles

  • Posts

    • Chuck FB
      Fluid Change Questions

      By Chuck FB · Posted

      I know when I was looking around last year to see if someone handled Amsoil gear oil to buy at the retail level which of course means full price. I found an independent shop that works a lot on GM/Duramax pickups and they did not bring in the 75W-85 as they just stuck to the 75W-90 for the front and rear as a standard practice for the HD trucks which makes sense anyway for the higher hp/torque diesel and pulling heavy loads in four wheel drive. I haven't changed my diff oils yet but still plan on using the 75W-85 for the front diff as I highly doubt I will be beating on the truck and figured for my use type the bit thinner oil would be to my benefit for the winter for that slightly less drag. Very different weather here all winter vs northern Washington near the coast, that's for sure. 
    • Chuck FB
      Oil Consumption

      By Chuck FB · Posted

      Ok that confirms the extra quart theme they are still going with which must mean they have noted some initial use more so then some engines and probably the bigger factor in all of this probably isn't the engine so much as its the insane distance or OLM that lulls a lot of the driving public into driving their new vehicle off the lot and not even doing one short interval oil change because the manufacturer doesn't say different and if the dealer follows that logic as well. Selling the rarely needing to be serviced concept seems to go over well with the public that wants to get away with as little as possible for dollars spent on the vehicles maintenance and I bet there are 3.0 engines just like other vehicles out there that never have their oil checked by the owner which goes back to why they probably felt the need to add that extra quart to avoid a costly theme.    Speaking of cutting filters open, it was probably over two years ago now that a youtuber who buys vehicles to do longer term reviews and pulls a fifth wheel through the mountains of Colorado on summer trips and that becomes part of the testing. Anyway he had a GM HD with the 6.6 gas and a Ford 250 with the 7.3 gas at the same time and of no surprise the Ford had more power etc but somewhere along the way in the few thousand miles he put on the truck, he changed the oil and was seeing glitter and cut open the filter and yeah, things were not looking spectacular. The truck about that time or soon after seemed down on power compared to what it had been and then threw some engine code, I expect the cam/lifters were failing and so he brought the truck back to the dealer and made some deal to get out of it as he knew it would sit for months waiting on a new engine as they were so backlogged at the time. He kept the GM for some time after that using it exclusively until he sold it after buying his next vehicle to do a review on. Definitely the filter can tell a story when things are starting to go sideways, but it would be a sickening feeling to cut it open and be faced with an ugly mess like that and be running a magnet through the pleats and the oil on the dirty side of the filter and see all the fines sticking to the magnet.    The dealer may have some ideas based on experience as to where that coolant smell is coming from, I would imagine if they can't find it but its smelling they would put dye in it to they could give it a run cycle and use the black light to see where it pops up, if its a hose connection, water pump, rad or even a head gasket etc. 
    • riddler
      Torsion adjustment

      By riddler · Posted

      Good looking truck, suspensionmaxx looks like a solid option
    • riddler
      Torsion adjustment

      By riddler · Posted

      Thanks for the info, im considering a leveling kit or 4" lift kit.
    • davester
      frustrating P0446 code

      By davester · Posted

      charm.li (website) has the vehicle-specific diagnostic procedure for that code, you can use to find what the cause of it is.

  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...