Jump to content

Recommended Posts

Posted

Installed a gloss black vinyl emblem overlay, not too sure how I feel about it. I messed up on a couple spots and you can see the red. I may end up peeling them off and spray painting them.
3a414ccf893f669b0d9cde316d849ce7.jpg85ac6a22ab0357f11bb061ba37933623.jpg


Sent from my iPhone using Tapatalk

  • Like 1
Posted
22 hours ago, ChristopherDB said:

Been wanting to install footwell lights ever since I bought the truck last week. Couldn't wait any longer for the LED strips to arrive so I ran to the auto parts store and bought some just before they closed. Forgot the wire so I had to run to Home Depot as they are open late. Got home, forgot the t-tap to tap into the dome me lighting, so back to Home Depot just before they close at 10PM. My projects always require at least three trips to the hardware store. 3 hours later and I finally finished the fronts!

 

 

 

IMG_20180407_233827.jpg

That is slick... Where did you tap into the dome lights? Would love to do this myself this weekend!

Posted (edited)
19 minutes ago, Imcrazy said:

That is slick... Where did you tap into the dome lights? Would love to do this myself this weekend!

I tapped into the wire demonstrated in this video: 

 

I then shined a light from the driver side through the font of the console and from the passenger side I could see the light shining through and used a fish tape to pull the wire through to power the LED strip for the passenger feet.

These were the LED strips I picked up locally, which matched perfectly with the factory LED dome lighting. https://shop.advanceautoparts.com/p/alpena-ezlink-flexled-24-starter-flexible-led-light-strip-kit-white-77066/11579331-P?searchTerm=77066

Edited by ChristopherDB
  • Like 1
Posted

Plasti dipped the 3 chrome strips in my grill and the chrome bottom behind the license plate.8c646c05f7d7738f44d97b60a85da550.jpgf5ba9555ce13afe16b21281591838725.jpg

Sent from my SM-G950U using Tapatalk

  • Like 4
Posted

They look like the GMC All Terrain wheels, painted/powder coated black.

 

Posted
They look like the GMC All Terrain wheels, painted/powder coated black.
 
Yeah they're black GMC replicas.

Sent from my SM-G950U using Tapatalk

Posted

Dropped my truck off at the dealer again for coolant fogging up interior. Last week they replaced the radiator and thermostat for too many thermocycles but the issue was still there. I got the call today it will be $1,100 for the heater core. GM offered about $100 towards the repair. I'm disappointed to say the least. 

20180404_230809.jpg

Posted
On 2018-04-06 at 4:53 PM, Coxryan1 said:

RC level installed, midnight edition wheels and Cooper rubber!ff18ff123f3081b977d7290004eece83.jpgb41fe29d10c0af9eea28b88064d6b2a8.jpg1f3f76a7e89d4171a9f1972604a01e13.jpga930e6b0efed22d389db6d5892f4bb85.jpg

Sent from my Pixel 2 using Tapatalk
 

 

What brand running boards do you have on?

Posted
On 4/7/2018 at 8:53 PM, ChristopherDB said:

Been wanting to install footwell lights ever since I bought the truck last week. Couldn't wait any longer for the LED strips to arrive so I ran to the auto parts store and bought some just before they closed. Forgot the wire so I had to run to Home Depot as they are open late. Got home, forgot the t-tap to tap into the dome me lighting, so back to Home Depot just before they close at 10PM. My projects always require at least three trips to the hardware store. 3 hours later and I finally finished the fronts!

 

 

 

IMG_20180407_233827.jpg

Did mine in green. Matches the rain forest green truck

20170130_182027.jpg

  • Like 3
Posted
On 4/7/2018 at 10:53 PM, ChristopherDB said:

Been wanting to install footwell lights ever since I bought the truck last week. Couldn't wait any longer for the LED strips to arrive so I ran to the auto parts store and bought some just before they closed. Forgot the wire so I had to run to Home Depot as they are open late. Got home, forgot the t-tap to tap into the dome me lighting, so back to Home Depot just before they close at 10PM. My projects always require at least three trips to the hardware store. 3 hours later and I finally finished the fronts!

 

 

 

IMG_20180407_233827.jpg

Can you show a pic of where you mounted the led light strips under the dash on both sides?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Hi all,   I just bought a 2021 suburban RST with 88,000 miles on it and everything has been good but I’ve been noticing within the last month or so that there are small electrical things going on and I know what the AGM batteries and all the electric electrical in these big trucks you need to have a constant flow with good voltage   That being said, I bought a new battery thinking that that might have something to do with it but today I went to get in and start it and it said no key found when I had the key right in my pocket   It also proceeded to flash the lights inside and outside for over 30 minutes as I went to disconnect the battery as soon as I touch the negative terminal, I heard the relay reset and everything come back up. I got in the truck and started it no problem.   Anyone else have this happen to them? I’m starting to think it’s the KARR system that the dealer installed short circuit stuff.
    • I don't drive this truck on a regular basis since I have a new company truck with no out of pocket fuel or maintenance cost. Yesterday I got it out to run some errands and got the title message on my DCI. A quick Google search suggested to first clean the Map Sensor. I pulled it out and it was sooty so cleaned it up and reinstalled it. Issue not resolved. My OBDII is a couple years old so didn't see any codes. Today I took it to a friend at AutoZone to get him to check it with his reader. It had the following codes: P20C3 P02BB P221F Stating the most likely solution is to replace diesel emission fluid (DEF) tank assembly.   So, I guess a trip to the dealer is necessary. I read where there was a backorder on these tank assemblies several years ago so hope that has been resolved.
    • Are you using a weight distribution hitch system with your trailer as that alone can change the actual tire pressure requirements needed. It would prove interesting to see what the actual individual axle weights are on your truck when you are hooked up to the trailer. In fact when your hooked to the trailer, typically if anything unless it has a large capacity weight distribution system that is over cranked, often the weight on the front axle will be less when hooked up vs driving empty and certainly if one doesn't have a weight distribution hitch. Really the only times one may get up there with weight on the steer axle is if there was a snow plow mounted on the front or a motorcycle on a rack or with a very large jockey tank full of fuel at the front of the box that transfers a bit of its weight to the front axle.    And of course your tires carry more weight for a given tire pressure due to their size vs a stock sized tire so there is that to take into the equation as well. 
    • Great info here thank you. I just joined, we have a 2014 Silverado truck we bought about 4 years ago with less than 5,000 miles on it. It has approximately 24,000 on it now. It appears to have all the standard issues that people are talking about. Occasional charging problems especially using 110 volt, occasional blinking triangle where nothing will turn on when first starting the truck but it will reset itself if you wait 10 to 15 minutes. Noisy coupler between the flywheel and the generator. Our truck is speed limited to 74 mph, is there any way to change that? The latest issue we have been dealing with is when driving long distance on the highway at full speed the generator does not keep the batteries charged. The meter will go into the yellow/red border Zone for charge status and the yellow triangle will illuminate solid but the generator will not keep the battery charged, not sure why the controller doesn't tell the gas engine to increase RPM to increase generator output it usually stays well below 25 kilowatts even though the battery is discharging and I have to slow down the highway to 45 mph and eventually pull over and let the truck idle to charge the battery so I can continue driving at speed. Has anyone had this issue before or have any idea how to diagnosed it? When via Motors was around it they were very helpful at troubleshooting. This becomes much if the Terrain is hilly and you're towing a small trailer
    • I have the GMC accessory (REV) cover installed by dealer. Ordered with the truck.  They did a very good install job, can't find a single issue. Some water gets in around the tailgate but no where else.  You can see daylight around the tailgate but that's not the covers fault.  Installation is means everything. Guys at my dealer were seasoned pros, not inexperienced here today good tomorrow types, like many dealers employ for these jobs.   I don't mind paying for a professional job.    
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...