What have you done to your K2 today?

[15bronzeduramax]

Latest Mod.. Added OE Yukon/Escalade ambient floor lighting.. These lights stay on while driving and are the same light as the roof console center light..

I followed the install process here....

2015 Silverado OEM Footwell Lighting - YouTube

 

[Bigbuick]

Tried out some new Chemical Guys products today!!! I’m satisfied!!

 

[Grumpy Bear]

Waking Pepper from her winter slumber. Battery Tender off, fluids & pressures checked. It sunny out if but brisk and time for first drive of the year. Still allot of snow cover but the roads are salt free. It's suppose to get into the 60's over the next week. Yippie!! 

[Darthmalo]

16 hours ago, 15bronzeduramax said:

Latest Mod.. Added OE Yukon/Escalade ambient floor lighting.. These lights stay on while driving and are the same light as the roof console center light..

I followed the install process here....

2015 Silverado OEM Footwell Lighting - YouTube
 

 

Hello,  How difficult is to put these lights?  is plug and play with the harness from Harness Dr.?

[15bronzeduramax]

5 hours ago, Darthmalo said:

Hello,  How difficult is to put these lights?  is plug and play with the harness from Harness Dr.?

It really wasn't hard at all, I had it done in about 2 hours,. minus the prep time of getting the leads ready, that was a couple hours... I bought (4) OEM GM leads off of eBay. P/N 12085535, or you could get them from @pgamboa Harness Dr.. I rough measured from the mounting location to about the gas pedal area, cut some 18 gauge wire (red/black), and heat shrink butt connected them to the GM leads then wrapped each one up good in harness tape.. I mounted all the lights (there are factory mounts in the trucks, except for the passenger seat, it's not a power seat) , I then ran both back seat light wires under the seat rails and up along the inside edge of the console. I took both passenger and driver's side light leads and ran them up to the front of the console up by the console mounting bracket..

I cut back all the black leads and terminated them with a 10mm electrical connector and mounted the negative to a dash mounting bolt that had enough bolt threads to get the terminal, lock washer and a nut on.. I then cut all the positive leads back and connected them all together. I took a piece of wire long enough to reach from the BCM to under the console. Butt connected all 4 leads to the single lead and wrapped that up good with harness tape. I used a T-tap on the violet/green wire in the video and ran the line to that...

Edited March 5, 2021 by 15bronzeduramax
punctuation and revision

[CajunFries]

Finally got around to wrapping my intake tube with some DEI heat wrap. So far it’s about 10degrees cooler driving around in the city. Doesn’t get as much heat soak from the fan kicking on and off.
I can probably get even better IAT if I make a lid for my “box”.


Sent from my iPhone using Tapatalk

[HoosierZ]

Cleaned the skid plates and hit the front one with some aluminum polish. 

[dieselfan1]

Got most of my sponsors decals on today ,....







[emoji857][emoji857][emoji857][emoji857][emoji12][emoji12][emoji12][emoji12][emoji24][emoji24][emoji24]
I wish .
Some hate them I kind of like them.

Got it all cleaned up too.[emoji41]

Sent from my Pixel 3 using Tapatalk

[OffTheAir]

Wasn't today, haha, but just got an oil change for the truck, full synthetic. About 5.5k miles since my last one. Doing a tire rotation tomorrow since that is a little overdue. Very excited for the warm weather coming up, deep cleaning time! 

[Grumpy Bear]

Ten weeks in zero weather and she popped off like it was shutdown 30 seconds ago. Fueled her up and let her have her head for a few hours. Sweeeeeeeeeeeeet. 

[dieselfan1]

Ten weeks in zero weather and she popped off like it was shutdown 30 seconds ago. Fueled her up and let her have her head for a few hours. Sweeeeeeeeeeeeet. 

What did you expect?
It's a Chevy. [emoji16]


Sent from my Pixel 3 using Tapatalk

[slumpychuck]

Got most of my sponsors decals on today ,....







[emoji857][emoji857][emoji857][emoji857][emoji12][emoji12][emoji12][emoji12][emoji24][emoji24][emoji24]
I wish .
Some hate them I kind of like them.

Got it all cleaned up too.[emoji41]

Sent from my Pixel 3 using Tapatalk

What size tires and lift here?


Sent from my iPhone using Tapatalk

[dieselfan1]

What size tires and lift here?

 

 

Sent from my iPhone using Tapatalk

McGaughys 9"

37" Ridge Grapplers

Sent from my Pixel 3 using Tapatalk

 

 

 

[Raven Z71]

My truck suffered an awesome dent. ☹

[dieselfan1]

My truck suffered an awesome dent. [emoji852]

Well that sucks ass. Was that your neighbor?

Don't take me wrong and I hate to say it though, you left your truck in a vulnerable position. I never park in front of a driveway just for that exact reason.

I over think stuff like that[emoji3166].

Let's see a pic of the carnage.

 

 

Sent from my Pixel 3 using Tapatalk