Jump to content

"Service Airbag" light on- Help with codes


Recommended Posts

Posted

I have a 2008 GMC Sierra and the "Service Airbag" light is stuck on. I had a garage read the codes and it is continuously bringing up this code:

 

B0015V- Left front pretensioner deployment loop resistance above threshold.

 

Originally it did have this code as well, although this didn't come up again after the codes were reset:

 

B0084- Front end sensor 2

 

I removed the cover to the drivers front seat bellt tensioner and checked the electrical connection. It was wet and did have some electrolysis on it. I cleaned it up, dried it and used some dieletic grease on it. It didn't work. The B0015V code is still coming up. What else could it be?

Posted

You're on the right track but it may require more attention. Airbag systems are extremely sensitive. You may have to replace the pretensioner or further inspect the airbag harness.

Posted

Hello shawnmd,

 

I am sorry to hear that you are experiencing an issue with your vehicle. As a customer service representative, I'm not able to provide much in the way of do-it-yourself information, so I'm glad to see forum members are beginning to step in with feedback. If you have any lingering concerns please contact me via private message.

 

Jennifer T.

GM Customer Care

  • 3 weeks later...
Posted

I have the same problem with my 2008 GMC Sierra Ext Cab SLE All Terran with 80K miles. I have to take it into the dealer to have them look at it, i know its going to cost a fortune. I have to get my driver side passenger door lock replaced as well, it seem like the door locks going out in my model year is very common.

Posted

I just had this come up with my 08 silverado, I also have 80k. Let me know if anyone gets this figured out. Really not looking forward to taking it to the dealership.

Posted

Sorry, no I haven't yet, been away from home for the last month. I'm actually going to be bringing it in for the second level check for the consumption test. So I may have them run a scan. Not quite sure what all the possibilities are, hoping it's a DIY project though

  • 2 weeks later...
Posted

Just had my truck scanned, to get a B0084 code. Haven't had any luck finding any more info why it's throwing the code. Any help is appreciated

After subscribing to Alldata, I was able to pinpoint the problem to be a faulty Front Right(Passenger) Impact Sensor. 20 minute job to change, glad I spent $27 for the subscription.

Posted

After subscribing to Alldata, I was able to pinpoint the problem to be a faulty Front Right(Passenger) Impact Sensor. 20 minute job to change, glad I spent $27 for the subscription.

 

That's how it's done guys !!!!^^^^^^^^^^^^

 

Service information !!!!

 

Invest in it !!!

  • 2 months later...
Posted

Have had an intermittent air bag light on mine. Took it to dealer and they wanted big $$$ to replace the sensor so I told them I would get back to them. After reading in the forums about this I was able to crawl under the truck and check it out for myself. When checking the connections I found that I was able to push in the connector on the drivers side slightly, Also noticed that there was no corrosion or distortion of the sensor. Started the truck a few times, no more light!!! Keeping my fingers crossed. Thanks guys for your posts on this.

Archived

This topic is now archived and is closed to further replies.

  • Latest Articles

  • Posts

    • I have thought an EV might have some practical value in extending the life of the ICE members of ones fleet. Now....I'm convinced of it. I've been letting my better half access Raven (Mitsubishi Mirage) for her needs while Dizzy has been in the shop. Being the fuel freak I am and given the fact Raven is capable of over 60 mpg in clean air on a warm day I was taken back by the wife's ability to take a car that had used a half a tank of gas that to that point had returned a value of 57 mpg and return in with a decimating 51 mpg for that same tank in that same day in a 15 mile round trip of short hop errands and a stop in the drive through at Micky D's.  😱   Trust me on this. It would take the remainder of that tank driven on the highway to return that tank to just 54 mpg. This is not a Mitsubishi issue. This is an ICE issue that is magnified in vehicles capable of such high fuel economy values. On a percentage basis your 1500 does the same thing. Short hopping an ICE consumes a good deal more fuel and in doing so provides zero additional useable outputs. That entire volume of fuel is wasted in diluting the cylinder walls oil films, creating crankcase moisture and acid content and the resultant wear.    Enter the SLATE. All of that is avoided and the ICE's advantage in range and made useful at reduced wear for your ICE!   Kind'a cool. 
    • Back in the day people would buy cars based on performance. The charger posted does 0-60 in 3.3 seconds. And it’s fully loaded.  It has a decent warranty and will fit most anyone’s needs. Remember the original Hemi? 90 day warranty. 25K mini truck or that car? I’d go with the car. It wouldn’t fit my perimeter. If I could just talk my wife out of her Genesis. It would be perfect for her.
    • Let's pivot this back. Someone said they wanted pictures.   Even better, there's already video. Pre-prod prototypes are already on the road and they're letting the press drive them.   JerryRigEverything did a good review. I really enjoy his content and EV adventures, so I was thrilled when he had the chance to review a Slate:    
    • The Charger EV was stillborn. Wrong car at the wrong price for Dodge's intended audience. Now at a good price with fire-sale discounts, and still not selling, it's still very much the wrong car. Again, Dodge's intended audience. I believe a lot of Stellantis' EV blunders were all under Tavares' regime at Stellantis...the board convinced him to move on. Neat car, just wasn't received on the level that would sustain mass production.   Dodge is headed in a better direction for its core business. I didn't think there was anything left to get excited about re: the Durango after its 15 year run, but they're just now releasing a 392 version that should price out in the low 40's. Nicely done. I'm not sure I would touch anything Stellantis makes with a 10' pole these days, but the Durango is still mostly parts designed like 3 parent companies ago so maybe it's still OK?
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...