Jump to content

Recommended Posts

Posted

I know most people on here would see this as a blessing, but i am one of the few that actually likes the feature - i took in my RST over the weekend for its first oil change, and drove yesterday with the AC off for the first time since (live in PHX), i then noticed that the Auto Stop feature wasn't kicking in. DIdnt think much of it so this morning, another sub 95 degree morning i decided to roll with the windows down and no AC - and still the Auto Stop isn't working. Any ideas?

Posted

Yes, you can only temporarily shut it off from what I've read - and this gets reset every time the truck is shut off.

Posted

Looks like there are lots if reasons:

 

The climate control settings
require the engine to be running
to cool or heat the vehicle
interior.

The vehicle battery charge
is low.

The vehicle battery has recently
been disconnected.

Minimum vehicle speed has not
been reached since the last
Auto Stop.

The accelerator pedal is
pressed.

The engine or transmission is
not at the required operating
temperature.

The outside temperature is not
in the required operating range.

The vehicle is in any gear other
than D (Drive).

Tow/Haul Mode or other driver
modes have been selected.

The vehicle is on a steep hill or
grade.

The driver door has been
opened or the driver seat belt
has been unbuckled.

The hood has been opened.


The Auto Stop has reached the
maximum allowed time.

  • Like 1
Posted

Check to see if some bum helped themself to your new battery when it was in for the oil change.  It's been known to happen.  

  • 2 months later...
Posted

I got the same problem. I do like this feature but it stop working now.  I know it will disable when the outside temperature too low. But now Its about 35- 45f. So I wondering what is going on with my new Silverado 1500 2019 

Posted

I don't care much for it but it seems to be random. I noticed it doesn't do that a couple minutes after starting the car. Sometimes I don't drive it for weeks and notice it takes longer for the autostop to kick in. I am assuming it needs to engine to feed the battery up. It's just a guess, I don't know. I don't drive it much anymore, probably 3,000 miles a year. It is no longer used at the ranch.

  • 4 weeks later...
Posted
On 8/26/2019 at 10:53 AM, jessez24 said:

I know most people on here would see this as a blessing, but i am one of the few that actually likes the feature - i took in my RST over the weekend for its first oil change, and drove yesterday with the AC off for the first time since (live in PHX), i then noticed that the Auto Stop feature wasn't kicking in. DIdnt think much of it so this morning, another sub 95 degree morning i decided to roll with the windows down and no AC - and still the Auto Stop isn't working. Any ideas?

I have a new 2019 Sierra that the Auto Stop did not work after the first 500 miles. I have had it in the shop 4 separate times and the GM techs cannot figure it out.  Each time GM resets it and it works for 300 miles or less then stops working again. Now this is strange as we got 6” of snow and the first time I put the truck in 4x4 I noticed the Auto Stop started working after I shifted back to 2 wheel drive. Truck has 16,000 miles and I will let the dealer know that it is working now but hopefully it is not a problem in the future.

Posted (edited)

Same here after my first oil change along with the 2 recalls all done in one appointment, it stopped working for me. It’s hovering around -5C or so here but don’t now if that’s the threshold. 
 

Update:  So after a two days, Stop/Start is working again.  Even in around -12C feels like -20C according to local weather reports.  

Edited by SilveradoRST
Posted

This is not very scientific, but I've noticed this happening lately too. I'm in North Florida (Southern border of GA, a few hard freezes a year, some frost, etc) and since it's been cooler it hasn't seemed to auto stop. Again, not scientific, but that's what I've been noticing.

Posted

I only have around 150 miles so far but the autostop feature on this 2019 6.2 10spd is a lot more noticeable than in my 2009 Tahoe Hybrid with 217k miles on it. I will have to research how they are restarting the engine in these newer products but whatever it is, it is not nearly as smooth as the Hybrid Tahoe from 10 yrs ago.   

Posted
3 hours ago, Dnt said:

I only have around 150 miles so far but the autostop feature on this 2019 6.2 10spd is a lot more noticeable than in my 2009 Tahoe Hybrid with 217k miles on it. I will have to research how they are restarting the engine in these newer products but whatever it is, it is not nearly as smooth as the Hybrid Tahoe from 10 yrs ago.   

It uses the starter in a traditional manner.  Didn't the hybrid use the starter as a motor to move the vehicle and get it going?

Posted (edited)

The GM TwoMode Hybrids from a few years back utilize 2 electric motors inside the special 2ML70 transmission and use a  dampener in place of the torque converter, it does not have a "starter' in the conventional sense the electric motor inside the transmission spins the engine (aka ICE) through the dampener to start it. The transitions are smooth as silk, really some awesome technology. It was just too expensive for GM to manufacture I guess. 

I needed a 4x4 for work and something that I did not have to worry about getting scratched/dented and that was CHEAP to buy. At $6,600.00 this Tahoe fits the bill perfectly and is really a fun truck to drive. I have put 23k miles on it in a year and it has performed well for a "Beater Ride"  

I think you are correct on the new GM trucks they seem to be utilizing the regular starter which creates a noticeable shake. i may just turn the silly AutoStop thing off I don't think that I will be able to tolerate it. 

2009 Tahoe Hybrid.jpg

Edited by Dnt
added info
Posted

i live in upstate NY and yes it wont engage if your truck is still cold as hell and the heater is cranking, particularly if you're one of those guys who cranks his thermo to high. It's a thermostat people. Treat it like your house and set it at your desired temp (68-73) and leave it. It'll heat and cool as fast as it can and then calm down.

 

anyhow, It usually takes a good 5-10 minutes before it's happy and then will kick off at a stoplight. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Latest Articles

  • Posts

    • Sure, but they do have some affordable options like the Trax, Trailblazer, Envista, and Encore. Some of these have a cheaper base price than the Civic, though the fuel economy isn’t as high. The main problem is that people WANT the highest trim with all the goodies and finance for like 7 years. That’s how ppl “afford” the more expensive vehicles. 
    • Holy s**t - not much of a parts thrower you say? You BLASTED that thing with the parts cannon!  You'd have been probably $1,000 ahead if you had just brought it to a competent shop rather than shotgunning a bunch of parts it clearly didn't need.   Just FYI - oil additives are really, REALLY good at ONE thing ... and that's emptying your wallet. They're ALL useless gimmicks.   If that has the L94 or L99, then #7 is an AFM cylinder. I'd suspect a failed lifter in that case.   If you leaned on wiring, sensors, and/or connectors while changing the oil, you'll have to check all that to be sure pins didn't get pulled out, connectors broken, etc.. Old wire loom that was barely adequate when new is certainly brittle by year 19 - make sure wires aren't chaffed and shorting out somewhere where you might have leaned. or supported yourself on it.   If your a mechanic, why didn't you just find out what you were missing and troubleshoot from there??  TIMED spark, fuel PSI / injector pulse, air, compression.  Can't make ANY money going the parts cannon route.
    • LOL! Are you joking?? That wax SUCKS! 100% gimmick made to "look" good.    After just TWO winters I had severe surface rusting in patches over 90% of the frame. Only reason it looks great in the pics is because I SATURATED the frame every single fall with used motor oil for 14 of the 16 years I owned it. Otherwise it would've been sent to the crusher 8 years earlier with the speed it was rusting prior!    I sold that POS 3 years ago. Was a gigantic headache the second it rolled off the showroom floor. Brakes pulsated on the TEST DRIVE. Door trim fell off the 1st week! Interior squeaked and rattled, and the drivetrain clunked after 2k miles. 4x4 switch failed shortly after. Front end - ball joints, struts, hub bearings - all failed between 38k-50k. Engine started burning oil at 50k. Rear and and transmission failed before 100k. Nothing but problems, and frustration with the piss-poor engineering designed to make you give up. Well, it worked! Nothing on that truck was easy to remove ... except the wheels. They haven't figured out how to screw that up yet. Give 'em time ...   I won't make that mistake again. EVER.   Such fond memories ... https://postimg.cc/K1qf23tS  https://postimg.cc/gallery/X02z64J  https://postimg.cc/gallery/mHSRXZv  https://postimg.cc/gallery/D4mMRfL
    • Different monitors do their test only under conditions specific to that monitor.  you MIGHT find the drive cycle conditions for the monitor that isn't ready on this site: https://lemon-manuals.la/   If it's not there, then it should be on alldata.com for your truck, but it requires a paid subscription.   And you need to know which specific monitor isn't ready.
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...