Jump to content

Recommended Posts

Posted
Yeah You truck looks great Lapoolboy. Im sure it's tall. I test drove a LT trail boss before I bought my 2020 RST. I remember the bed was up to my neck. I"m happy with the 1.5 level in front and 1.25 in the rear. 1.5 shouldn't tax the front end components to much either.  It's just right. Still might get those Rought Country Leveling struts some day. Until then I'm good. 
IMG_4623.jpg.1faf07960561d852c6c533be62727659.jpg

Up to your neck? Are you 4’2?


Sent from my iPhone using Tapatalk
  • Haha 1
Posted

King 3.0 ibp coilover with 3.0 ibp rear. Ordered deaver 2” springs to get rid of the lift block. 

24B32AC1-6100-46C6-BCA8-A0BFA39BB630.jpeg

  • Like 4
Posted
7 minutes ago, Luckyfd said:

King 3.0 ibp coilover with 3.0 ibp rear. Ordered deaver 2” springs to get rid of the lift block. 

24B32AC1-6100-46C6-BCA8-A0BFA39BB630.jpeg

No comp adjusters?!

Posted
1 minute ago, TheTicketTX said:

No comp adjusters?!

Yes. They come on all 3.0. 2.5 you have an option to have/not have them. 

  • Like 1
Posted (edited)

2 inch Southern Truck Level (Lower strut)

20 inch Stock wheels

285 60 20 Nitto Ridge Grapplers (no rub)

Also took off Air Dam today(looks way better)

 

C59B7F50-565A-4741-9E3E-E2F7BDE775EA.jpeg

Edited by Jay Teez
  • Like 4
Posted
3 hours ago, Jay Teez said:

2 inch Southern Truck Level (Lower strut)

20 inch Stock wheels

285 60 20 Nitto Ridge Grapplers (no rub)

Also took off Air Dam today(looks way better)

 

C59B7F50-565A-4741-9E3E-E2F7BDE775EA.jpeg

That looks great! Those wheels and that color look good together. How does the ride comfort compare to stock after the new tires and level? Also how does the extra tire weight feel with the 5.3/8 speed? I want to do something very similar to my truck, but I’m afraid of losing some comfort/power...Thanks!!

Posted

@ausomecasey

As far as comfort and ride quality there is no change, I actually like it better because your sitting higher and can see more especially at intersections.There is a slight power loss with weight of the tires but the truck still gets up and goes with no issues. It’s minimal. I’m very happy with my setup as I prefer a more stock look.

Posted
On 2/10/2020 at 12:29 PM, TheTicketTX said:

No comp adjusters?!

 

On 2/10/2020 at 12:22 PM, Luckyfd said:

King 3.0 ibp coilover with 3.0 ibp rear. Ordered deaver 2” springs to get rid of the lift block. 

24B32AC1-6100-46C6-BCA8-A0BFA39BB630.jpeg

What wheel n tire did u choose..? The wheels look good, its hard to tell tho on the tires and the size.

Posted
9 minutes ago, Flatblack83 said:

 

What wheel n tire did u choose..? The wheels look good, its hard to tell tho on the tires and the size.

Addict Xd wheels BFG 35/12.5./18

Posted
On 2/9/2020 at 2:45 PM, rodycomero said:

We finally got some sun to wash her up and take a picture. 2" leveling kit with KO2's. I've run this setup on all my trucks. Love it.

20200208_121715.jpg

Nice ride. What’s the tire size? Block in the back?

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Forum Statistics

    250.5k
    Total Topics
    2.7m
    Total Posts
  • Member Statistics

    342,938
    Total Members
    8,960
    Most Online
    C. Hart
    Newest Member
    C. Hart
    Joined
  • Who's Online   3 Members, 0 Anonymous, 525 Guests (See full list)


  • Latest Articles

  • Posts

    • 287,500 Mile Service   8/13/2026   Reset Fuel Trims   Since the work done in the previous post there was a good improvement in response in all areas except right after a fill up where the LTFT would go -20%+ for about four miles while the STFT was near neutral. Before the work they both went very negative for a few miles after a fill up but act normal thereafter.    We did a systems check of the vapor recovery system for functionality and ability to hold a vacuum. That checked out fine. But this doesn't mean the charcoal canister is dead in the water. Testing that is next up. For now the reset of the fuel trims.    I intentionally shorted the fill exactly two gallons to eliminate any chance of filling the canister. On start up the trims were behaving normally until I got up and rolling where the LTFT went -10 / -11%% but the short was + 2 to 0%. Within a mile the the STFT offset the LTFT and by 2 miles they were neutral. HUGE improvement but still not hunky-dory.    I'll watch them for a few days. Perhaps another tank where I will fill completely to 'first click' and compare. Meanwhile on the hunt for a new canister and I'll toss another purge value at it for good measure. Pending the outcome of the canister test that is. Progress of any kind is welcome.    Fuel economy improvement with bringing hole #3 back to the living was a noticeable bump to the positive. Even on the few miles I drove after the refill I already see another bump up by the trims reset.     She's purring like a kitten with a warm bowl of milk.    BTW, adding 50 rpm to the idle took the majority of the negative timing out on cold start up and leaned the cold idle. No longer burbles in the cat. What a dumb way to heat a cat.      
    • Yeah, shame I can’t really get that filter easily anymore. Running a PureOne. Your fave!    TAN would be neat to see. Confirmation I ran it too long probably. 🤣
    • My son and I both bought new trucks in 2017. Both of us immediately put Truck Covers USA American Roll Covers on our trucks. My son still has his truck and it never sees the inside of a garage. We live in Alabama, so not much snow. My truck was my daily driver and was in the garage when I wasn't driving it or at work. No issues with either cover even after almost 9 years. About a year ago I sold my truck to my brother and bought a 2025 Silverado 2500. The second thing that I put on that truck was a new Truck Covers USA cover. They are very well made and have a very positive locking system. I looked at a Retrax and my concern was the way that the cover locked to the rail. BTW, the first thing I put on the new truck was step bars. Those new trucks are high!
    • The Allison 10 speed torque converter doesn't "lock up" like the previous transmissions. It has 4 operational modes; open, slip, transition from open to slip; transition from slip to open. I have an Edge CTS3 monitor and I monitor transmission torque converter slip. Step on the gas and you get a little slip. Take your foot off the gas and you get a little negative slip. I have not found a way to display the torque converter mode beyond that. My Edge CTS3 also displays something that our trucks should already display, the current gear. I also monitor throttle body position and engine load. If I see the engine load getting too high, I'll manually drop a gear.
    • Nice result. Your filter is working well  I'd have like to have seen the acid number for this sample. Curious type that I am. 
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...