Jump to content

Recommended Posts

Posted

I have a 2016 Sierra 1500 with the 5.3L engine, 111k miles.  About 6 months ago I changed the spark plugs & wires and one of the wires accidently got pulled out by the stupid long bolt in the steering shaft that run way to close to one of the spark plug wires.  The truck misfired but I was only a few miles from home. I limped it back, realized the problem, plugged the wire in and all seemed good.  Unfortunately, 10 miles later the check engine light came on again, this time just showing P0420 code (catalyst efficiency below threshold, Bank 1).  I changed all (4) of the O2 sensors, but the code came back after 10 miles.  I then bit the bullet and changed the drivers side cat with a aftermarket weld-on from rockauto, nope. I then paid a muffler shop to replace the passengers side cat (generic) and fix my sad welding on the drivers side.  The light stayed off for about 50 miles this time but as always came back on.  I then tried to put a spacer between the 2 rear O2 sensors to pull them out of the exhaust stream, light on after 10 miles.  I even tried plugging the old 2 rear o2 sensors in the wiring harness and just zip tying them to the frame so they were breathing fresh oxygen, but still the light!  My mechanic is out of ideas and suggesting taking it to the stealership and having them replace both cats again with the OEM setup for @$2000.  I have almost zero faith that will solve the problem and that it will just be more money that I don't have going into the trash, and the dealer will just shrug their shoulders.  Any other suggestions of things to look at/try before jumping off that cliff?  I am a backyard mechanic with just a basic OBD2 reader.  I do know that all (4) O2 sensors are putting out voltage, but really don't know how to interpret that data.

Posted

If you don't have any exhaust leaks and you're using good fuel it's most likely the cats. Aftermarket cats are a lot cheaper for a reason. I currently have my y-pipe sitting on the floor of my barn, just replaced it for a kooks off-road y-pipe. I'd be willing to part with it for a few hundred plus the cost of shipping.

Sent from my SM-G998U using Tapatalk

Posted

Beware of fake knockoff parts made in China.  You can chase yourself in circles trying to fix something with crap parts. 

 

Also, keep in mind that today's diagnostic systems are so damned sensitive/picky that even if you have a not-so-bad-part from brand other than GM or AC Delco, the GM system may still not like it.  

  • 1 year later...
Posted (edited)

Yes Mike I have the same code P0420 once in a while will also read P1153.  

when I first purchased the vehicle 2008 chevy with 5.3 would get a CE light about once every 2 or 3 months now it comes on every week or 2. I purchased a Blue reader still can't figure out what the data means or the  issues they don't seem to help me at all.  I replaced all plugs and wires about a year ago and had a shop install 4 new Denso O2 sensors.  No change.  Lately light is coming on more frequently.  Every time I come to a light I cringe waiting for the idle to change a bit then light to come on.  Only issue is a slight roughness to idle once in a while. I took to Midas they said Cats are good and nothing wrong with vehicle. I have no rotten egg smell and they did an intake injection cleaner for the tune of $ 450.00 (robbery which I could have probably done myself).  light came on about a week later.  these computer vehicles are the pits.

 

 

Edited by jim_55379

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Articles

  • Posts

    • Here's a starter kit:    CC Jensen, a Danish oil testing Concern gives us the following guidelines:   ISO 14/12/10 Very Clean Oil ISO 16/14/11 Clean Oil ISO 17/15/12 Lightly Contaminated ISO 19/17/14 New Oil ISO 22/20/17 Very Contaminated and not suitable for any service.   In addition CC Jensen gives a table showing how engine life is increased by cleaning up the oil. For example cleaning the oil from 19/17/14 to 13/11/8 will extend motor life by a factor of 6X.   But even cleaning it two “Life Extension Classes” will double motor life. So perhaps giving those classes would be useful:   21/19/16 20/18/15 19/17/14 18/16/13 17/15/12 16/14/11 15/13/10 14/12/9 13/11/8   *************************************   https://testoil.com/program-management/setting-iso-cleanliness-targets/   Third paragraph from the bottom will give a starting point.    Your next question should be, okay 10um at what Beta ratio and the answer is in the graph Beta 75.   Then the next question is what is your chosen filters profile? (Purolator PL series below) The red dot is Beta 75. This was the information I obtained from MANN a few years ago. So the best filters, Purolator One, AMSOIL EA, FRAM Ultra, Royal Purple, Bosch Premium should get a doubling engine life over filters like Purolator L, any service filter from any quick lube, WIX, NAPA, STP, Mobil 1, Purolator BOSS.    And as noted by CC Jensen a 2-5 micron @ Beta 200 bypass system has the capability of a six fold improvement. AMSOIL has such a system as does Donaldson.       Now having said all that testing is the touchstone. Test the oil NEW and test it with your chosen filter. Then test over milage. Do the work, get the result. But understand this in NOT absolute BECAUSE this is one factor in isolation.   Example:    A valve spring supplier can state that with cam X and a valve train of Y grams the valves will not float to 7K rpm. is that true if the builder choose a system 20 grams over limit? Common sense must be used and limits understood. 
    • This doesn't look like a GM truck. Not needed on a HD truck
    • It varies a ton around me. Some places are still at $5.00 or higher and others are way down into the $4's.   Offroad diesel was $4.02 at the one station I passed today.
    • So after reading the reveal from Chevrolet, I kept asking myself...why did the trim levels change?   Here are the official ones:   Work Truck (WT): The quintessential fleet truck, built with durable, easy-to-clean interiors for commercial or utilitarian use. Custom: A stylish, road-oriented trim that adds a more refined appearance, standard dual exhaust, and modern exterior styling. Custom Trail Boss: An entry-level off-roader featuring a 2-inch factory suspension lift and 34-inch mud-terrain tires on a budget. Silverado: Serving as the new base consumer truck (replacing the previous LT trim), it comes standard with the Z71 off-road package when equipped with 4WD. Trail Boss: Steps up the off-road hardware with the 2-inch lift, 34-inch tires, monotube shocks, an exclusive off-road hood, and more premium interior options. ZR2: The flagship off-roader. It boasts 35-inch mud-terrain tires, Multimatic DSSV dampers, front and rear electronic lockers, forged carbon-fiber interior accents, and an available hardcore Bison Edition (co-developed with AEV). High Country: The pinnacle of luxury. It replaces bright chrome with modern satin chrome, 22-inch wheels, premium leather, real wood interior trim, a panoramic sunroof, and an exclusive front-passenger touchscreen. As others have stated, why would you want a Silverado - 'Silverado' - wth?? LT needs to remain!!!   Also, there will no longer be a dedicated Z71 model.  All 4x4 trucks will have the Z71 package. Carplay is also something that cannot be removed.  Hopefully it will remain.     I am excited about the 5.7L V8 (350 C.I.D.)  Old school Chevy power.  My only concern is whatever version of AFM/DFM cylinder deactivation.  Too bad that isn't an option a buyer can choose to have or not.   I will definitely be stopping by my local dealership when these trucks start showing up.
    • I haven't seen diesel for less than $5.30 anywhere in my area
  • GM-Trucks.com Clubs

  • Popular Contributors

×
×
  • Create New...